- Grimspeed Lightweight Battery Mount
- Corsa closed box air intake
- Loudest catback for a stock 86
- What's this thing on header?
- Rocker arm ejection question.
- AT Radiator automatic transmission
- what can this noise be? transmission?
- Can I get some help with some technical measurements?
- Main bearing location size?
- Are South Bend Clutch and Exedy the same company?
- Request HKS EL Catted sound clips
- How does this part attach?
- Going Flex Fuel
- Spark plugs
- Question about first gear possible problem
- Aftermarket Exhaust Guide
- WRX Clutch Fork vs Stock?
- Got an FRS with Tomei headers, what do about melted plastic
- My FRS 2013 Automatic Is Making Sounds When I Brake
- Stupid negative battery terminal bolt
- P0700 Auto trans
- Yet Another Transmission Problem
- Very sloppy / limp gear stick
- In-Person vs Remote Dyno Tuning
- how does 400 whp feel?
- (Invidia N2 + Catless UEL) vs (Tanabe Concept G + Catless UEL) which has less drone?
- CLEiB Single Exit Catback
- Has anyone ever heard this sound on their ft86 (Strange Engine Noise *Video)
- Skid plate bolt sizes?
- Need Help Finding Used Transmission
- 2017+ vs pre 2017 OEM Catback differences
- Tensioner pulley wobble
- Invidia N2 + Tomei UEL Headers Decibels
- Small amount of yellow liquid in exhaust ?
- Question re: aftermarket LSD and final drive
- pipe between muffler and resonator looks strange
- Long term performance/reliability of FT-86 SpeedFactory UEL Header
- Carbon driveshaft and short shifters
- 3inch downpipe and all the way back
- ELI5: Why do I need to delete the cats to get rid of the dip?
- Gas pedal became less sensitive over time after purchasing brand new
- Clutch softer/lighter then normal
- Anyone owns the AVO Turboworld oil cooler kit?
- 17+ Intake Box (Not Manifold) vs. Early Models
- California Will Start Checking for ECU Tuning In Smog Checks
- Exhaust leak help
- E85 NA engine build
- Clutch buzz/noise after installing a new one?
- How can I mount this oil cooler?
- Lightened flywheel and pulleys
- Rev limiter not working
- How to check ECU for over-revs
- Replace Flywheel Bolts
- Resurface flywheel or buy new
- What catted header in 2021?
- Installing '14-16 engine in a '13
- Sard ITBs
- LTFT + STFT very negative Idling, Oil dilution with gas smell problem
- TRD Japan or US quick shifter
- Mishimoto Oil Cooler sandwich plate leaking oil
- Connector PCV Hose (11821AA660)
- Valve clearances on built block
- Dowel/locating pin. Camshaft sub assembly
- Any love for X-Force Varex?
- TOB COVER
- Grey sealant chunks in oil filter..engine failure imminent?
- Embarrassingly don't know where this ground goes
- Longest possible FD?
- MA Performance 3" SS Catback VS Invidia N1 Catback Exhaust
- Shifter Malfunction After Clutch Install
- Cracked Crank Nose Sprocket
- Staged short block or upgrading current block internals? (Old tale)
- New mods all E85 dependent?
- Heading off problems?
- Is there anything odd in my obd readings?
- Jumpy RPM while cruising
- How to improve engine sound?
- Direct injectors installation issues.
- Gen2 Transmission swap?
- Quite smelly exhaust after header install + OFT Stage 2+ tune
- 2013 FRS Engine Knock?
- UEL on Auto
- Stock oil press
- Rear diff swap from 4.10 to 4.30
- Porting the heads
- Blown Engine Question
- What to look for when buying a used engine
- Stage 2 no drone exhaust options?
- New cam grind?
- New cam grind?
- Frs transmission resistance in neutral
- High pressure fuel pump, pipe installation issues
- CVJ Boot Band Clamp Source?
- Verus Carbon Fiber Driveshaft - New revision
- What is Toyota's engine code for the new 2.4?
- Engine Knock, Vacuum Pump?
- P1170 and P0171 after front pipe install
- Retorqing the head bolts.
- Need cam/rocker info
- fuel injection cover/rail bolts
- Tomei UEL Header
- Driveshaft will not lineup with rear diff during clutch install
- Information on ATI harmonic balancer
- clutch pedal on floor.
- 4.88 final drive
- Catback Exhaust / UEL Header?
- Verus CF driveshafts.
- Any leads to IS300 diff
- Clutch Fork Squeak help
- Header Question
- Possible cure for fuel starvation
- Ej20x swap frs
- Catback vs Axleback for sound
- ISO Berk Front Pipe
- MT issues when stopped
- Heavy "Shuttering" When Starting in 1st Gear
- id1050x on the 86
- Oil Cooler with Fan - Experiences
- Replacement oil cooler line?
- Exhaust Hangers Slide (exhaust misaligned)
- Direct injector install question
- Scion FRS 2016: Smoke rises from the exhaust
- Timing Chain cover revisions / changes 2013-2020
- Say granny tranny 5x fast
- Top dead center?
- Check Engine P300, P302, P303
- Spark Plug Change from Under The Engine?
- Scion FRS 2013 engine vs newer engines differences
- Single Cylinder Misfire
- fuel line quick connect missing?
- 2013 frs stock intake install
- ACT SB-7 HDSS Clutch/Flywheel Help
- Manual swap
- best clutch for daily driver on JDL Turbo Kit
- IRP for a Daily?
- HKS mushroom filter damaging to the engine?
- 2022+ Exhaust compilation thread
- Exhaust with Bash bar
- Used UEL gruppe S header - welded
- Beehive valve springs
- Clutch pedal not coming up all the way
- REAR MIDPIPE/MUFFLER PIPE OUTTER DIAMETER
- Has anyone tried nitro gears ring and pinion?
- Full Tomei Exhaust System
- Ice Fabrication/off the line coil pack connectors - Upgrade to 2015+
- Torque damper
- Rust on the ground electrode of new spark plug, is it normal?
- Short block chipped and indented, still useable?
- Invidia HFC front pipe
- Shift Interlock Solenoid
- Can you share tunes?
- STi diff bushings and carbon driveshaft
- TRD vs STI Motor Mounts
- No grip no fun
- How long can I wait without getting a tune after installing UEL headers?
- 4-2-1 vs UEL Headers
- HKS hi-power Spec L with Tomei UEL header
- 2013 frs, attmepted repairs to fix gas leak, ended up worse than when i started
- Is this oil cooler kit too much for a NA?
- Exhausts with good flow velocity
- 3.0 inch vs 2.5 inch
- Invidia q300? r400? or MXP SP?
- Bad vibration after new clutch
- Invidia Dual Resonated Front Pipe
- Clutch question
- Head porting and flow numbers
- BRZ quick connect vs barb fuel lines
- Intermittant P0219a and P0119f
- Rasp Going Fully Catless?
- Exhaust Compatible with Gen 1???
- Code P0420 Catalyst System Efficiency Below Threshold (Bank 1)
- Weight
- Engine Harness swap
- JDL 4-2-1 headers with OEM FP+CB?
- Remark FT-86 + Resonator Exhaust Drone
- Slapping / bouncing feeling when driving slow or changing gears
- Short shifter
- Retune after going back to stock fatback?
- POP while installing crank bolt, now CEL and TCS!
- My FA20 NA Dyno Results and Analysis - Stock, 98 RON, and E85
- CELs and Reduce Power - 2015 FR-S JRSC
- Head castings and difference
- MXP / CSG Touring Exhaust Turns
- Cold Air Intake Suggestions ?
- HKS EL Header with Cat (33005-AT007) on a 2017+ BRZ?
- Diff mounts
- Aftermarket thermostats
- stock clutch alternatives?
- Tranny Question
- Exhaust Recommendation on JDL Turbo Setup
- Afr Bung Placement for Gauge
- Cd00a
- Engine Ticking and Blowby
- Best Header for Sound?
- Automatic transmission made by Toyota?
- Clean, Flow Test, Balance Direct Injectors
- Small Leak?
- Whiteline
- Boosted motor mounts
- Rust on sparkplug
- ACT clutch pressure vs South bend stg 3 vs Exedy
- Which should I do first?
- Header to engine block nuts stuck
- Squeaky Clutch
- Smoke
- Exhaust is too loud
- To everyone else who has rebuilt an engine
- Just added a second oil cooler...
- I opened bleed nipple with clutch not depressed
- how to disconnect the ignition coil? (pic)
- HKS Hi-Power Single Racing V2 vs Spec L V2 (Dual)
- extra crank when starting
- Sick of replacing RH drive shaft seals...
- 2013 Oil Temperature Sensor Connector
- Slowly losing coolant
- I managed 2.59 mpg, whats your worst fuel consumption figures?
- Cleaning direct injectors after E85 use
- Cd009 swap
- High pitched whine/squeal.
- That stupid oil filter dribble tray
- Exhaust
- Another Transmission Oil Thread
- Oil temp from obd2 port
- Impossible to get a smooth start.
- I know it's been asked but p0018
- Vacuum leak? 2013 Brz
- Rear mounted water "helper" radiator
- Building a FA20
- One large or Two small?
- Broken drive shaft
- Valve Adjustment interval
- Driveshaft support bushing
- Carbon build up
- Ceramic coating on header mating surface?
- Power level of GT86 CS-R3
- Perrin oil cooler problem
- IRP Short Shifter worth it?
- Invidia N1 Replacement Gasket/Bolts
- S1 sequential
- The sound of Gruppe-S catless UEL, HKS dual resonator FP, & Stock cat back
- Cleaning VVT camshaft sprocket assembly after spun bearing
- In search of cooling options for an auto trans
- Flat flange to Donut?
- Sound deadening in trunk
- VALVE ROCKER RETAINERS
- Diagnostic Question P000A and C1201
- Total valve lift
- Bad primary cat?
- Header to Over Pipe
- [For reference] Measured: STi Performance Muffler (Low Back Pressure)