Aftermarket Engine Mount - Page 2 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

utekineir · 10-21-2013, 09:55 PM

Quote:

Originally Posted by Sportsguy83

IMHO, it is only noticeable in 6th gear, 30 mph and putting load on the engine. Aside from that, I don't notice much.

so.... a majority of the time for anyone dding?

Sportsguy83 · 10-21-2013, 10:43 PM

Quote:

Originally Posted by utekineir

so.... a majority of the time for anyone dding?

Do you really spend a lot of time in 6th gear going over 50% throttle?

6th gear is usually reached at 45+ mph and at that point its extremely minimum.

utekineir · 10-21-2013, 10:46 PM

Quote:

Originally Posted by Sportsguy83

Do you really spend a lot of time in 6th gear going over 50% throttle?

6th gear is usually reached at 45+ mph and at that point its extremely minimum.

just read like 6th gear to me, not 6th gear and high load

my bad

Sportsguy83 · 10-21-2013, 10:52 PM

Quote:

Originally Posted by utekineir

just read like 6th gear to me, not 6th gear and high load

my bad

No problem, my explanation might have been incomplete. Its only at around 30 mph. Anything 40+ its barely noticeable and once up and running (around 50+) its ok. I am not saying they are equal to stock or anything like that, but its really a small increase in NVH.

Calum · 10-22-2013, 08:46 AM

Quote:

Originally Posted by Sportsguy83

IMHO, it is only noticeable in 6th gear, 30 mph and putting load on the engine. Aside from that, I don't notice much.

How did you even find that? Oh wait, you have torque...

Thanks man.

Sportsguy83 · 10-22-2013, 08:50 AM

Quote:

Originally Posted by Calum

How did you even find that? Oh wait, you have torque...

Thanks man.

Taber · 10-23-2013, 04:11 PM

Anyone running the Cusco mounts? Feedback?

RallySport Direct · 10-23-2013, 07:23 PM

Quote:

Originally Posted by Taber

Anyone running the Cusco mounts? Feedback?

We run the Cusco mounts on our shop car here and we love them. Yes, they are very very stiff. I would not recommend them if you value comfort, or if this is your daily driver. Now the good thing about them being so stiff is that the response from the engine is immediate as you no longer have any soft mounts soaking up the movement.

You can check out my thread on the cusco engine mounts and rear diff brace here.

http://www.ft86club.com/forums/showthread.php?t=30313

Thanks,
Rick

grostoine · 10-23-2013, 07:33 PM

Thanks! I allready saw your video on the cusco engine mount!! This is realy interesting!

DesertFrs · 10-23-2013, 07:53 PM

Avo has engine mounts and transmission mounts.

EvilBeaverFace · 10-24-2013, 02:37 PM

Quote:

Originally Posted by DesertFrs

Avo has engine mounts and transmission mounts.

http://www.avoturboworld.com/avoshop...nts-p-219.html
http://www.avoturboworld.com/avoshop...unt-p-218.html

Anyone want to try these or own it and want to do a review?

Dodzilla · 10-24-2013, 03:43 PM

Those are the STI engine and transmission mounts on avoturboworld.

EvilBeaverFace · 10-24-2013, 05:04 PM

Quote:

Originally Posted by Dodzilla

Those are the STI engine and transmission mounts on avoturboworld.

Didn't catch that before I posted though it is a little confusing since they don't say anywhere that they're the STI version. I was just going off what the other guy said and since they were the only ones listed on AVO's site.

Thanks for letting us know.

Stevo22 · 10-24-2013, 05:56 PM

Quote:

Originally Posted by ATL BRZ

Looking into a pair myself. How were your install experiences guys? I've heard they can be a huge PITA.

Did you leave the header on or take it off when installing them?

Here is a bulleted guide from @mrk1. Engine Mount Install

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using OEM Mic for Aftermarket Radio AND/OR Replacing OEM Mic with Aftermarket Mic	ecko04	Electronics \| Audio \| NAV \| Infotainment	10	05-05-2018 04:47 PM
What will happen to the aftermarket for this car after the engine bump?	enjoi23	Scion FR-S / Toyota 86 GT86 General Forum	19	10-13-2013 03:08 AM
Raceseng Tow Hook w/ Go Pro Mount Built In Front/Rear Mount -fteightysix	86SPEED	Exterior Parts - The Rest	2	08-20-2013 02:37 AM
DIY: Making a GoPro camera mount with a GrimmSpeed front plate mount	PMok	DIY (Do-It-Yourself) Guides	2	06-11-2013 11:58 AM
Engine sputtering while idling with check engine light flashing, WTF	speedy racer	Scion FR-S / Toyota 86 GT86 General Forum	15	08-27-2012 07:50 AM

10-23-2013, 04:11 PM	#21
Taber Member Join Date: Jun 2013 Drives: 2013 BRZ Limited Location: Maine Posts: 61 Thanks: 17 Thanked 21 Times in 15 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Anyone running the Cusco mounts? Feedback?

10-23-2013, 07:33 PM	#23
grostoine Senior Member Join Date: Nov 2012 Drives: Subaru BRZ Location: Quebec Posts: 392 Thanks: 9 Thanked 104 Times in 54 Posts Mentioned: 13 Post(s) Tagged: 0 Thread(s)	Thanks! I allready saw your video on the cusco engine mount!! This is realy interesting!

10-23-2013, 07:53 PM	#24
DesertFrs Senior Member Join Date: Dec 2012 Drives: Scion FRS 10 Series AVO Turbo Location: Coachella Valley / Riverside Posts: 426 Thanks: 303 Thanked 297 Times in 149 Posts Mentioned: 40 Post(s) Tagged: 0 Thread(s)	Avo has engine mounts and transmission mounts.

10-24-2013, 03:43 PM	#26
Dodzilla Member Join Date: Jun 2013 Drives: 2013 Subaru BRZ Location: Las Vegas Posts: 29 Thanks: 2 Thanked 22 Times in 7 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Those are the STI engine and transmission mounts on avoturboworld.

User Name		Remember Me?
Password