Aftermarket header, new secondary O2 sensor, code P013A

[steve99]

Originally Posted by kizz

Damn, 2 CEL. One was P050B, I disabled the cat warm up to reduce noise on my neighbors. I am able to disable that code, but P013A is not in the definitions. Is there an easy way to add that DTC to the definitions without losing the A/F#3 tables?

EDIT: I looked in the XML definition and found both entries for P013A, but it still doesn't show in Romraider. o.o

You can safely disable P050B code its only and emission check code.


P013A is going to be more difficult, you will need to find someone skilled at rom disassembly, likely on romraider forums.


Did you remove that right angle adapter that's going to make rear 02 see lean condition.


And maybe try a second hand oem rear sensor from auto wreckers, they will all be same from 2012 to 2016 auto or manual car

[kizz]

Originally Posted by steve99

You can safely disable P050B code its only and emission check code.


P013A is going to be more difficult, you will need to find someone skilled at rom disassembly, likely on romraider forums.


Did you remove that right angle adapter that's going to make rear 02 see lean condition.


And maybe try a second hand oem rear sensor from auto wreckers, they will all be same from 2012 to 2016 auto or manual car

Ahh shit, I can't get to a lift right now and have to drive 2 hrs on saturday. Was hoping to disable the code cause it kills cruise control.

Will have to deal with it and remove the spacer when I get back, or maybe this weekend if I can get under the car.

Thanks for the help.