EcuTek 0-5v inputs - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

1stGenBRZ86 · 06-03-2014, 10:41 PM

Is it possible to run an EBCS, Flex Fuel, and Wideband O2 inputs into an EcuTek powered ecu all at the same time? It seems as though only 2 inputs (CPC and rear O2) are supported for all three. Am I missing something?

Xero-Limit · 06-03-2014, 11:19 PM

Yup. You have two inputs (evap cpc/o2) and one output (evap solenoid). We've had folks doing all 3 and it works.

spdbydesign · 06-03-2014, 11:42 PM

Quote:

Originally Posted by moto-mike

Yup. You have two inputs (evap cpc/o2) and one output (evap solenoid). We've had folks doing all 3 and it works.

+1, this is how we setup the cars here for all 3.

1stGenBRZ86 · 06-04-2014, 12:32 AM

Thanks!

06-03-2014, 10:41 PM	#1
1stGenBRZ86 Senior Member Join Date: May 2013 Drives: 2013 BRZ Location: NYC Posts: 207 Thanks: 110 Thanked 58 Times in 35 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	EcuTek 0-5v inputs Is it possible to run an EBCS, Flex Fuel, and Wideband O2 inputs into an EcuTek powered ecu all at the same time? It seems as though only 2 inputs (CPC and rear O2) are supported for all three. Am I missing something?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pinout for FRS Bespoke head unit - video inputs?	ATSAaron	Electronics \| Audio \| NAV \| Infotainment	2	12-09-2014 11:59 PM
Spliting analog output signal (0-5v) to two inputs.	marcoaferrer	Software Tuning	16	02-27-2014 11:29 AM
Pioneer ALCP-W13U (FR-S head unit) RCA ports: inputs or outputs?	Anthony	Electronics \| Audio \| NAV \| Infotainment	8	01-07-2014 02:52 PM
where is the mic inputs on the fRS radio	njccmd2002	Electronics \| Audio \| NAV \| Infotainment	4	12-10-2013 01:59 AM
The New Tanabe Exhaust- Inputs and Thoughts	JM Auto Racing	Engine, Exhaust, Transmission	28	08-31-2012 04:40 PM

06-03-2014, 11:19 PM	#2
Xero-Limit Join Date: Nov 2012 Drives: JDL Turbo FRS, 335SC BRZ (ret) Location: Lehigh Valley, PA Posts: 938 Thanks: 368 Thanked 1,550 Times in 527 Posts Mentioned: 380 Post(s) Tagged: 6 Thread(s)	Yup. You have two inputs (evap cpc/o2) and one output (evap solenoid). We've had folks doing all 3 and it works.

06-04-2014, 12:32 AM	#4
1stGenBRZ86 Senior Member Join Date: May 2013 Drives: 2013 BRZ Location: NYC Posts: 207 Thanks: 110 Thanked 58 Times in 35 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Thanks!

User Name		Remember Me?
Password