|
||||||
| Forced Induction Turbo, Supercharger, Methanol, Nitrous |
![]() |
|
|
Thread Tools | Search this Thread |
|
|
#1 |
|
Member
Join Date: Jul 2014
Drives: Whiteout 14
Location: San Jose
Posts: 20
Thanks: 5
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Edelbrock surge tank cap failure?
Hi guys,
Been running an edelbrock SC on my frs for the last few months. Recently after an oil change I saw a lot of dried coolant in my engine bay around the surge tank/radiator area and was suspecting some sort of leak. I noticed the surge tank for the SC was a little low, so I topped it off, and went on my way. I also noticed that the cap (motorad t35) was not fitting quite 'right', in that 1. it was a little crooked, and 2. It was kinda like a pill bottle; screw it past a certain tightness and it would loosen up again. I'm assuming this isn't normal and have a replacement cap ordered. Has anyone seen anything similar in their edelbrock? I'm assuming you should be able to screw on the surge tank cap tightly right? Thanks! |
|
|
|
|
|
#2 |
|
Join Date: Jul 2012
Drives: S2000 CR
Location: Orange County
Posts: 14,562
Thanks: 8,942
Thanked 14,211 Times in 6,854 Posts
Mentioned: 970 Post(s)
Tagged: 14 Thread(s)
|
They'll warranty it for you. Contact your vendor, and they'll facilirate it.
|
|
|
|
|
|
#3 |
|
Member
Join Date: Jul 2014
Drives: Whiteout 14
Location: San Jose
Posts: 20
Thanks: 5
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Thanks Mike, I'll be reaching out the shop I got it installed in. How topped off should the surge tank be when the car is cold? I see a 'Max' line, but I assume it should only be that high when the engine is hot?
Thanks! |
|
|
|
|
|
#4 |
|
not playing cards
Join Date: Sep 2014
Drives: a 13 e8h frs
Location: vantucky, wa
Posts: 32,395
Thanks: 53,053
Thanked 37,228 Times in 19,308 Posts
Mentioned: 1117 Post(s)
Tagged: 9 Thread(s)
|
I don't think that's a real thing.
__________________
|
|
|
|
|
|
#6 |
|
not playing cards
Join Date: Sep 2014
Drives: a 13 e8h frs
Location: vantucky, wa
Posts: 32,395
Thanks: 53,053
Thanked 37,228 Times in 19,308 Posts
Mentioned: 1117 Post(s)
Tagged: 9 Thread(s)
|
I googled vendors who facilirate and it looks like CSG is the only one. Those guys are amazing.
__________________
|
|
|
|
|
|
#7 |
|
Member
Join Date: Feb 2015
Drives: 2017 BRZ Limited PP
Location: Atlanta, GA
Posts: 80
Thanks: 116
Thanked 28 Times in 22 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
I dont know, I facilirate stuff at my job all the time. I think its more common than you think.
|
|
|
|
| The Following User Says Thank You to kritch For This Useful Post: | Ultramaroon (07-03-2019) |
|
|
#8 |
|
Join Date: Jul 2012
Drives: S2000 CR
Location: Orange County
Posts: 14,562
Thanks: 8,942
Thanked 14,211 Times in 6,854 Posts
Mentioned: 970 Post(s)
Tagged: 14 Thread(s)
|
It should always be above the flowing portion in the bottom, to facilitate self-bleeding.
|
|
|
|
| The Following User Says Thank You to CSG Mike For This Useful Post: | Ultramaroon (07-05-2019) |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Radium surge tank | GrabTheWheel | Tracking / Autocross / HPDE / Drifting | 30 | 01-17-2022 09:35 AM |
| JUN GT SURGE TANK FOR FT86/BRZ | scubie.brz | Engine, Exhaust, Transmission | 60 | 11-23-2020 08:48 PM |
| Edelbrock sc oil catch tank and filter | Kojiap1 | Forced Induction | 1 | 08-16-2017 05:24 AM |
| SARD Surge Tank Kit w/ ITB from TAS 2017 | mav1178 | Engine, Exhaust, Transmission | 50 | 05-12-2017 11:50 PM |
| Moto East / Deatschwerks Drop-in Surge Tank - tech & discussion | Xero-Limit | Engine, Exhaust, Transmission | 42 | 04-27-2017 10:16 PM |