|
||||||
| Issues | Warranty | Recalls / TSB Problems, issues, recalls, TSBs |
 |
|
|
Thread Tools | Search this Thread |
07-18-2016, 05:23 PM
|
#1 |
|
Member
Join Date: Aug 2014
Drives: 2013 Scion FR-S
Location: South Carolina
Posts: 66
Thanks: 7
Thanked 15 Times in 8 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
car won't start after clutch installed
So I uograded my clutch, old one came out and new one went in with out an issue. all connections that were disconnected were reconnected. when i went to go turn the key to start it, it cranked but didn't start. I'm now getting three DTC codes U0100, U0122 and U0151. Has anyone had this or a similar issue and have possible resoloutions? I'm thining the ecu is shot... I hope not...
Side note, I know it's not good pratice, but I didn't disconnect the battery before i started... |
|
|
|
07-18-2016, 07:21 PM
|
#2 |
|
Site Moderator
Join Date: Oct 2009
Drives: ichi 86 Project
Location: Middle of No where
Posts: 20,976
Thanks: 7,673
Thanked 19,102 Times in 8,333 Posts
Mentioned: 681 Post(s)
Tagged: 27 Thread(s)
|
U0100 is causing the rest of the codes. iirc U0100 is something to do with ECM. Might need to check to make sure to you connected all the wires correctly.
__________________
 |
|
|
|
|
07-18-2016, 07:33 PM
|
#3 |
|
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 29,953
Thanks: 28,927
Thanked 32,003 Times in 16,486 Posts
Mentioned: 709 Post(s)
Tagged: 2 Thread(s)
|
In addition, you may consider disconnecting the battery now ..... to see if the system will right itself.
humfrz |
|
|
|
| The Following User Says Thank You to humfrz For This Useful Post: | Ultramaroon (07-18-2016) |
|
07-18-2016, 08:45 PM
|
#4 |
|
Member
Join Date: Aug 2014
Drives: 2013 Scion FR-S
Location: South Carolina
Posts: 66
Thanks: 7
Thanked 15 Times in 8 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
We've triple check the wire connections and I disconnect the battery earlier today for about a half an hour with no change in status
|
|
|
|
|
07-19-2016, 01:29 AM
|
#5 | |
|
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 29,953
Thanks: 28,927
Thanked 32,003 Times in 16,486 Posts
Mentioned: 709 Post(s)
Tagged: 2 Thread(s)
|
Quote:
 http://www.obd-codes.com/u0100 humfrz |
|
|
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help!! Car Wont Start After Clutch Swap (25$ reward for solution!!) | bren5279 | Issues | Warranty | Recalls / TSB | 44 | 07-03-2017 08:36 AM |
| Clutch Rattle at cold start | shellslinger | Issues | Warranty | Recalls / TSB | 16 | 10-11-2015 01:45 PM |
| Cold start rattle after header,op,fp installed by a newb | aristo | Engine, Exhaust, Transmission | 5 | 10-28-2014 07:28 AM |
| Push-button start clutch switch | mike the snake | Engine, Exhaust, Transmission | 8 | 04-14-2014 11:31 PM |
| RPM varies, cold start, clutch in and out | 00NissanNinja | Issues | Warranty | Recalls / TSB | 8 | 03-04-2014 11:40 PM |
Bad Habbit
