- Most "Rumbly" Header?
- Loud Ripping Sound
- Sound Generator Delete and Perrin Inlet Tube, Opinions?
- Injen Air Intake Revision - FYI For All
- Best EL catless header?
- Increasing top speed?
- The stock clutch in a 2015
- Blown head gasket??
- T1R Exhaust, who owns one?
- Wrapping stainless header
- Best UEL catless header
- High horsepower NA
- JDL Shipping Snafu
- 3in. titanium fp or op?
- '15 MT won't shift into 2nd at speed. Please help!
- Works AB vs AB-M
- SuperTek Trans mount Questions. worth discomfort?
- Remove Engine - Any DIY's?
- Oil cooler hose length?
- Front pipe to mid pipe gasket?
- Quicksilver exhaust?
- New header gaskets when reinstalling?..
- Threads for Stock oil Pressure and Temp Senders
- Help me decide Perrin Resonated or Invidia Q300 Resonated
- MXP Exhaust hitting rear subframe?
- Corsa exhuast + header
- Deepest catback you've heard -- but with an uncatted uel header
- After Market Clutch Sticky??
- cattback 2,5" or original diameter exhaust?
- Exhaust Confusion
- Q300/perrin catback design
- JDL Catted Header
- Raceseng | AC Delete Product Release and Introductory Offer
- Invidia N1 air flow not even
- Cat Back Exhaust
- Spec-D Catback Exhaust
- Guide - Passing IM240 Emissions and engineering certirifcation
- Putting My Exhaust On
- berk setup what do you think?
- Single Piece Driveshafts and issues with Short Shifters
- swaintech ceramic coated header
- Will the check engine light lit up if i install an intake system?
- TPS only 80% at WOT?
- Axle diagnosis
- Sizing compatibility?
- PLM Header Review
- Dented fuel injector?
- Deep sounding cat-back to suit catless UEL headers
- Works Axle Back Muffler Review (Works ABM)
- Public announcement regarding HKS exhaust systems
- Vendors/Members, Anyone have coil packs in stock?
- Borla front pipe
- Exhaust and headers opinion
- DTS Ark Performance x Berk Test Pipe
- Fujitsubo Authorize R exhaust - possibly the quietest catback available.
- frontpipe and emissions control
- What's the most you can get out of the engine
- Planning to buy Headers in June
- thinking invade N1
- thinking invidia N1
- Variable intake to lift torque dip
- Combination Oil Cooler
- Berk catted front pipe
- Problem with TRD quickshifter gettingloose
- Racer X Fabrication, coolant overflow tank
- 2017 = more power
- PLM EL HEADER BRZ
- Oil galley temp reading low
- Part number help
- AT acting up after long drives
- Is there a perfect header back exhaust?
- Driver injector connectors
- Requesting OEM Clutch Line Specifications
- Help help :-)
- ACE new product develop question
- P/N for Front Pipe Hanger Bolt
- Header & Exhaust combo for max power?
- ACE Header Independent Testing Results and Review - 199.6WHP on CA 91 Octane
- headers rasp
- R-magic Intake pipe
- Automatic Transmission: Loud Clank
- Exhaust Gasket: OEM or Aftermarket?
- OS Giken LSD + 4.8 FD. Do they fit together?
- MAPerformance FR-S/BRZ Oil Cooler Track Review
- BRZ/FRS AZ6 Manual Trans Upgraded Gearset
- Yet another Borla install
- What's up with this exhaust??
- Gaskets for used TRD exhaust
- Aftermarket Air Intake with Sound Generator Attachment?
- EURO STANDARDS emission testing with catless header
- Mechanical Sound Coming from rear
- Part numbers for fuel lines?
- Nameless axle back
- Greddy oil cooler to cold
- OFH wait time
- PLM Header Review
- Final Drive gears??
- Oil Cooler Set Up – DIY?
- Anyone had luck installing Perrin Crank Pulley on AT
- Oil pressure and Oil Temp sensor - where did you mount them and how
- CNT header unequal length
- Full Catless + 1 Resonator Exhaust! (Sound Clip + Flyby)
- JDL Catted UEL header VS ft86speedfactory catted UEL
- Varex Exhaust - Loud to Quiet Anytime You Want!
- Is there a header providing performance gain and stay cool like OEM ?
- Drop in filters.
- Can i put 13-14 axle back on 15 brz?
- Foglight Oil Cooler - Washer Bottle Options?
- stiffer clutch= broken Clutch fork
- TRD exhaust vs Perrin 2.5" resonated
- Oil cooler horizontal/vertical matter?
- Stock header and cat back plus catless front pipe
- A/F Wideband O2 Sensor Bung Location
- perrin big maj question
- Different exhaust affecting MPG's?
- Cosworth Stage 2.0 & Strut tower brace
- Exhaust assistance needed.
- Love Invidia n1, any way to reduce volume?
- Borla Set up Help!
- Frontpipe and Overpipe Match for Perrin 2.5"
- skunk 2 intake owners, oil cooler fitment question.
- CAI - Perrin or Mishimoto
- What header are you running/ supercharged fa20's only
- What is this on my overpipe?
- B&M Oil Cooler?
- F20C performance out of the FA20
- Exhaust Alignment
- Exhaust leak?
- no flange for donut gasket on J2 front pipe
- Perrin BRZ / FR-S Lightweight Accessory Pulley Kit Read more: http://www.ft86speedfa
- Possible clutch wear?
- transmission dipstick location
- Oil pressure sender thread size
- UNICHIP AND FLUX 2
- Possible solution for mating 2.5" to 3" exhaust parts?
- Greddy Axel Back or Catback?
- Fluidampr Internally Balanced Damper
- What does this part of the engine do?
- TITANIUM MIDPIPE???
- New TRD intake
- stroker kits on this engine are a waste (save the Toda thread)
- Jalopnik gives the FA20 some respect
- DIY X REVIEW: CNT UEL HEADER INSTALL
- Heat reflecting oil pan idea
- Nut size needed for overpipe to exhaust manifold
- Tranny Rattle ???
- Mishimoto’s BRZ/FR-S Plug-N-Play Fan Shroud R&D!
- ASM Autobacs / TODA throttle body
- Engine idle jumping
- Look what arrived today... No more 4th gear issues!
- Really need help with this... About Exhausts
- Exhaust manifold/headers
- Will the exhaust fit in the trunk
- 3" JDL overpipe for Nameless header?
- Has anyone found a solution to Kartboy shifter rattles and noises?
- Apexi Intake D Plus
- GReddy Exhaust - EVO3 vs EVO GT?
- The dealer replaced my transmission and claims the driveshaft is worn out
- TRD Quick Shift Kit
- New Sleeves for the FA20
- Catless header exhaust smell?
- tomei type 60s dd / streetability / tracky tracky / my experience / loud
- Single exit options (seeking opinions)
- Coolant temp sensor adaptor/Rad hose inner diameter
- Header on N/A question
- Borla v2 UEL collector
- How to install silencers on exhaust?
- TRD Quickshifter Problems
- Engine Braking - Questions
- Stock Clutch
- Internals Upgrade Question
- anyone measured how loud in decibels the invidia N1 is
- HKS resonated Front Pipe Question
- Clutch for 350-400WHP?
- Any opinions on Crawford powerblocks
- drop in filter, the right way to install it?
- Grimmspeed Intake + JR Oil Cooler Fitment
- TRD Lightweight Flywheel & Racing Clutch
- HELP:CEL and p0171 code
- new intake shudder at 3300-4000 rmp
- TRD exhaust owners - Warning! - READ!
- Oil temp sensor install help
- Baseline Dyno Results
- Nameless Axleback Drone Question
- IP Coil Packs
- Invidia N1 exhaust question
- Newly installed problems
- Anyone with a built motor whats you catch can setup?
- 2015 scion frs rough shifts in automatic transmission
- axle-back short muffler?
- Where to buy replacement relays?
- Opinions on Magnaflow vs. Perrin 2.5" resonated exhaust?
- J2 exhaust sold out?
- ABS/TCS and TPMS lights coming on.
- Tomei exhaust spring clamps
- Blown head right side
- Switched manual transmission fluid. 6-5 grind gone but hard to find 5-4 now.
- Exhuast confusion
- Opinions on the Nameless Performance Headerback/Cat Back Exhaust
- Went back to stock, different AFR?
- Do I have a leak? (with video)
- Catless Frontpipe fitment for GT86 A/T
- Open flash header and catless front pipe and unresonated exhaust review
- Automatic transmission problem
- Trans insert and block whine reduction
- Which Intake for the FR-S?
- Brz muffler delete
- Torque required for oil cooler sandwich plate and spacer??
- Header and full exhaust dilemma
- is this it for N/A?
- Custom Muffler Delete vs Berk Dual Tip Muffler Delete
- FIXED-CX Racing sandwich plate literally pouring out oil
- Greddy VS. HKS intake duct
- Bouncing revs
- Question regarding even gears on BRZ
- Car running poorly after check engine light cleared
- Quiet Headers?
- Invidia N1 + Nameless FP/OP w/Helmholtz?
- Strange Smells After Header Install
- Exhaust Question
- Zeta Performance Exhaust
- Piper Camshafts
- Trans play after header/overpipe install?
- Tomei Headers with ???
- How hard to make a bolt on axle back track pipe?
- Offical Gruppe-S UEL Header Install & Review Thread
- Installing new axles (drive shafts)
- will an Imprezza oil cap fit the BRZ?
- Need some advice choosing a Cat Back
- Acceleration Rattle
- Greddy Evo GT Catback
- Lightweight flywheel, now struggles to start and revs hunting
- Invidia N1 catback or Invidia Q300 catback??
- Perrin 3" resonated Catback
- Oil cooler, lenght of your lines?
- Is it possible to add shift paddles to the GT?
- NA Injector Upgrade?
- Top Speed Headers
- Quietest Headers with the US TRD catback?
- Annoyed by ads in the tech sections?
- direct injector injection/rail pressure?
- Poor Overpipe Clearance
- What are these things?
- What mod is worth it?
- AT oil cooling line, which is in and which is out?
- Release Series Exhaust
- Stock exhaust gaskets/Perrin 3" gaskets
- Typical Mustang Dyno Numbers?
- What is this
- Anyone know anything about Injen Headers?