Exhaust experiment

[Tainen]

I think this is a decent idea. Yes, it will mate up, and be a full header back system, and with two resonators it should keep the overall sound in a good place, especially with headers.

I have catless headers, and yes, they do resonate, so if you plan on going that deep into an NA build, you need to account for resonating with either a really quiet axleback setup or resonators.

[BuBlake]

Check it out, they said it was a mistake and corrected it, hurray!: http://www.shopgreddy.com/exhaust-he...3-exhaust.html
I kind of figured, but wanted to be 101% sure...

So it is in fact a midpipe and muffler included with the Greddy EVO 3. Not bad for $860, imo. With the front pipe w/high flow cat and overpipe from Nameless, i'm looking at about $1400 for a full exhaust, no headers. I'll go ahead and add in the optional resonator because I know it'll be more than enough sound-wise either way.

I'll order as soon as my paycheck comes in this week, then hopefully Greddy will ship it out when it's released or a little earlier. :0) The Nameless stuff should be shipped sooner, which may result in me wanting to try out the front pipe and overpipe by themselves. (With stock muffler) I'll probably opt for a Greddy Intake and a Perrin crank pulley as well.

[BuBlake]

Originally Posted by boarder1995

The stock resonator reduces the exhaust/header/engine resonance. The optional resonator offered by Nameless (Helmholtz resonator) is in addition to the stock resonator that stays in place. They offer this to further reduce a resonance they find that pops up a bunch with aftermarket headers they're working on. Mixing exhaust will bring mixed results. YMMV.

How did you get the Nameless headers? I don't see them on the website.

[Foobar]

Originally Posted by BuBlake

Check it out, they said it was a mistake and corrected it, hurray!: http://www.shopgreddy.com/exhaust-he...3-exhaust.html
I kind of figured, but wanted to be 101% sure...

So it is in fact a midpipe and muffler included with the Greddy EVO 3. Not bad for $860, imo.

Good job!

By the way, FT86Club vendors are selling the system for less than GReddy's MSRP. That thread I linked is such an example.

[BuBlake]

Originally Posted by Foobar

Good job!

By the way, FT86Club vendors are selling the system for less than GReddy's MSRP. That thread I linked is such an example.

Thanks! I may even be able to get a combo deal with the Greddy Intake. I requested a pm from the vendor.

[Sportsguy83]

Originally Posted by BuBlake

How did you get the Nameless headers? I don't see them on the website.

He's their "test" car before someone in the shop bought an FRS


Sent from my iPad using Tapatalk HD

[boarder1995]

Originally Posted by BuBlake

How did you get the Nameless headers? I don't see them on the website.

I don't have them (yet), but thought I should be prepared.

[Sportsguy83]

Originally Posted by BuBlake

How did you get the Nameless headers? I don't see them on the website.

Originally Posted by sportsguy83

He's their "test" car before someone in the shop bought an FRS


Sent from my iPad using Tapatalk HD

Oops, my bad, thought you had responded to Tainen. Tainen was their test car is what I meant. He DOES have the Header prototype installed.