- Oil Pan Fail
- Clutch or transmission problem?
- Cam/Timing Sprocket Replacement?
- Catted front pipe and mid pipe recomenations
- Suitable flywheel holding tool?
- 2015 BRZ engine valve tick?
- Stiff/pulling shifter?
- Gen 2 OEM header on Gen 1
- su00300093 vs 10103ac260
- Manual gearbox breather
- GR86 clutch vs FRS/86 clutch specs and fitment
- Throttle body problems
- Final Drive and Kaaz 1.5 Way Diff Swap
- Civic Exhaust on Frs?
- Root Cause Found?... short shifter RATTLE
- Perceived power decrease as engine/oil temp raises
- Help me choosing between these two manifolds
- Second lambda extender
- Rear Main Seal - oil separator
- P0420 (Catalyst System Efficiency Below Threshold (Bank 1))
- ACT Clutch Lockout SOLVED
- Highervalve lift with shims
- Engine ticking shortly after new engine
- AFR at 8.5 on WOT?
- Header Question
- Cam plate leak challenge
- Camshaft question
- Header nuts coming loose
- Car dies after I give it gas once warm
- Opting for the N1 system but want to know about headers and tune
- Coolant Temp Sensor Nut Size
- FRS Shifter issue
- Think head gasket is blown
- Clutch rating
- What's this part
- P0037 Info - Post-cat O2 Sensor Heater Circuit
- Drive shaft support
- Brz doesn't like to idle
- Clutch master cylinder
- Killer B exhaust tip extensions
- Swapping pre - facelift auto motor into a manual 2017 86
- Help fixing delicious d-box flex-fuel kit
- built motor woes. leaky exhaust valve
- Apexi Super Catalyzer with manifold and catbacks
- Bad cold start 10:1 91
- Mishimoto Radiator Ship Time
- anyone else have worn oem pulley's on the inside edge?
- C1528
- Is ACE header discontinued? Anyone interested in making a replica?
- Gerald Just Projects Flex Fuel Kit
- Stock tune for build low comp motor safe?
- Belt tensioner pulley noise?
- FRS Clutch job questions.
- Hydraulic release bearing
- Powertrain options for track only
- IAG FA20 Block Reccomendations
- Advice on installing JDL 4 2 1
- FRS Rocker arm issues? Or rod knock?
- Non-Torsen LSD
- Help me with catback please!
- Lead in Oil
- Gen 2 Transmission in a Gen 1 Car
- [Available Now] AWE Exhaust Suite for BRZ & 86
- Stumped: Oil pressure switch port
- Broke down
- Why are all the headers sold out?
- Exhaust decisions help
- Why are all the headers sold out?
- OS Giken host
- [Need advice] Problems after new short block install and shop doesn't know what to do
- Immobilizer question, bcm
- Invidia Q300 tips falling off after 3 weeks, what do?
- FA24 clutch/flywheel
- Code P0133
- Header install question ('17 ftspeed catted header)
- Auto Trans slipping in Sport mode 1-2 and 2-3?
- HKS Legamax Premium or Sports catback?
- Need help with exhaust rattle
- Dyno graphs: My 2022 GR86 (stock) vs my 2017 BRZ (stock & tuned)
- Is there a good catted header?
- Exhaust manifold gaskets - which way do they go?
- Consensus on Delicious Tuning Coil Packs?
- Single side exhaust
- Perrin 2.5” cat back issues
- My First Run Impressions and Testing Results with (knockoff) Billet Power Blocks
- MY2013 BRZ with mixed injectors
- Input from gmeter possible?
- Cast Aluminum Intake
- Comp clutch tool
- brz track day high oil temperature question
- Very aggressive engine braking all of a sudden
- JDL UEL Header with catalytic converter code
- Help identifying piece I found underneath my intake manifold.
- P0141 Intermittent code on a 2018 BRZ, fully stock
- Valve replacement
- Grinding sound when decelerating
- Port Injector cleaning results
- P2119 Troubleshooting
- Delicious Tuning OFT Flex Fuel Kit
- Looking for hardware for used exhaust (Greddy)
- Looking for a lightweight flywheel that doesn’t rattle/chatter
- Splitter Connector to run FF and O2 sensor
- Boost vs N/A - questions
- Increasing positive LTFT on idle
- HELP: Coolant temps hit the notch below max
- Dss axle boots riped
- To Rebuild or not, but with no Experience with Engine Rebuilds
- best heads to use
- Increasing exhaust sound besides catback
- AWE Touring exhaust - 2 month review
- What exhaust set up for Supecharged BRZ
- Subaru BRZ high pitched squeal/whine/buzz
- Hydraulic clutch regrets
- HELP: Pulley violently shaking with chemical smell
- 2013 BRZ Ignition Coil Set Up
- How bad did I screw up my bell housing?
- Trans build
- PLM UEL Header Experience
- FA20 vs FA20DIT
- Tomei "slip joint bracket" weld broken
- High power short blocks
- ZD8 2022 BRZ Tanabe (Revel) Medallion S catback
- Different intake hose shape
- Varex or Butterfly Exhaust Muffler
- 2015 FA20 engine in 2013 car
- 2013 BRZ trouble shifting into 6th
- Can’t get the transmission off!
- '14 FRS cranks but won't turn over
- Reputable engine builders in SoCal?
- Difference between direct injectors?
- 6speed compatibility between model years/brands
- How do i put stock headers (with the stud bolts) back in?
- Priming Oil System
- EXEDY HYPER MULTI TWIN CLUTCH & FLYWHEEL FOR SUBARU BRZ
- Installing Nameless catback and JDL Frontpipe help (Spring Bolts wont budge)
- Engine Overheating
- HELP! Coolant Leak in driver side cabin.
- Code P0171 on STOCK car
- Woodruff Key Condition
- Are my exhaust tips too long?
- XTreme clutches - sprung vs cushioned?
- Fuel Injector Module Swap
- Wont go into gear
- Is there a oil filter design change from Gen1 to Gen2?
- 5Zigen Ashiku axleback exhaust for ZN8/ZD8 GR86/BRZ 22+ pics
- helmholtz chamber vs popping tune?
- Excessive Crankcase Pressure
- Messed Up Bell Housing Bolts
- New engine start up
- Trans rebuild OEM
- The Grapes of Rasp
- Recommendations for improving cooling stack
- If you were wondering about that little split in your axles boots...
- Brz More Noise Advice
- Fatigue Failure JDL FP/OP Combo. Anyone else?
- Are Magnaflow headers any good?
- Chasing a P0301 code down
- Gen 2 GR86/BRZ Oil Cooler Sandwich plates
- Exhaust manifold + Resonated Milltek (db's)
- Oil Fill Cap Broke
- Stall/Torque Converter from SSP , in the real world?
- HPI stronger transmission
- BRZ shuttering/pulling power away while accelerating.
- Help pls traction control light comes on and check engine too
- Delay in engine revs...!
- Engine Oil check valve?
- Missfire above 3k
- Direct injection
- Grinding or rubbing
- The 6 Quart Oil Pan Spacer - Gen 2
- Rear Wheel spin on lift
- New OFT on previously tuned car
- GReddy Circuit Spec Exhaust Manifold (dyno)
- CD009 swap
- Ace Intake/radiator duct
- E85 FRS getting harder to start in the cold
- Differential sadness
- Clutch shop saga (rodent damage?)
- Stock AT Transmission Cooler Line Routing
- Need help identifying intake
- GT86 strange engine sound after hard driving
- Final drive higher or lower for auto turbo?
- I’ve created an exhaust mess
- TBW Underbody Protection Panels
- Clutch
- 2013 FRS timing issue
- Ragged on start up
- Invidia q300 mod
- Ticking noise
- Trouble shifting without rev-matching
- Xforce 2.5" Muffler connecting to Stock Midpipe?
- FA20 main bolt socket
- Yaw sensor code -> No ABS
- Drove thru flood, engine making odd noises when accelerating
- Cusco engine mounts slight burning smell?
- mid pipe
- YIKES! Carbon fiber driveshaft goes bang...
- PCV sucking oil after oil baffle plate install
- Is alternator output load dependant ???
- Replacing linkage bushings?
- ATI Damper?
- All motor build? Stroke, ITBS, Ethanol?!?
- Help diagnosing what appears to be a bad/seized differential
- Horrific drone on a used MXP Comp RS... potentially damaged?
- Any ideas why both of my cats failed?
- Engine Rebuild - Lifter/Rocker Reinstallation
- Frs rear end
- Smoking from catch can and turbo?
- Clicking sound in reverse, automatic transmission
- Bouncing noise when pushing clutch to the floor
- Twin disc clutch strange noise when driving
- OS Giken installation
- Nice sounding exhaust without being to loud and drone
- Engine "knock" sound when it warms up
- Advice on exhaust before first tune!
- Drive shaft u-joints
- JDL FP/OP Advice
- Are cam sprocket bolts reusable?
- 2nd gen intake manifold on 1st gen?
- 2020 Toyota 86 Engine Knock
- New Clutch - Car wants to stall out
- Engine sound
- Oil Accumulator
- HKS Engine Specs
- How To Properly Dyno and Are You Getting Scammed
- GR86 4 gear SYNCHRONIZER ring in GT86?
- Blox Uel, tomei uel, plm uel, skunk2 uel. Which is best?
- Coolant Level - Reservoir vs. Filler Neck
- Jackson Racing DROC - Leaky AN Fitting
- My exhaust has been possesed by demons
- Transmission removal woes
- Stalling at idle...Please help
- MAP sensor bolt spec
- is RockAuto good- clutch & material?
- Direct Injectors stuck in head.
- Engine Ground Strap Locations
- Need an OEM header for 2013
- Battle Garage Ultimate Throwout Bearing
- Exhaust-ed, Need Sound Advice
- Transmission Access port cover.
- Extreme vibration at certain RPM’s after transmission work
- Advice needed- reverse lockout installation issue
- Performance Gains with Catted UEL Headers on Kouki ('17+) 86
- Louder engine noise and more vibration after Exhaust header change
- 2020 GT86 with GR86 stock catback exhaust?
- Transmission snout/retainer replacement.
- PLM Header, overpipe, frontpipe, midpipe, and exhaust?
- This peculiar noise started at the same time I lost power.
- Transmission Rattle while in Gear and Iddle
- Tomei Type D Dual Exit Exhaust