Phone holder

[Ovrtme]

Here's my amatuerish first attempt. Used a Ram Mount and Proclip offset swivel base, attached to a piece of 1/4 wood. I wanted mine a bit higher and farther forward, so I offset the swivel into the corner of the wood, rather than the center. It works great for me, except that I haven't attached it to the console, just sitting in the spot, so it goes flying in fast corners. I'm thinking velcro or maybe magnets - now that I've seen this thread.

[jshadeck]

Originally Posted by Shagaliscious

I like my ProClip. A little more expensive then others (mine was around $65 with shipping), but I think it is perfect. Spins 360 degrees and tilts.

Proclip dash mount and iphone 5 specific holder is PERFECT. Never been happier w a phone mount.

[Ericc B]

[Ericc B]

[jshadeck]

Not angled towards the drivers eyes and a little far away to reach w out leaning out of the seat :/ otherwise id really like the 86logo aspect

[Crackseed]

That ProClip setup is great, though I might have to re-order a separate holder in a few months when the new 5 comes out haha.

Thanks for posting that! Ordering my own today

[Shagaliscious]

Originally Posted by Crackseed

That ProClip setup is great, though I might have to re-order a separate holder in a few months when the new 5 comes out haha.

Thanks for posting that! Ordering my own today

I love it, use it all the time. Even when I don't use my phone for navigation, it's just nice to not have it in my pocket but still right there.

[DKPJester]

Originally Posted by TennisHsu

Here is my solution

I know this post is from forever ago, but I was wondering if that suction would hold to the dash trim and if there would be space enough to get the suction cup in the little panel of dash trim to the right of the stereo but to the left of the split between the two trip pieces. If you a) still have the mount and b) don't mind giving it a shot I would really appreciate it.

[TennisHsu]

Originally Posted by DKPJester

I know this post is from forever ago, but I was wondering if that suction would hold to the dash trim and if there would be space enough to get the suction cup in the little panel of dash trim to the right of the stereo but to the left of the split between the two trip pieces. If you a) still have the mount and b) don't mind giving it a shot I would really appreciate it.

As long as it's a clean non porous surface, this thing sticks to anything. So yes it should stick to the panel you are referring to. I will check to see if there is enough space this weekend.

[DKPJester]

Originally Posted by TennisHsu

As long as it's a clean non porous surface, this thing sticks to anything. So yes it should stick to the panel you are referring to. I will check to see if there is enough space this weekend.

I really appreciate that. I like the placement of the magnet/adhesive solution in this thread but I feel much more secure with a suction cup configuration. That should provide the best of both worlds

[jshadeck]

Originally Posted by DKPJester

I really appreciate that. I like the placement of the magnet/adhesive solution in this thread but I feel much more secure with a suction cup configuration. That should provide the best of both worlds

Thats the exact placement of the proclip, if that is of any use to u

[TennisHsu]

Originally Posted by DKPJester

I really appreciate that. I like the placement of the magnet/adhesive solution in this thread but I feel much more secure with a suction cup configuration. That should provide the best of both worlds

The suction cup is wider than that piece you are referring to.

[jshadeck]

[31katys]

Did you see the 86 badge phone holder in the photos of the convertible?? Maybe they'll sell those as an accessory?