follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 2 1 2
Showing results 1 to 30 of 59
Search took 0.01 seconds. Search: Posts Made By: WHITE
Forum: Forced Induction 08-07-2015, 09:22 AM
Replies: 464
Views: 196,907
Posted By WHITE
75mm @ 7,650rpm = 15,235rpm 72.5mm @...

75mm @ 7,650rpm = 15,235rpm

72.5mm @ 7,650rpm = 15,769rpm

70mm @ 7,650rpm = 16,307rpm

The "safe" CONTINUOS rpm of the 210 and 335 blower is 15,000rpm. I'm not going to tell you whether or...
Forum: Forced Induction 07-19-2015, 12:48 PM
Replies: 123
Views: 52,265
Posted By WHITE
It just means one of the rocker arms in the head...

It just means one of the rocker arms in the head broke.
Forum: Engine, Exhaust, Transmission 07-18-2015, 10:58 AM
Replies: 22
Views: 14,401
Posted By WHITE
Carrillo rods are good. Cp or JE are both...

Carrillo rods are good.

Cp or JE are both good pistons.

10.0:1 CR

Yes to stronger valvesprings.

As for oiling, id look toward element tuning for suggestions as they're most likely leading...
Forum: Forced Induction 07-16-2015, 08:55 PM
Replies: 123
Views: 52,265
Posted By WHITE
Draco-REX Here's were element tuning first...

Draco-REX

Here's were element tuning first encountered the problem:
http://www.ft86club.com/forums/showthread.php?t=73858

And if you scroll down a little on this page it talks about it...
Forum: Forced Induction 07-16-2015, 08:25 PM
Replies: 123
Views: 52,265
Posted By WHITE
Draco-REX oil starvation might not have been the...

Draco-REX oil starvation might not have been the culprit. there's an, as of right now, uncommon factory defect of the "pin" that holds the rocker arm failing and backing out of the rocker arm. This...
Forum: Forced Induction 07-16-2015, 01:20 PM
Replies: 110
Views: 33,428
Posted By WHITE
2015/2016 wrx is an fa20di-t. Unless you already...

2015/2016 wrx is an fa20di-t. Unless you already knew that and were making a remark about how the new wrx engine is better then the ej205, in wich case disregard my post.
Forum: Forced Induction 07-15-2015, 04:13 PM
Replies: 65
Views: 23,076
Posted By WHITE
In that case I agree with you 100%, the car in...

In that case I agree with you 100%, the car in the OP will probly never see anything other then the rollers. Making that much power on stock engine is just for bragging rights, put it on the track or...
Forum: Forced Induction 07-15-2015, 03:44 PM
Replies: 65
Views: 23,076
Posted By WHITE
I find it comical when people think you cant use...

I find it comical when people think you cant use 500+hp in this car. If you set the car up right you can make even 1000hp usable. You just need to take the time and set everything up right.
Forum: Forced Induction 07-15-2015, 09:16 AM
Replies: 65
Views: 23,076
Posted By WHITE
Its a bone stock engine, so 12.5:1 compression...

Its a bone stock engine, so 12.5:1 compression ratio pistons.
Forum: Forced Induction 07-13-2015, 07:48 PM
Replies: 123
Views: 52,265
Posted By WHITE
I'm going to go out on a limb here and venture my...

I'm going to go out on a limb here and venture my guess to be that you ate a rocker and shot it out of the valve cover. Just a guess. I'm interested to see what the actual verdict is.
Forum: Forced Induction 07-12-2015, 08:22 PM
Replies: 123
Views: 52,265
Posted By WHITE
Might have to call and find out. They might make...

Might have to call and find out. They might make them, but dont advertise as theyre not popular since most people reduce compression ratio.


I'd like to tell you that you wont notice a difference...
Forum: Forced Induction 07-12-2015, 07:44 PM
Replies: 123
Views: 52,265
Posted By WHITE
What you want is 4032 forged pistons, they'll be...

What you want is 4032 forged pistons, they'll be more then strong enough for you. And they wont slap and burn oil like 2618's.

Off the top of my head, you can get arias through full blown in 4032,...
Forum: Forced Induction 07-12-2015, 07:21 PM
Replies: 123
Views: 52,265
Posted By WHITE
I'm not sure what happened, I'm not here to...

I'm not sure what happened, I'm not here to answer that.




But in response to your building dilemma....you want safety, and reliability...then you want forged internals, OR you want to just go...
Forum: Engine, Exhaust, Transmission 07-12-2015, 04:19 PM
Replies: 25
Views: 8,745
Posted By WHITE
Efferalgan yes they still offer the stage one...

Efferalgan yes they still offer the stage one clutches. Ssp is still working on the stage 2 last i talked to them a month or so ago.

http://www.dsgperformance.com/SSP-Stage-1-Clutch-BRZ-FR-S
Forum: Engine, Exhaust, Transmission 07-06-2015, 09:10 AM
Replies: 38
Views: 13,729
Posted By WHITE
If you haven't known already, piper cams has...

If you haven't known already, piper cams has three options.

http://www.pipercams.co.uk/pipercams/www/product.php?pid=SUBFA20BP300
Forum: Other Vehicles & General Automotive Discussions 07-03-2015, 02:13 PM
Replies: 48
Views: 12,946
Posted By WHITE
Looks like a can-am spyder or whatever with a...

Looks like a can-am spyder or whatever with a body tossed on it lol
Forum: Forced Induction 07-02-2015, 10:03 AM
Replies: 24
Views: 6,036
Posted By WHITE
Simple tire change to a better compound and a...

Simple tire change to a better compound and a tiny bit wider cures that problem. Its a well known fact the Prius tires are crap unless your looking to drift everywhere. But its an easy fix, no need...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 06-29-2015, 06:22 PM
Replies: 5
Views: 2,763
Posted By WHITE
I also ran my pilot super sports at 32 psi hot....

I also ran my pilot super sports at 32 psi hot. My sizes were 255/40r18 front 265/40r18 rear. Tires wore even on all four corners, id say your problem was becuase you ran them at 39psi, thats too...
Forum: Forced Induction 06-28-2015, 04:50 PM
Replies: 464
Views: 196,907
Posted By WHITE
moto-mike Whats the max lb/min of the 335?

moto-mike Whats the max lb/min of the 335?
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 06-25-2015, 09:27 AM
Replies: 194
Views: 68,293
Posted By WHITE
Subbed. Have to say I'm really excited about...

Subbed. Have to say I'm really excited about this. You will have at least one buyer right here.
Forum: Engine, Exhaust, Transmission 06-24-2015, 09:50 AM
Replies: 6
Views: 5,634
Posted By WHITE
If they're anything like these(based on the...

If they're anything like these(based on the description of both they're similar)......

http://www.rallysportdirect.com/Okada-Projects-PD4004901R-Plasma-Direct-Coil-Packs

Then you can look here...
Forum: Forced Induction 06-23-2015, 11:43 PM
Replies: 103
Views: 45,431
Posted By WHITE
Just read this whole thread....made for a comical...

Just read this whole thread....made for a comical night. In for the dissapointment.
Forum: Forced Induction 06-23-2015, 11:39 AM
Replies: 24
Views: 6,776
Posted By WHITE
How long your stock block lasts depends on tune...

How long your stock block lasts depends on tune and were you're making your power, not just how much power your making.

You can slap a turbo on it and only have 200hp but if your tune sucks your...
Forum: Engine, Exhaust, Transmission 06-22-2015, 07:18 PM
Replies: 683
Views: 370,742
Posted By WHITE
Im not talking about thermal expansion. Im...

Im not talking about thermal expansion. Im talking physical rod stretch from the rpms youll be spinning. From what little ive read it would appear the consensus is that a steel rod can stretch from...
Forum: Engine, Exhaust, Transmission 06-21-2015, 07:36 AM
Replies: 12
Views: 6,838
Posted By WHITE
I know I'm repeating all that's mentioned above...

I know I'm repeating all that's mentioned above but I feel its worth beating to death,

-Your block is NOT the weakest link.
-your connecting rods ARE the weakest link.
Forum: Engine, Exhaust, Transmission 06-13-2015, 09:24 AM
Replies: 683
Views: 370,742
Posted By WHITE
Now put it all together!!!

Now put it all together!!!
Forum: Engine, Exhaust, Transmission 06-09-2015, 04:40 AM
Replies: 14
Views: 3,792
Posted By WHITE
In case ya didn't get the memo :reposthorse:...

In case ya didn't get the memo :reposthorse: .......its "wire loom". Its a protective plastic casing/sleeve that protects part of the wire harness from premature wear and direct contact with heat....
Forum: Engine, Exhaust, Transmission 06-04-2015, 06:50 PM
Replies: 116
Views: 78,791
Posted By WHITE
So then why even say anything ij the first place?...

So then why even say anything ij the first place? If you know people arent going to listen to you and theyre going to spend their money how they want, whats the point of calling them out and telling...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 05-23-2015, 10:19 PM
Replies: 7
Views: 1,590
Posted By WHITE
Depending on how much adjustability you have on...

Depending on how much adjustability you have on your lower control arms you may be able to adjust the camber plates on your coil over to full positive and use the lca to adjuster your camber back to...
Forum: Engine, Exhaust, Transmission 01-20-2014, 04:44 PM
Replies: 115
Views: 40,666
Posted By WHITE
Cool doesnt pay the bills. Happy sponsors pay the...

Cool doesnt pay the bills. Happy sponsors pay the bills, happy sponsors are made by winning races and being on the track racking up points. A tried and true engine(ej) will ensure you to be out on...
Showing results 1 to 30 of 59
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 08:18 AM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.