SCCA CS Legal Koni Stepped Washer Size?

[MarkR171]

I just received my set of full-replacement Konis and was hoping to install them and get an alignment done by this weekend... but Koni is still not shipping them with the insert to make them SCCA CS legal.

Does anyone know the sizes for the stepped washer for the top mounting hole to make them CS legal? Also, any tips on where to find one? I'll also call Koni, but am expecting to find it faster elsewhere.

[Locust]

Originally Posted by MarkR171

I just received my set of full-replacement Konis and was hoping to install them and get an alignment done by this weekend... but Koni is still not shipping them with the insert to make them SCCA CS legal.

Does anyone know the sizes for the stepped washer for the top mounting hole to make them CS legal? Also, any tips on where to find one? I'll also call Koni, but am expecting to find it faster elsewhere.

I had to E-mail Koni. They send it out immediately but it'll take about a week and a half. They're super responsive so just hit them up today and they should reply.

[MarkR171]

Originally Posted by Locust

I had to E-mail Koni. They send it out immediately but it'll take about a week and a half. They're super responsive so just hit them up today and they should reply.

That's what I was afraid of. I'd like to have them installed for a practice event with another club this weekend before the last SCCA event of the season next month.

[MarkR171]

You weren't kidding about Koni responding immediately. It took them all of 5 minutes to ask me for my address and tell me they are sending it via UPS 2 day. Awesome.

Side note, It's 16mm to 14mm from this: https://s3-us-west-1.amazonaws.com/s...structions.pdf