|
||||||
| Engine, Exhaust, Transmission Discuss the FR-S | 86 | BRZ engine, exhaust and drivetrain. |
 |
|
|
Thread Tools | Search this Thread |
01-25-2017, 09:18 PM
|
#15 |
|
Senior Member
Join Date: Apr 2013
Drives: 2005 Toyota Camry
Location: 91745
Posts: 6,562
Thanks: 493
Thanked 6,100 Times in 3,030 Posts
Mentioned: 95 Post(s)
|
I would say:
in general, if you run stock engine mounts and your exhaust hangers are in good condition, you are fine. If you have a car with higher mileage (75k+ or more) then some of the rubber hanger should be replaced on the exhaust. Just keep in mind: there's two flex sections on the entire stock exhaust: factory exhaust manifold, and the donut gasket. The more solid everything is, the more likely a failure may occur. But, say the probability of something breaking is 0.5%, you may increase this risk to perhaps 3% and it can still be perfectly fine on your car for many years. As is the case with many other things, YMMV (Your Mileage May Vary) Additional NVH into the cabin is a secondary concern, IMO. |
|
|
|
01-29-2017, 05:24 PM
|
#16 |
|
Senior Member
Join Date: Dec 2014
Drives: Honda Accord Euro
Location: Europe
Posts: 204
Thanks: 251
Thanked 54 Times in 38 Posts
Mentioned: 1 Post(s)
|
I have found the thread about vibrations - if anybody is interested.
http://www.ft86club.com/forums/showthread.php?t=102332 |
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Noticeable vibration after installing aftermarket parts. | boredjester | Engine, Exhaust, Transmission | 14 | 09-28-2016 10:38 AM |
| Looking for any aftermarket headers | Easy | Mid-Atlantic | 11 | 05-24-2015 08:36 PM |
| Aftermarket headers in Ontario | Mr.Impreza | CANADA | 22 | 05-02-2015 11:42 AM |
| WTB aftermarket Headers | Nitro_FRS | Engine, Exhaust, Bolt-Ons | 5 | 01-09-2014 02:07 AM |
| Is aftermarket UEL headers with a cat a bad idea? | IAmNotTheDriftKing | Engine, Exhaust, Transmission | 27 | 12-27-2013 06:14 PM |
