follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums


Showing results 1 to 30 of 127
Search took 0.45 seconds.
Search: Posts Made By: 504
Forum: Software Tuning 11-16-2020, 08:06 PM
Replies: 8
Views: 1,303
Posted By FR-S2GT86
Good to hear, but keep in mind what I said in my...

Good to hear, but keep in mind what I said in my last post. If your MAF sensor gets oily again, there’s a reason.
Forum: Software Tuning 11-13-2020, 09:55 AM
Replies: 8
Views: 1,303
Posted By FR-S2GT86
I'm just wondering if it's dirty. Rich conditions...

I'm just wondering if it's dirty. Rich conditions on many cars can often be due to a dirty air filter. Not enough air flow for the fuel to burn cleanly. Your ECU sees that and tries to compensate by...
Forum: Software Tuning 11-12-2020, 04:50 AM
Replies: 8
Views: 1,303
Posted By steve99
could be leaking injector excessive fuel...

could be leaking injector
excessive fuel pressure


dirty maf sensor


but just guessing
Forum: Software Tuning 11-01-2019, 07:48 PM
Replies: 4
Views: 1,109
Posted By DBW
I think your tuner has it backwards... 700cc...

I think your tuner has it backwards... 700cc injectors should be no where near that for your power level. With that PI/DI injection ratio your DI injectors would be around 2ms at redline.
Forum: Software Tuning 11-01-2019, 06:54 PM
Replies: 4
Views: 1,109
Posted By tomm.brz
Usually safe limit of DI is an opening time of...

Usually safe limit of DI is an opening time of just under 6ms, so that with colder weather it doesn't go over 6.5ms
But better stay at 6ms when cold

And more than 2ms from end of injection and...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 10-04-2019, 11:03 PM
Replies: 428
Views: 73,456
Posted By 86MLR
Mustang Eco $55kAUD (big fat boat that needs a...

Mustang Eco $55kAUD (big fat boat that needs a V8, LOL, 4cyl Mustang)

Don't get the 2.0 Camaro here

Golf GTI $45 (but FWD and fugly hatch or wagon)

Hyundai Veloster turbo $35k (cheap but...
Forum: Forced Induction 08-13-2019, 10:28 AM
Replies: 33
Views: 10,028
Posted By rb6freak
How many miles since FI setup: 30,000 ...

How many miles since FI setup: 30,000
Type/Brand of FI: PTuning GTX2867R tuned to 15.5psi
Torque and WHP: 240/190/91octane/9psi/mustangDyno - 280/220/101octane/13psi/mustangDyno
Fuel Type: see...
Forum: Software Tuning 07-05-2019, 04:21 PM
Replies: 39
Views: 11,829
Posted By Kodename47
A01G. Tried A02G and reverted back. Same on that...

A01G. Tried A02G and reverted back. Same on that as well I found.

A potentiometer to work out the resistance required and then wired to 12v supply would work. I've just never bothered to test.
...
Forum: Software Tuning 07-05-2019, 08:45 AM
Replies: 39
Views: 11,829
Posted By tomm.brz
it's true, agree.. but if you scale it correctly...

it's true, agree.. but if you scale it correctly i think it's enough the STFT correction, it has anyway more than +-30% of range of correction
also, i get a smoother closed loop driving with ltft...
Forum: Software Tuning 07-05-2019, 07:38 AM
Replies: 39
Views: 11,829
Posted By steve99
Yes turn off af correction #3 for sure but​ not...

Yes turn off af correction #3 for sure but​ not essential to turn of ltft in open loop ive left mine active and run flex kit.
Ill try and test out the issue you and kodenane47 see but im on e85 so...
Forum: Software Tuning 07-05-2019, 06:41 AM
Replies: 39
Views: 11,829
Posted By tomm.brz
the way ecutek wants you to use flex fuel, doesn...

the way ecutek wants you to use flex fuel, doesn t involve ltft
they want you to hook up a flex fuel sensor to know exactly the % of ethanol so it corrects the fueling by itself and doesn t rely on...
Forum: Software Tuning 03-08-2019, 11:40 PM
Replies: 5
Views: 1,166
Posted By steve99
Also have a look at Closed loop...

Also have a look at



Closed loop fueling conpensation - coolant temp 1 and 2 maps under warm up enrichment in ecutek
Forum: Software Tuning 03-08-2019, 08:48 AM
Replies: 5
Views: 1,166
Posted By steve99
Ecu appears to ise those maf after start tables...

Ecu appears to ise those maf after start tables for first minute or so after all starts


Higher coolant temps have less maf offset in standard tables
Forum: Software Tuning 03-08-2019, 01:17 AM
Replies: 5
Views: 1,166
Posted By tomm.brz
one way would be, took a "virgin" stock rom for...

one way would be, took a "virgin" stock rom for that car (not from ecutek database) and star modifying what you dont have in ecutek, with romraider
then save, and reapply all other things in ecutek...
Forum: Software Tuning 01-10-2019, 12:20 PM
Replies: 16
Views: 4,785
Posted By Tor
The problem is the whole scale moves a bit. So if...

The problem is the whole scale moves a bit. So if I need 18 to produce 3% accelerator at a fresh flash, that 18 I put in the tables won't consistently produce 3%.


Traction control, rev limiter,...
Forum: Software Tuning 01-04-2019, 07:50 PM
Replies: 16
Views: 4,785
Posted By steve99
something like this, this is NA E85 so you will...

something like this, this is NA E85 so you will likely be richer in both tables.


http://gyazo.com/0fc20f1f7d34e6e3d29560ef918bdced.png
Forum: Software Tuning 01-04-2019, 07:03 PM
Replies: 16
Views: 4,785
Posted By Kodename47
You can zero the delay. But closed loop should...

You can zero the delay. But closed loop should help in pulling this back towards target so I would be trying to work out why it goes lean. If it does this in closed loop (what are the STFT at this...
Forum: Software Tuning 01-04-2019, 06:41 PM
Replies: 10
Views: 2,952
Posted By Kodename47
It's because the logging addresses can change as...

It's because the logging addresses can change as the different patches use different RAM locations. Some of the older patches changed so much between versions that very few of the RR parameters...
Forum: Software Tuning 01-04-2019, 04:13 PM
Replies: 10
Views: 2,952
Posted By tomm.brz
Yes, you re right, i ve experienced errors too...

Yes, you re right, i ve experienced errors too with a wrong rr patch, but mostly just works
Forum: Software Tuning 01-04-2019, 02:34 PM
Replies: 10
Views: 2,952
Posted By Kodename47
So long as the RR patch is of the same version....

So long as the RR patch is of the same version. If it's not some of the RR parameters may not log correctly.
Forum: Software Tuning 01-04-2019, 08:10 AM
Replies: 10
Views: 2,952
Posted By tomm.brz
Yes you can, just open a stock rom of your CalId...

Yes you can, just open a stock rom of your CalId and apply a racerom patch and start logging
Forum: Software Tuning 01-04-2019, 07:56 AM
Replies: 10
Views: 2,952
Posted By Fred E
You shouldn't have a problem. The only limitation...

You shouldn't have a problem. The only limitation as far as i know would be that any tune files that you would want to flash with this other dongle would need to be keyed for that dongle ID.
Forum: Software Tuning 08-23-2017, 08:30 PM
Replies: 3
Views: 1,416
Posted By steve99
Any standard tables in opensource roms should...

Any standard tables in opensource roms should translate ot ecutek tables.

Do you have bigger port injectors ?

check the port scaling and the injector latency tables

cold start rpm will go...
Forum: Engine, Exhaust, Transmission 07-18-2017, 09:16 PM
Replies: 37
Views: 15,939
Posted By VerusEric
Synchrotech Carbon Synchronizer Upgrade Kit!

We are really excited to share the news with everyone! We can't wait for these to be available!

We are starting a pre-order group-buy to aid Synchrotech in the tooling costs for bringing an...
Forum: Software Tuning 06-12-2017, 08:15 AM
Replies: 12
Views: 2,421
Posted By Boomerang
@steve99 for president

just want to say a huge thankyou to steve99 for all his help in anything tuning related..

he deserves a medal for his efforts!!
Forum: Software Tuning 05-26-2017, 07:38 AM
Replies: 1,088
Views: 451,695
Posted By TachyonBomb
So I came from the 03-15 evo world. I've been...

So I came from the 03-15 evo world. I've been tuning them with tactrix cable + ecuflash since 07. How did ecuflash go from such a nice user friendly program with lots of updates, lots of constantly...
Forum: Forced Induction 05-23-2017, 11:16 PM
Replies: 31
Views: 6,253
Posted By arthur93
You legend!! What kit are you using? Do you have...

You legend!! What kit are you using? Do you have a build thread that I can follow?
Forum: Forced Induction 04-29-2017, 08:16 AM
Replies: 29
Views: 7,791
Posted By bfrank1972
Yup, 110 miles, conclusive, nothing else to...

Yup, 110 miles, conclusive, nothing else to say:thumbsup:
Forum: Forced Induction 04-29-2017, 03:15 AM
Replies: 29
Views: 7,791
Posted By Cal3000
135k Miles on Engine. 110k boosted miles; still going strong

I think the longevity test was passed. I drive 100 miles a day to and from work with it. lol. I'm 284whp (mustang) which is about 370 crank hp or 310-320whp on a dynojet. I think at this power level,...
Forum: Engine, Exhaust, Transmission 04-17-2017, 11:06 AM
Replies: 69
Views: 67,551
Posted By Kayysonie
Figured I'd share. I was running 0w20 since I...

Figured I'd share.
I was running 0w20 since I got the car and installed my pressure gauge around 50k miles. Then I switched to 5w30 (51k miles) just this weekend. I have some few data I can share....
Showing results 1 to 30 of 127

 
Forum Jump

All times are GMT -4. The time now is 05:21 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.