follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results

Register and become an FT86Club.com member. You will see fewer ads

Page 1 of 3 1 23
Showing results 1 to 30 of 81
Search took 0.01 seconds. Search: Posts Made By: wu_dot_com
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 03-01-2018, 04:46 PM
Replies: 41
Views: 14,961
Posted By wu_dot_com
Rear spring Softer compare to ? Brz or FRS? ...

Rear spring Softer compare to ? Brz or FRS?

Based on my research, it’s probably harder than MY13 BRZ, but softer than MY13 FRS
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 01-30-2018, 03:33 PM
Replies: 4,584
Views: 1,470,929
Posted By wu_dot_com
So I’m finally done with my suspension spec out...

So I’m finally done with my suspension spec out for my 13brz. Looking for some advise

Bilstine B6, OE BRZ front spring 2.7k, OE FRS rear spring 3.8K, OE front sway 18mm (+1 if require), 15mm...
Forum: Engine, Exhaust, Transmission 03-20-2015, 03:39 PM
Replies: 72
Views: 23,240
Posted By wu_dot_com
the first 3 video looks normal, nothing specific...

the first 3 video looks normal, nothing specific jumps out.

the last video did raise a lot of questions. the hair like material seems to be the organic friction pad material the clutch uses. it...
Forum: Engine, Exhaust, Transmission 03-19-2015, 02:38 PM
Replies: 72
Views: 23,240
Posted By wu_dot_com
this transmission have the push-rod system. the...

this transmission have the push-rod system. the transmission linkage to the shifter is a L shape solid rod.

my experience came from the hands on work I did when I had to installed the OE clutch...
Forum: Engine, Exhaust, Transmission 03-18-2015, 07:30 PM
Replies: 72
Views: 23,240
Posted By wu_dot_com
Btw if something in the clutch assembly is...

Btw if something in the clutch assembly is broken, you will defiantly hear some weird noise (FOD) from the bell house.

The likelihood of you needing to replace the clutch is low. The burning smell...
Forum: Engine, Exhaust, Transmission 03-18-2015, 07:22 PM
Replies: 72
Views: 23,240
Posted By wu_dot_com
first thing first, check the clutch linkage from...

first thing first, check the clutch linkage from under the dashboard. there is a connecting rod that link the clutch peddle to the master cylinder.

then check if there is any leakage in the MC...
Forum: Engine, Exhaust, Transmission 12-17-2014, 05:23 PM
Replies: 23
Views: 13,454
Posted By wu_dot_com
lets look at this issue from a stress analysis...

lets look at this issue from a stress analysis perspective.

in a engine like this, we will first understand the typical failure modes for bearings, and the implications of those failure modes in...
Forum: Engine, Exhaust, Transmission 08-26-2014, 09:02 PM
Replies: 39
Views: 9,055
Posted By wu_dot_com
here is from a design perspective of bolts, and...

here is from a design perspective of bolts, and washers.

typically bolt / nut torque are selected base off of the nut / bolt yielding load (which ever one is weaker) and compare it to the fatigue...
Forum: Engine, Exhaust, Transmission 05-28-2014, 01:01 PM
Replies: 115
Views: 42,701
Posted By wu_dot_com
the problem with connecting rod and 1 TPs is...

the problem with connecting rod and 1 TPs is that, you can never know for sure the exact amount of volumetric air that is going into each individual TB.

when you have 1 PID, 1 TB and 1 TPS, you...
Forum: Engine, Exhaust, Transmission 05-27-2014, 08:42 PM
Replies: 115
Views: 42,701
Posted By wu_dot_com
i think its a little different between the ITB...

i think its a little different between the ITB (individual throttle bodies) of the past vs now.

the 20 v 4age ITB most likely are controlled by throttle cables. thus the PID lag with modern day...
Forum: Engine, Exhaust, Transmission 03-03-2014, 03:01 PM
Replies: 25
Views: 9,205
Posted By wu_dot_com
yesterday ive switched back to AEM cai again for...

yesterday ive switched back to AEM cai again for the third time after having 42k miles on my car and counting.

this time, im having everything stock except intake.

the behavior of this cai...
Forum: BRZ First-Gen (2012+) — General Topics 02-28-2014, 04:31 PM
Replies: 96
Views: 22,264
Posted By wu_dot_com
if you want to pass those sedans, stop carrying...

if you want to pass those sedans, stop carrying fattys... there is a reason why we have factory bucket seats. think of it as a go/no go gauge.

if the girl didnt fit... sorry please exit the...
Forum: Southern California 02-17-2014, 12:22 PM
Replies: 18
Views: 4,766
Posted By wu_dot_com
glendora mountain road, los angeles

glendora mountain road, los angeles
Forum: Southern California 02-10-2014, 04:00 PM
Replies: 18
Views: 4,766
Posted By wu_dot_com
SOCAL: LA, OC, SD, IE, Sprit Driving Locations

so yesterday i was taking a date out on a sprit drive and a thought pop into my head.

why dont we have a running suggestions for some nice driving routes that we can reference at anytime.
...
Forum: Issues | Warranty | Recalls / TSB 02-04-2014, 06:41 PM
Replies: 219
Views: 102,437
Posted By wu_dot_com
the dealership just called saying my clicking...

the dealership just called saying my clicking sound was a result of a deficient axial nut torque value.

The exact location of said axial nut location is not specified to me. I will ask when I...
Forum: Issues | Warranty | Recalls / TSB 02-04-2014, 04:29 PM
Replies: 219
Views: 102,437
Posted By wu_dot_com
hum i just drop off my car at the dealership for...

hum i just drop off my car at the dealership for the same click issue. its also on the driver rear axel area. i thought it was a crack wheel bearing, but it seems like it could be a crack CV. the...
Forum: Issues | Warranty | Recalls / TSB 01-07-2014, 11:59 AM
Replies: 14
Views: 4,659
Posted By wu_dot_com
you sould have clutch drag. where the clutch is...

you sould have clutch drag. where the clutch is not releasing so your syncro is not spinning fast enough for the gears to engage.

though this is an OEM clutch w/ low miles i would not expect...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-12-2013, 12:13 PM
Replies: 113
Views: 30,861
Posted By wu_dot_com
to further add to Matt's point. the primary...

to further add to Matt's point. the primary function for those bolt that those strut bars attach to are for clamping. force transfers can occur as long as sufficient surface contact exist (or 100%...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-11-2013, 07:51 PM
Replies: 113
Views: 30,861
Posted By wu_dot_com
this article you've posted does give some very...

this article you've posted does give some very basic static force analysis. however, the static analysis is not explain properly.

under all driving condition, point 4 and 5 actually experience a...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-11-2013, 07:29 PM
Replies: 113
Views: 30,861
Posted By wu_dot_com
you have a very valid point. Since I have no...

you have a very valid point. Since I have no historical data, I can only say that there is a possibility of hole distortion based on similar experience.



though the movements of 2 shock towers...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-11-2013, 03:59 PM
Replies: 113
Views: 30,861
Posted By wu_dot_com
GS (GrimmSpeed) Attach pt:2 Type: Bar ...

GS (GrimmSpeed)
Attach pt:2
Type: Bar
Weight : L
MATL / Fabrication: STL/ Wield
Price: 160
Good: reasonable price, solid wield attachment, light weight.
Bad: 2 pt attachments introduce...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-11-2013, 02:54 PM
Replies: 113
Views: 30,861
Posted By wu_dot_com
actually, some hinged joints are for cosmetic,...

actually, some hinged joints are for cosmetic, while others are for performance. it all depends on the tightness in tolerance of the hinge.

by definition, hinges have force transferring...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 11-04-2013, 02:38 PM
Replies: 20
Views: 13,997
Posted By wu_dot_com
Thumbs up Strut Bar Review: AEM Strut Bar Thoughts and Experiences

AEM Strut Bar Review, Thoughts and Experiences
AEM have been one of the more underrepresented brands in aftermarket part on this forum. As a result, I thought I should write a review on AEM’s...
Forum: Engine, Exhaust, Transmission 04-12-2013, 06:44 PM
Replies: 27
Views: 10,890
Posted By wu_dot_com
:thumbup: Thank you for not taking it...

:thumbup:

Thank you for not taking it personal, I wasnt trying to call you out, but I thought you have some new information.

I think one of the major difference between Airaid and AEM is...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 03-12-2013, 11:39 PM
Replies: 190
Views: 50,296
Posted By wu_dot_com
Very good point. :) I think I've turn 90% of...

Very good point. :)

I think I've turn 90% of people away from this topic with this geek talk.:bonk:
Forum: DIY (Do-It-Yourself) Guides 03-12-2013, 12:45 PM
Replies: 4
Views: 2,667
Posted By wu_dot_com
Application: Clutch Slave Cylinder Bleeding ...

Application: Clutch Slave Cylinder Bleeding

Name: Speed Bleeder

Spec: Thd Size (M7 X 1.0); Overall Length, in/(mm) 1.19/ (30.22)

Source: http://www.speedbleeder.com

PN: SB7100S
Forum: Engine, Exhaust, Transmission 03-08-2013, 12:02 PM
Replies: 96
Views: 43,691
Posted By wu_dot_com
Remove

Remove
Forum: Engine, Exhaust, Transmission 03-05-2013, 01:46 PM
Replies: 91
Views: 23,712
Posted By wu_dot_com
also, just because its 304SS doesnt mean its...

also, just because its 304SS doesnt mean its 304SS. ask the manufactor for their batch certification. you could have a bad batch of 304SS with lower than usual chrom content.
Forum: Engine, Exhaust, Transmission 03-04-2013, 02:25 PM
Replies: 96
Views: 43,691
Posted By wu_dot_com
I can see two sides of this argument. The...

I can see two sides of this argument.

The biggest question is does this corrosion consider a quality problem?
There question can be answer in two folds.
1. Does the corrosion prohibit the unit...
Forum: Engine, Exhaust, Transmission 03-01-2013, 06:01 PM
Replies: 96
Views: 43,691
Posted By wu_dot_com
that sounds typical for any wield. the...

that sounds typical for any wield.

the engineering vocab you need to support your clam is
“though 409SSS may have developed a surface oxide layer to protect the corrosion from farther...
Showing results 1 to 30 of 81
Page 1 of 3 1 23

 
Forum Jump

All times are GMT -4. The time now is 09:26 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.