04-11-2015, 11:49 AM | #1 |
Senior Member
Join Date: Feb 2011
Drives: 2013 FR-S Matte Orange
Location: Portland, OR
Posts: 2,016
Thanks: 489
Thanked 937 Times in 507 Posts
Mentioned: 168 Post(s)
Tagged: 0 Thread(s)
|
Ground Control Complete Coilover System
$2000
This setup has been on my car for a little less than 6,000 miles. It includes the upgraded Koni Race double adjustable inserts in the struts. The housings are Koni Yellow with the coilover adjustment section anodized red. Selling with the super beefy camber plates and strut bar for the front and 1" drop top hats for the rear. The camber plates and strut bar are anodized pewter. This setup will allow a drop of 3" if you chose to go that low. I got -3* camber out of the front which is great for track alignment. Spring rates: Front 475lb/in or 8.5k Rear 500lb/in or 9k Photos are of the product when new. They are powder coat finish and will clean up to like new with the exception of marking under bolt head locations.
__________________
Last edited by digital_assassin; 04-13-2015 at 11:39 AM. |
04-11-2015, 10:43 PM | #2 |
Senior Member
Join Date: Jul 2014
Drives: 2013 Scion FR-S 10 Series
Location: Clarendon Hills, IL
Posts: 617
Thanks: 442
Thanked 356 Times in 202 Posts
Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
|
Is the photo of the coilovers representative of their current condition, or was it taken prior to installation (they look brand new)? Additionally, what pound springs are used front and rear?
Last edited by RJasonKlein; 04-11-2015 at 10:47 PM. Reason: I added a second question. |
04-12-2015, 10:57 PM | #3 |
Senior Member
Join Date: Feb 2011
Drives: 2013 FR-S Matte Orange
Location: Portland, OR
Posts: 2,016
Thanks: 489
Thanked 937 Times in 507 Posts
Mentioned: 168 Post(s)
Tagged: 0 Thread(s)
|
The pictures are from when new. When they come off the car there will be some marking at the bolt holes. They are powder coated so they'll clean up and look like new.
I'll get the spring rates in a little bit. Its escaping me ATM so I need to dig up the paperwork.
__________________
|
04-13-2015, 12:55 AM | #4 |
Senior Member
Join Date: Feb 2011
Drives: 2013 FR-S Matte Orange
Location: Portland, OR
Posts: 2,016
Thanks: 489
Thanked 937 Times in 507 Posts
Mentioned: 168 Post(s)
Tagged: 0 Thread(s)
|
Front spring rate is 475lb/in or 8.5k and rears are 500lb/in or 9k
__________________
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ground Control Complete coilovers vs RCE Tarmac T2 | knipple | Suspension | Chassis | Brakes -- Sponsored by 949 Racing | 16 | 05-28-2014 05:32 PM |
FS: Ground Control complete coilover kit | bombardius | Brakes, Suspension, Chassis | 13 | 05-22-2014 09:25 PM |
Ground Control Complete Coilover Suspension Kit and Adjustable End Links | Eric1855 | Brakes, Suspension, Chassis | 12 | 05-26-2013 12:02 AM |
Ground Control Complete Coilover Kit | D1cker | Brakes, Suspension, Chassis | 2 | 04-06-2013 10:05 PM |
Ground Control Complete Kit Install and Initial Thoughts | Eric1855 | Suspension | Chassis | Brakes -- Sponsored by 949 Racing | 33 | 03-21-2013 10:52 AM |