Ground Control Complete Coilover System
 

$2000

This setup has been on my car for a little less than 6,000 miles. It includes the upgraded Koni Race double adjustable inserts in the struts. The housings are Koni Yellow with the coilover adjustment section anodized red. Selling with the super beefy camber plates and strut bar for the front and 1" drop top hats for the rear. The camber plates and strut bar are anodized pewter.

This setup will allow a drop of 3" if you chose to go that low. I got -3* camber out of the front which is great for track alignment.

Spring rates:
Front 475lb/in or 8.5k
Rear 500lb/in or 9k

Photos are of the product when new. They are powder coat finish and will clean up to like new with the exception of marking under bolt head locations.

http://www.ft86club.com/forums/attac...0&d=1397691969
http://www.ft86club.com/forums/attac...2&d=1397692048
http://www.ft86club.com/forums/attac...1&d=1397692003

Is the photo of the coilovers representative of their current condition, or was it taken prior to installation (they look brand new)? Additionally, what pound springs are used front and rear?

The pictures are from when new. When they come off the car there will be some marking at the bolt holes. They are powder coated so they'll clean up and look like new.

I'll get the spring rates in a little bit. Its escaping me ATM so I need to dig up the paperwork.

Front spring rate is 475lb/in or 8.5k and rears are 500lb/in or 9k

Any comments on the set up? I have yet to read a proper write up reviewing the GC Koni Kit. Anyone chime in?