- Car won't hold idle after basemap tune
- Too Late to Turbo?
- Bov spitting oil. Help!!!
- Switching to uel header, tune question
- How much boost can the stock fa20 handle?
- Sti oem turbo kit on an 86
- Cxracing turbo problem
- Garrett G Series turbos (Sema 2017)
- Xxxx
- Over boosted - Jdl Turbo Kit. Engine Knock. R
- Opinions-Keep and go FI or sell?
- Oil catch can with Edelbrock Eforce?
- Jrsc intercooler and bypass valve upgrade questions
- JRSC C30 Loud whine
- Engine Management
- Recirculate Dump Tube?
- Benefits of Recirculating Wastegate
- Jrsc replacement diverter valve issue
- Flex Fuel Gauge and Boost Control based on Ethanol Content
- BRZ - Full Race EFR 7163 Turbo kit - Clean Install
- Want to turbo my BRZ...Ideas?
- Sprintex Survey/Feedback Re Heat Soak
- Supercharge vs Turbo
- Greddy and Blitz Turbo Kit
- I'm seeing conflicting info regarding our PCV valve
- Are Turbo Blankets Worth The $$$
- Anyone else a little excited for the HKS Turbo kit?
- Which turbo kit fits my needs?
- How hot is too hot?
- FI a 86 in Japan, what to use?
- Experience Installing the Works Stage 2 Turbo Kit
- Dual walbro 450 fuel pumps? How??
- Turbo kits with catted header
- Turbo from 06 wrx in Brz?
- Aem water/methanol injection kit
- Blew my motor!!!
- Full 3” exhaust vs half 3” with 2.76” on FI
- Atmospheric Pressure Sensor
- Catch Can Setup
- e-force boost gauge
- Turbo or supercharged???
- Is building a motor necessary for FI on this motor?
- SBD Question....
- UEL vs. EL headers with turbo
- Check Engine Light/Car Shaking
- SBD500x Spark Plugs?
- Turbo Maintenance 101
- Turbo Time
- Edelbrock vs JRSC for track
- Specific goals in mind... Need help selecting FI kit and tune accordingly
- looking for basic tune for Greddy/Trust T518Z Turbo Kit
- Help!! Water/methanol injection
- for AT, turbo or supercharge?
- HKS V3 Supercharger
- Starting issue after building engine
- HKS TURBO!!!! 11001-KT001 Bolt on Turbo Kit GT-III RS
- How do I wire in a hobbs switch for 2 fuel pumps?
- AVO Turbo Kit issues in 2018
- Maperofmance turbokit
- STI PCV for SBD Turbo Kit
- Sprintex 69mm pulley
- rough rpm at 4k
- 4.556 Final Drive with a Turbo Setup
- What would be a good turbo kit for the lowest price?
- Another Catch Can Thread
- MAF Sensor Comparison
- Beat rush oil sandwich plate / oil cooler issue
- Oil drain problems
- Hesitation/Misfire under boost
- Forced induction shoplist
- Sudden Power Loss / Hesitation and jerking under WOT
- Edelbrock Supercharger Install - Will not start, Cranks forever. I'm out of ideas.
- Best SC/Turbo kit for AT?
- Asking advice about Bolt-On Turbo
- Oil type and change interval for FI
- Boost taper at high rpms
- Anyone blow a stock engine running 8 psi(<300HP)
- Newly Built FA20 - Vortech - e85 - Starting Issues
- ARP Custom Age head studs
- Engine internals for 500-600 HP turbo
- FRS/BRZ ELECTRONIC BOOST CONTROL
- Compression ratio for 500hp turbo build
- Suggestions On Boost Issue
- Turbo
- Opinion on Kit
- Turbo Issue?
- Jackson Racing C38 vs C30 with stock pulleys
- 17” wheels too small for FI’d twins?
- JRSC C38 with an RS Pulley
- Automatic turbo frs 2nd gear problems.
- Car jerking hard at WOT
- Is MAP sensor 3bar necessary?
- INSTALLED TURBO, CAR WONT START
- Total loss, selling Custom CP 12.5:1 pistons never used or installed
- Engine oil recommendations for turbo cars
- Forced induction's affect on the nature of the 86
- wastegate extra boost pressure
- thinking out loud...
- FI and Insurance
- Internals for boost?
- FI Questions - SBD vs. JDL
- AOS or catch can for track use
- Which oil cooler for GPP Turbo?
- Adding/Switching to BOV for Supercharger
- Kraftwerks Results w/30 mm belt E85 and high boost
- Turbo ram air intake?
- New clutch?
- 2017 Internals
- What is the best way to have 250bhp on FRS?
- P0103 (MAF code) CEL
- turbo build on stock frs
- Greddy vs JDL
- NA Motor Can Handle 350 Crank HP?
- Exhaust Manifold Absolute Pressure Sensor (EMAP)
- Wastegate flutter!!
- UEL turbo header retrofit possible?
- Need help plotting Turbo Airflow Map
- Engine bogging in WOT after gear change
- SC fitment with 2017 model
- Turbo yoda's Coyoda kit update
- Can you help me?
- 2017+ Toyota 86 SC kit fitment
- Rotrex C38 Compressor Banjo Bolts
- xx
- xx
- Anyone else run into really bad exhaust drone?
- BOV 101
- Boost controllers & fixing high RPM power dip
- Seized motor/vapor lock after installing Edelbrock 1556
- How does the FA20 PCV system work?
- Mysterious turbo kit
- CARB Legal Forced Induction
- Question about the HKS Bolt on
- The WORKS 2017+ Stage 2 Turbo Kit is here!
- When does power break the drivetrain
- Okay to vent PCV catch can back to turbo intake?
- Supercharger whine too loud??
- El & uel
- Turbo burning?
- Would I boost this car again if I had the chance?
- Revisting the phantom electric supercharger
- Steamspeed Turbos
- Engine Blown [Turbo]
- Looking to boost my 2017 BRZ Limited
- Jackson Racing Super Charger Rotrex Reliability Poll
- P0171System Lean Cosworth Supercharger
- To boost or not to boost...
- Sprintex 210, E85 and ACE 350?
- Boost prep for fa20
- Jrsc squeak and squeal that is hard to Locate . Any info would be appreciated !!
- Turbo thoughts, educate me!
- Thinking out loud ...
- Greddy Profec Boost Controller
- Your cam actuators and ECUtek tuning ( help pls )
- Max power from Vortech H67B kit?
- Another direct injection thread! Yay!
- Best Turbo kit for stock engine? As of 2018...
- Reliability on turbo 86
- Small Turbo Recommendations ?
- Can anybody explain why my STFT & LTFT take a dump randomly?
- LOOKING FOR A GOOD TURBOCHARGER
- LOOKING FOR A GOOD TURBOCHARGER
- 2013 Valve Spring recall - modified (FI) engine thread
- Scott from HKS
- Edelbrock SC Stock Tune with Full Exhaust
- Lowering compression
- edelbrock SC pulley install
- Valve Spring Recall = Upgraded Internals?
- Which FI kit for automatic daily driver?
- Supercharger reliability for ~260whp?
- Cost to go turbo??
- Automatic Supercharged Gt86 Shifting Issue
- Any opinions on WORKS stage 2 turbo kit and Corsa catback?
- Front pipe
- help installing MAC 3port electronic boost controler
- JRSC vs HKS v3 SC
- Turbo issues
- LOCATION OF BOV?
- Boost and Lightweight Flywheels?
- Delicious Tuning - Community Update
- Wierd noises from sprintex supercharger
- Twinscroll GTX3576 vs Single GTX3071
- P0172 CEL fixes
- water / meth kit fail-safe with ecutek
- (Boosted) Blown Motor Advice - AFTER RECALL
- Opened up my Rotrex today. Here are my thoughts.
- Choke with Edlebrock SC on E85
- Garrett G25-660 G-Series
- HKS oil cooler with Edelbrock SC
- Safe Boost Compression Options
- Exhaust Smell
- Automatic Brake Booster Vacuum Question
- Valve Spring Failure With Forced Induction?
- Forced induction soon.. questions
- AVO Stage 2 vs Stage 3 Kit
- e-force in -40C weather.
- AIT relocation - Bias resistor values - HKS SC - ECUTEK
- NA E85 worth it on pre FI?
- Intercooler water spray
- Best header for JRSC?
- Supercharger and catch cans
- JRSC and OFT?
- Does this look like a 3 bar map sensor?
- Lower compression effects
- SBD500X turbo kit help
- GT2860RS with JDL turbo kit
- Greddy T518Z Whp
- The Stock Engine Thread
- Greddy T618Z for our FA20 Motor
- 2867r power expectations on e85
- Open Waste gate “Flutter”
- BRZ WONT RUN UNDER 2000 RPM
- Water Methanol without a tune (brainstorm)
- Who Uses Oil Scavenging Pump for Turbo Drain
- Turbo and tuner
- I CANT MAKE A DECISION!!! Jrsc or edelbrock.
- Do companies ever put on sales for turbos/superchargers?
- innovate 210 question
- WRX Manifold on FRS engine block
- greddy t620z kit turbo size
- Gnarly JRSC whine
- Feedback on Verus AOS ?
- dynocom hp??
- Gt 4202 spool info
- Flex Fuel - Lines & Fittings
- Dangers of a Non-Intercooled SC?
- Turbo Flutter
- Recommended gauges for supercharger
- Edelbrock surge tank cap failure?
- Can someone ease my mind a bit when it comes to engines blowing up?
- Manual trans Sprintex 210 owners! Please check if you have these parts laying around
- Car revs to 4K and holds RPM -FBM
- Oil leaking around oil pan screws
- Noise after turbo install
- Turbo Coolant Question
- Blow off valve open at idle
- blitz advance power intake system
- Upgraded fuel pump with stock injectors?
- Replacing mushroom filter for conical?
- Tires after you added boost...
- Brake Booster Hose T-Fitting Size?
- Water/Meth Failsafe and Superchargers?
- spun bearing after 200kms. edelbrock
- HKS Supercharger Owners Poll
- Full blown Stage 1 premium turbo kit vs JDL v2.1
- Edelbrock SC Smallest Pulley
- Noob owner needs help: Part 1 (PCV & BOV)
- Vortech Supercharger thoughts
- Spark Plug Gapping Preference for Turbo Build
- Case study comparing the Ace header against a popular UEL header with FI