BEST EXHAUST FOR RUMBLE - Page 3 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

LBC Por Siempre · 12-18-2013, 08:48 PM

For sure dude; when I finally do get my exhaust - along with whatever type of forced induction I decide on, I sure in-the-hell don't want that "FART CAN" sound.

Sniper2606 · 12-18-2013, 09:26 PM

[ame="http://www.youtube.com/watch?v=tSkmF-_x0WU"]BRZ with headers - YouTube[/ame]

Borla headers, motiv over pipe, invidia catless pipe, Q300

My setup, love it on the summer time cold start its pretty damn loud

protpibe · 12-19-2013, 02:39 PM

Quote:

Originally Posted by 1086

@Steve The rear doesn't look too bad with the single exit. Of course, if that $80 piece of plastic that covers the passenger gap were say, not $80 - I'd go for it lol.

@husker741 right...sure, you could easily say that with regard to any car above or below $30k - my point is that the OP was focusing on sound so it doesn't make much sense to spend $1.5k plus, for sound, hence "I want that deep rumble sound". If he is looking for more than just that, different story, different response but not the case.

I didn't really care about cost too much within reason, I just wanted a deep rumble. Any performance increases I MAY have gained were not a selling point. A muffler delete will increase the volume of the exhaust, but it has a little too much pop for my tastes. A full catback with muffler and a UEL header will give a nice deep rumble without the poppiness of a muffler delete. To some, that's worth the $1,500+. Different strokes for different folks!

troek · 12-19-2013, 09:54 PM

i hope you didnt suffocate, lol

fx35s · 12-19-2013, 11:30 PM

It's rather a bit expensive catback, but I like my M7 catback.

Take 1: [ame="http://www.youtube.com/watch?v=zvMWxP2XgVg"]121713 T1 - YouTube[/ame]

Take 2: [ame="http://www.youtube.com/watch?v=ninhQCpZJWw"]121713 T2 - YouTube[/ame]

Take 3: [ame="http://www.youtube.com/watch?v=lY2lNqaNVA4"]121713 T3 - YouTube[/ame]

Hope these helps with your decision.

If you have any questions just PM me, I'll hook you up

KevinTJH · 12-22-2013, 07:01 AM

Thanks guys for all the responses. Wasn't expecting so many in such a short period of time!

As some have pointed out, rumble is all I'm looking for. I'm quite happy with the way the stock exhaust pipes look.

I know it sounds ridiculous, but my budget was no more than $200 (including labour), what could I possibly do to get a louder rumble?

geeang · 12-22-2013, 08:05 AM

Quote:

Originally Posted by KevinTJH

Thanks guys for all the responses. Wasn't expecting so many in such a short period of time!

As some have pointed out, rumble is all I'm looking for. I'm quite happy with the way the stock exhaust pipes look.

I know it sounds ridiculous, but my budget was no more than $200 (including labour), what could I possibly do to get a louder rumble?

You're joking right?

In Australia, $200 including labour will get you NOTHING that will give you a louder rumble.

z3ro · 12-22-2013, 08:39 AM

Quote:

Originally Posted by Sniper2606

Borla headers, motiv over pipe, invidia catless pipe, Q300

My setup, love it on the summer time cold start its pretty damn loud

i just nutted

protpibe · 12-22-2013, 09:22 AM

Quote:

Originally Posted by KevinTJH

Thanks guys for all the responses. Wasn't expecting so many in such a short period of time!

As some have pointed out, rumble is all I'm looking for. I'm quite happy with the way the stock exhaust pipes look.

I know it sounds ridiculous, but my budget was no more than $200 (including labour), what could I possibly do to get a louder rumble?

200 won't get you anything. Even if you found a used header, you'll still be spending about 600 after installation

Sent from my HTC One using Tapatalk

Sniper2606 · 12-23-2013, 08:02 PM

Quote:

Originally Posted by z3ro

i just nutted

You wanna hear this on a super cold 20 degrees start?

z3ro · 12-24-2013, 08:08 AM

Quote:

Originally Posted by Sniper2606

You wanna hear this on a super cold 20 degrees start?

do you even have to ask?

John92 · 12-28-2013, 10:29 PM

[ame]http://youtu.be/MkdkAUdDHds[/ame]

all the perrin setups I've run.

RedBRZ80 · 12-29-2013, 09:38 AM

Buy a mustang with flow masters? Just saying..

acg2010 · 12-29-2013, 04:55 PM

LOL in a sense RedBRZ has a point. No matter what, it's still a 4 cyl. It's never gonna have a hugely deep rumble. V8's 10's 12's rumble.

I find the louder the exhaust is the more clear it is its just a tiny sub-200hp engine (this doesn't apply to just the twins and isn't a knock on them, it just is what it is). As the tiny 4 exhaust gets louder it starts to just sound like an angry bee in a coffee can - no matter how high quality the parts are.

No offense meant to John, it's all what you like, but I think his various setups exemplify this. They get louder and louder, but they get more "tinny" sounding and more hollow. There's just not that much exhaust being produced. It's got a rock rattling in a pipe sound, not a low deep constant rumble like a 5.0 v8.

I think some people confuse loud for rumble. Snipers' sounds pretty good, and doesn't seem like it'd have too much drone, but its still just "louder" not a setup with particularly more "rumble."

When it comes to big rumble (like a mustang), there's just no replacement for displacement.

Just my .02 from modding cars with varying engine sizes.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to get that boxer rumble?	ryude	Engine, Exhaust, Transmission	45	03-20-2014 02:30 PM
Best exhaust rumble - no rasp	DarkestBuddha	Engine, Exhaust, Transmission	5	07-17-2013 02:49 AM
Tire rumble noise	Mokiki	Issues \| Warranty \| Recalls / TSB	13	02-13-2013 03:59 PM
subaru rumble	V1B	Engine, Exhaust, Transmission	25	07-13-2012 07:03 AM
Rumble coming from rear end?	No Quarter	Scion FR-S / Toyota 86 GT86 General Forum	34	06-27-2012 02:14 PM

12-18-2013, 08:48 PM	#29
LBC Por Siempre Senior Member Join Date: Dec 2013 Drives: 2008 Toyota Prius, 2012 911 Turbo Location: Long Beach, Bakersfield Posts: 157 Thanks: 3 Thanked 23 Times in 19 Posts Mentioned: 0 Post(s)	For sure dude; when I finally do get my exhaust - along with whatever type of forced induction I decide on, I sure in-the-hell don't want that "FART CAN" sound.

12-18-2013, 09:26 PM	#30
Sniper2606 Senior Member Join Date: Apr 2013 Drives: 2013 BRZ Location: OKC, OK Posts: 677 Thanks: 159 Thanked 221 Times in 138 Posts Mentioned: 6 Post(s)	[ame="http://www.youtube.com/watch?v=tSkmF-_x0WU"]BRZ with headers - YouTube[/ame] Borla headers, motiv over pipe, invidia catless pipe, Q300 My setup, love it on the summer time cold start its pretty damn loud

12-19-2013, 11:30 PM	#33
fx35s Senior Member Join Date: May 2013 Drives: 2013 Subaru BRZ Location: NNJ Posts: 433 Thanks: 510 Thanked 117 Times in 92 Posts Mentioned: 6 Post(s)	It's rather a bit expensive catback, but I like my M7 catback. Take 1: [ame="http://www.youtube.com/watch?v=zvMWxP2XgVg"]121713 T1 - YouTube[/ame] Take 2: [ame="http://www.youtube.com/watch?v=ninhQCpZJWw"]121713 T2 - YouTube[/ame] Take 3: [ame="http://www.youtube.com/watch?v=lY2lNqaNVA4"]121713 T3 - YouTube[/ame] Hope these helps with your decision. If you have any questions just PM me, I'll hook you up

12-22-2013, 07:01 AM	#34
KevinTJH Member Join Date: Feb 2013 Drives: Toyota GT86 RED Location: Sydney, Australia Posts: 74 Thanks: 4 Thanked 6 Times in 5 Posts Mentioned: 0 Post(s)	Thanks guys for all the responses. Wasn't expecting so many in such a short period of time! As some have pointed out, rumble is all I'm looking for. I'm quite happy with the way the stock exhaust pipes look. I know it sounds ridiculous, but my budget was no more than $200 (including labour), what could I possibly do to get a louder rumble?

12-29-2013, 04:55 PM	#42
acg2010 Senior Member Join Date: Dec 2013 Drives: 4 wheels/engine/seats Location: Texas Posts: 167 Thanks: 74 Thanked 80 Times in 56 Posts Mentioned: 1 Post(s)	LOL in a sense RedBRZ has a point. No matter what, it's still a 4 cyl. It's never gonna have a hugely deep rumble. V8's 10's 12's rumble. I find the louder the exhaust is the more clear it is its just a tiny sub-200hp engine (this doesn't apply to just the twins and isn't a knock on them, it just is what it is). As the tiny 4 exhaust gets louder it starts to just sound like an angry bee in a coffee can - no matter how high quality the parts are. No offense meant to John, it's all what you like, but I think his various setups exemplify this. They get louder and louder, but they get more "tinny" sounding and more hollow. There's just not that much exhaust being produced. It's got a rock rattling in a pipe sound, not a low deep constant rumble like a 5.0 v8. I think some people confuse loud for rumble. Snipers' sounds pretty good, and doesn't seem like it'd have too much drone, but its still just "louder" not a setup with particularly more "rumble." When it comes to big rumble (like a mustang), there's just no replacement for displacement. Just my .02 from modding cars with varying engine sizes.

User Name		Remember Me?
Password