- Engine rebuild
- E85 Optimal Exhaust Setup
- What HP Can Stock Pistons Handle???
- HKS Legamax Premium vs Legamax Sports
- FT86SF cat back help
- About milltek tail
- ACE Headers Price Rise
- Clutch went out during 60k service. Really?
- Honest Mechanic in Los Angels
- Is this normal for Skunk2 Alpha headers?
- Need some opinions
- Q: Mating Tomei Type 80 to Stock FP
- Varex Exhaust Availibility?
- 2018 Diff swap
- Driveline vibration at low RPM after clutch swap
- Diff raiser bushes
- Best replacement TOB
- Fr
- Getting valve work (recall) done. Should I do anything to bottom end
- Gaskets for installing a used R400 exhaust in 2014 Brz
- Noise on deceleration and taking off in 1st
- OBD2 scanner for monitoring oil pressure?
- Car getting stuck in gear / not going into gear
- Engine rattle on acceleration
- Cheaper upgraded motor mount options??
- 9000th oil temperature thread
- Differential/R&P Service - Looking for a shop - East/Midwest
- Boost vs N/A - questions
- Does Compression Ratio Affect Engine Note
- Service Interval for Aftermarket ATF?
- will not go into gear!
- Difference in TRD Exhaust Parts
- Lightweight flywheel and lightweight pulleys: bad?
- Questions About Built Blocks/Supercharging
- Removing a Full Blown FBM Oil Pan off BRZ motor
- Header question
- TRD 86 Kouki Rear Bumper Exhaust Tip
- Major leakage at Catback-->Frontpipe.
- Problem with 1st gear and 2nd gear!?!?
- Catback install - Invidia R400
- Is my engine knocking?
- Engine Code P0451 problems
- 2019 Engine into 2013 Chassis - Parts Change List
- EL Headers w/ Axle Back
- Is quickly shifting automatic car in manual mode is bad?
- Rattling when decelerating
- Removed Snorkel
- Rebuild with OEM short block
- Rubber Cover Fell Into Transmission Bell Housing
- FA20 NA - how easy to wake up the engine and add “character”?
- Bank 2 Valvetrain Noise
- No turning back now.
- Thoughts on ACT HD Clutch
- Adjusting slave cylinder to smoothen 1st-2nd and 3rd-2nd shifts
- JDL vs Tomei vs Gruppe S UEL Catless Headers
- Stock overpipe diameter
- Skunk2 EL header & UPGR8 filter re-flash Stg2 result
- Fitment of FDs on AT
- Coolant in cylinders
- Clutch pedal making weird noises
- Problems on start Built Engine
- Mishimoto cold air intake
- Advice for quieter setup
- ?Any difference between Subaru and Toyota atf fluids?
- Is this a fake TRD Exhaust?
- Need help finding new exhaust due to noise complaints
- Tomei 80R on 2017+ Toyota 86 (Kouki)
- transmission rattle
- 2017 TOYOTA 86 WON'T START
- Motul 300 LS
- Worth it to swap to 2017+ intake airbox?
- Soft clutch?
- Soft clutch?
- Cold cold(under 30dg) start sounds super weird
- Titanium wrap for Tomei EL Header
- Exhaust Drone
- invidia N2 setup recommendations?
- exhaust advice
- HKS single exit cat back exhaust drone!!!
- Toyota 86 Competition GR Parts - 4th gear + transmission parts
- Noise help!!!
- Engine mounts
- N1 Too Loud - Drop Front Pipe or Go Borla
- Nameless Axle back with header, Drone?
- MXP Comp Rs vs. Nameless axleback
- MXP Comp Rs vs. Nameless axleback
- How to safely lift engine using hydraulic jack?
- Oil Cooler Lines Constantly Seeping.
- ACE A350 header Bolts/nuts torque specs?
- EL or UEL Header?
- Discovery on STi JDM axleback and perhaps others
- Skunk2 CAI
- Worth trying to rebuild?
- New Clutch Shaking Going Into 1st?!?
- Brief Knocking While Reving From a Stop
- P0420 Permanent
- Lighter headers without added noise?
- Heat shield above muffler question
- Asking for technical headers informations
- invidia n1 or greddy rs 3 inch
- Can I leave this disconnected? How it works?
- A little direction required
- STFT/LTFT
- Is 19 row Oil Cooler too much for NA?
- Turbo Built FA20 Clearances
- Throttle body spacer dyno test?
- Used engine questions
- Humming Sound Similar to Wheel Bearing, but Possibly Not
- Exhaust
- identifying stock header?
- Which header / tune ? Can't decide
- Oil Galley Plug Adapters and Temp Sensor Fitment
- E85 Conversion
- Center pipe diameter
- Work oil regulator/cooler kit worth it?
- Percentage of port injection and carbon build up
- NEW: SBD 2.5" Overpipe / Front Pipe Combo for the 2013+ FRS/BRZ/86!
- Opinions Please: Blown Engine, Aluminum in Oil
- 2016 FRS Midpipe Flange Help
- Newbie needs tubro exhaust help!
- How GOOD are IAG short blocks?
- To exhaust wrap or not
- Automatic Transmission Shifting
- ACE Headers - Wait Times Ordering from CSG?
- Starting issues after clutch install.
- How much TOB travel req'd to disengage OE clutch?
- Fuse box screws
- How to fix exhaust leak
- HKS intake duct V1
- Catch Can Question
- E85 Last min advise?
- IS 250 y32 3.73 LSD for FI application
- Proper engine skid/bash plate
- Perrin 3" Resonated - Going Turbo
- ACDelco Platinum spark plugs, will they fit?
- Best manifolds (headers) to OFT - OpenFlashTablet
- Advice Needed: Best Radiator Fan + Shroud Combo
- Can you fail emissions with only one cat?
- Delicious tune OFT flex fuel kit
- Oil temps
- Silicone intake hose suggestions
- JDL 4-2-1 OFT tune
- Transmission whine
- FRS - Flat tow - transmission oiling - manual
- 2015 BRZ - Car running rich advice
- Missing skid plates
- Can anyone tell me what catback I have?
- Rebuilding Head from 2013
- FD 4.88 Problem
- Exhaust issues
- Engine mounts, Transmission bushing/ support mount
- OEM Exhaust Manifold - type of metal?
- Exhaust upgrade
- New Intake Install and Tune
- 2013 motor into 2016 FRS?
- Noise at idle
- STI Exhaust Part Number
- Is there a verdict on if replacing the OEM overpipe is worth it?
- Single vs. dual resonated front pipe
- e85 questions
- Pinion preload breakaway vs rolling torque difference
- Peened pistons
- Help with engine starting issue
- Need Help with Exhausts
- Upgrading clutch, anything else?
- PCV Valve Question
- P2757 Transmission Issue
- White smoke, gas smell, and water out exhaust pipe
- seeking advice on upcoming purchase
- Oil pan baffle plate
- FT86SF Catted Header and engine temps
- Nameless overpipe
- Exhaust. My biggest failure.
- 2nd to 3rd gear weird over-rev jerk when shifting
- are these shift level retainer bushings?
- Transmission Position Sensor Location
- Whos got the most HP??
- Serpentine Belt
- Will the FA20DIT pickup tube fit in an FRS
- Need help selecting transmission
- Acceleration sensor
- Diff build
- Questions regarding CAI
- built block options
- Resonator question
- BRZ Delicious Tuning HELP needed!!!
- Variable Exhaust Idea: Is it Plausible?
- Here's My Data Log(s)
- p0365, p0366, p0340, p0341
- Estimating exhaust volume (dB)
- JDL fan shroud vs Mishimoto fan shroud
- Time for exhaust...What all do I need?
- Remark Boso Edition Axleback sound clips
- Full list of what I need for clutch/TOB replacement install?
- Belt Walking
- Clutch suggestion
- Rebuild motor or built short block?
- AOS/Catch Can Needed for Supercharger Support Mod?
- JDL Front Pipe and OP Combo, anyone using?
- killerb oil pickup
- Exhaust / header ceramic coating smell??
- Add HP/torque 2013 FRS
- Possible exhaust leak after headers? Attached data log
- Oil Leak / PCV Puzzle
- Corse cat back, a bit loud.
- built motor with 12.5:1 compression?
- best O2 spacer for ACE 350 header?
- 2019 Short Block for A 13 Rebuild
- New short block help, understanding service manual
- Downstream O2 sensor replacement
- Good shop near RI/Boston/Eastern CT to install header?
- Looking for some advice re: fuel system upgrades
- DIY-ability for oil coolers and labor cost for installation
- Did OEM coolant part number change for 2018+BRZes?
- Possibly noob question from a not so noob manual driver
- Header to Overpipe Gasket?
- Plenum manifold
- Upgrading headers from 1320 to tomei uel difference? Is it worth it?
- Electric water pump
- Options for displaying Transmission temps in the car?
- Engine Oil Temp OBD2 PID for 2017+ Toyota 86
- Engine knocking around 1.8 revs
- Jackson Racing Supercharger engine build: Stay at 12.5:1 comp?
- Fujitsubo Authorize S vs STi Sports axlebacks
- Tips for a Newbie?
- Cylinder Head Differences 2013-14 vs 2017+
- Torsional Vibration Damper - FA20
- Tomei Expreme Ti Type-60s
- Exhaust Hissing when in lowering rpms
- Long cranks and engine struggling to start. Please help!
- Finding rocker retainer clips suitable for FA20
- Greddy Evo GT exhaust review
- 2017 86 Header Compatible with 2013 FRS?
- Used UEL Header Hardware
- Which Oil Sensor Is Better To Put Into The Block
- Newly Released Remark R1-Spec Titanium Exhaust
- JDL Header Question
- Issues with shifting 3-2?
- Oil Cooler block off foam
- JBA Exhaust?
- Greddy evo 3 exhaust modification
- eBay Oil Cooler
- Is it necessary to go for ‘name’ brands on overpipe/front pipe?
- Questions about after market unequal length headers
- Clutch fork grease
- engine optimization and oil pan
- Engine light for “replace abs module” but is functioning fine.
- Sound with decat headers + the rest OEM?
- Rod Bearings/Main Bearings
- Ticking noise coming from bottom of the block...