Windshield dimensions?

[tiger1964]

Anyone with a tape measure might contribute dimensions of the windshield; say height, and width at top and bottom? If so, thanks.

I bought my wife a novelty-imprinted sunshade, and it's far too big for her S2000 and would need to be trimmed. But, if the dimensions of the Honda's and BRZ windshield are so different as we cannot find a reasonably "common" fit, maybe she should hold off 1.5 years and then trim it to fit the Subaru after we get the car.

[tiger1964]

Well, perhaps easiest to measure my neighbor's 1st gen Toyota 86 and presume the dimensions are similar.

[DocWalt]

~25" tall in the center
~53" wide at the base
~46" at the top

[tiger1964]

Originally Posted by DocWalt

25" tall in the center
54" wide at the base

Thank you! Any chance I could also get the width at the top?

[DocWalt]

Just checked again, some updated measurements.

~25" tall
~46" at the top
~53" at the bottom

[tiger1964]

Originally Posted by DocWalt

Just checked again, some updated measurements.

~25" tall
~46" at the top
~53" at the bottom

Thanks! Sorry, I had not checked the website in 2 days; I figured I would not hear back so I measured the neighbor's 1st-gen 86 and came up with similar numbers. Those are close to the S2000's dimensions so we'll trim the sunshade to fit both cars, more or less. It will need the edge banding to be re-used or replaced.

Now when she goes shopping, Robert, Jimmy, Jonesy and Bonzo can watch over her car.