follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results

Register and become an FT86Club.com member. You will see fewer ads

Page 5 of 17 1234 5 678915 Last »
Showing results 121 to 150 of 500
Search took 0.01 seconds; generated 81 minute(s) ago. Search: Posts Made By: stevo585
Forum: Forced Induction 05-25-2016, 08:51 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
Wouldn't the big cranks be better than the...

Wouldn't the big cranks be better than the PC680's? They do have a higher CCA rating 170 vs 325 A
Forum: Engine, Exhaust, Transmission 05-24-2016, 09:02 PM
Replies: 683
Views: 390,122
Posted By stevo585
Graphite or sand cast them and make a side...

Graphite or sand cast them and make a side business. :D Laser the flanges and weld them.

Those flutes/runners machined are going to be expensive as hell though for a one off. I would guess...
Forum: Forced Induction 05-23-2016, 11:14 PM
Replies: 7
Views: 3,797
Posted By stevo585
That temp is fine for a 20 or 30 wt oil.

That temp is fine for a 20 or 30 wt oil.
Forum: Forced Induction 05-12-2016, 11:05 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
Be interested to see the afr and ignition advance...

Be interested to see the afr and ignition advance on the OFT compared to my Ecutek tune.

On 93 pump gas I'm at 11.8 afr and 22 degrees. E85 is 12.x afr and timing high 20's not sure exactly.

I...
Forum: Forced Induction 05-09-2016, 10:50 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
It was probably wheel hop as I did a dry burnout....

It was probably wheel hop as I did a dry burnout. Then bogged even after a 4k launch.

14.2 @ 99.5. Too warm kills performance I have done much better in cool weather. I also was only 2.3 on the 60...
Forum: Forced Induction 05-08-2016, 11:08 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
1/4 mile pass this friday May 6th. track run 1...

1/4 mile pass this friday May 6th.
track run 1 - YouTube
Forum: Forced Induction 05-07-2016, 10:33 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
I'm going to track my car soon at PBIR and I...

I'm going to track my car soon at PBIR and I wonder if the ESC will hold up. Gonna suck if I have to run NA. Might look into the aux but does anyone have experience with it on track sessions?
Forum: Forced Induction 05-07-2016, 10:25 PM
Replies: 13
Views: 3,515
Posted By stevo585
This is right an no one considers the area under...

This is right an no one considers the area under the curve just that peak number at 7k rpm. I bet this things feels faster and probably is more street-able than an NA e85 setup. I had that. Now I'm...
Forum: Forced Induction 05-04-2016, 04:37 PM
Replies: 6,041
Views: 2,393,206
Posted By stevo585
Just curious so If you rev out low gears to say...

Just curious so If you rev out low gears to say 5-6k by low throttle you wont' make any boost right? So not really just rpm dependent but also load dependent?

I assume its not until your part...
Forum: Forced Induction 05-04-2016, 12:49 PM
Replies: 6,041
Views: 2,393,206
Posted By stevo585
The rotrex does have a bypass valve right?

The rotrex does have a bypass valve right?
Forum: Forced Induction 05-03-2016, 07:17 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
The system should be pulling around 160 amps....

The system should be pulling around 160 amps. 4000W/24V = AMPS
Forum: Tracking / Autocross / HPDE / Drifting 05-02-2016, 11:22 PM
Replies: 422
Views: 260,182
Posted By stevo585
Whats a good pad for a novice just into HDPE's? I...

Whats a good pad for a novice just into HDPE's? I plan on swapping to torque 700 brake fluid....overkill? Recommend a good fluid? Thanks.
Forum: Forced Induction 04-29-2016, 02:54 PM
Replies: 26
Views: 12,284
Posted By stevo585
I would think more like mid 400's on e85. Can't...

I would think more like mid 400's on e85. Can't the T518z hit nearly 400whp? Maybe I'm getting this confused with the SBD kit.
Forum: Forced Induction 04-26-2016, 07:05 PM
Replies: 11,315
Views: 3,869,914
Posted By stevo585
I am looking around for a cheap used atmospheric...

I am looking around for a cheap used atmospheric blow of valve just for shits and giggles.
Forum: Forced Induction 04-26-2016, 04:15 PM
Replies: 11,315
Views: 3,869,914
Posted By stevo585
I do hear the whine if I really listen. Whats...

I do hear the whine if I really listen. Whats more noticeable is occasionally I do hear a slight psshh blow off valve sound when I lift the throttle.

I assume the air trapped between the throttle...
Forum: Engine, Exhaust, Transmission 04-21-2016, 04:58 PM
Replies: 4
Views: 1,378
Posted By stevo585
Wonder what the new 2017's gearing will be...

Wonder what the new 2017's gearing will be supposedly its improved. I assume that means lowered. I won't be surprised if its around 4.30.
Forum: Forced Induction 04-20-2016, 08:22 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
"If the ESC is turned off, technically it would...

"If the ESC is turned off, technically it would cause a slight air restriction, but likely nothing that would be of consequence".

Not exactly. My MAF was off 10% with it installed when I did my...
Forum: Forced Induction 04-18-2016, 10:50 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
I've pulled from 0-125mph (top of fifth before)....

I've pulled from 0-125mph (top of fifth before). That's what 20-25 seconds? Still around 21-22V.
Forum: Forced Induction 04-14-2016, 08:26 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
You should a ton of capacity now. I always...

You should a ton of capacity now. I always wondered where is the point of diminishing returns or if the two big cranks are it.

As I understand it you would want almost no voltage drop ideally. You...
Forum: Software Tuning 04-14-2016, 08:19 PM
Replies: 22
Views: 10,048
Posted By stevo585
Might need to rescale your MAF. Its a canned tune...

Might need to rescale your MAF. Its a canned tune it will be better for some than others.
Forum: Forced Induction 04-14-2016, 06:28 AM
Replies: 1,206
Views: 407,962
Posted By stevo585
Do you monitor boost? Be curious of that and...

Do you monitor boost? Be curious of that and whats the voltage drop?

I was hoping to do the same but keep the pc680 in the engine bay as well. I think in theory though 1 battery equal to two of...
Forum: Forced Induction 04-13-2016, 09:20 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
What I found is alot times in autocross your not...

What I found is alot times in autocross your not even full throttle. So it never activates. Areas like through a slalom your are wot so it really builds your speed quick almost too quick. All in good...
Forum: Forced Induction 04-08-2016, 08:53 PM
Replies: 168
Views: 103,089
Posted By stevo585
The edelbrock makes more power under the curve....

The edelbrock makes more power under the curve. The JRSC has no advantage on top end (or anywhere) its the same. Not better. The edelbrock is nothing like the sprintex its far superior, especially...
Forum: Forced Induction 04-08-2016, 08:47 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
You mean without going WOT? Otherwise its the...

You mean without going WOT? Otherwise its the same boost level, so not sure what you mean by "huge".

I also really don't want to tap into my ecu. I'm going to try to control it with ecutek.
Forum: Forced Induction 04-07-2016, 11:22 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
The smoothness or lack of is probably the tune....

The smoothness or lack of is probably the tune. Great thing about custom tuning for your particular environment and a scaled maf which all vary some. Mine drives like oem.

As far as dynamics a...
Forum: Forced Induction 04-07-2016, 03:42 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
My guess would be the ESC would get the jump for...

My guess would be the ESC would get the jump for a few seconds as the centrifugal gets to high rpm. Then just pulls away...

A positive placement would likely instantly just pull away from what I...
Forum: Forced Induction 04-07-2016, 03:39 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
No.. its not for sale :D ...sorry maybe in a...

No.. its not for sale :D ...sorry maybe in a year. Not sure I want to put 5k+ into this car that ill never get back.
Forum: Forced Induction 04-07-2016, 03:36 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
Wow sounds low. Its always over 4 psi. My min-max...

Wow sounds low. Its always over 4 psi. My min-max was .28 to .33 bar (4.1-4.8 psi) according to ecutek logging the MAP sensor during the 2 hour street tuning. Otherwise I dont monitor boost I have no...
Forum: Forced Induction 04-06-2016, 08:20 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
I do have a V1 but with latest and brand new big...

I do have a V1 but with latest and brand new big cranks. Only difference is the lighter compressor right? Is that worth upgrading too? You remember I did run a 13.8 @ 101 on e85. That was in 45-55F...
Forum: Forced Induction 04-06-2016, 08:17 PM
Replies: 1,206
Views: 407,962
Posted By stevo585
I actually have a first year kit. It's used....

I actually have a first year kit. It's used. Unlike most I run a custom Ecutek street tune with both 93 and 2x e85 maps saved in the ecu. Otherwise my setup is in my sig. I do have a stock catback...
Showing results 121 to 150 of 500
Page 5 of 17 1234 5 678915 Last »

 
Forum Jump

All times are GMT -4. The time now is 07:57 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.