Suspension setup for Limerock

[autosenses]

Hey everyone,

I need a little help to get an idea what alignment setup I should start for this season.

I'm going to do a season at Limerock's AutoX which is the official FCP Euro Proven grounds.

I know I have limited adjustment with stock suspension, but what alignment numbers should I be looking for? I have 17x8 45's RPF1's with 225 RT660's & camber bolts (not installed yet).

Any help is appreciated.

[strat61caster]

Max front camber whatever it is, -1.5 ish at best depending on which bolts you got. Zero toe front, 1/16” in at the rear. Can’t do anything else have fun.

[jflogerzi]

More camber could help. Peddler top hats would add another degree of camber

Sent from my Pixel 6 using Tapatalk

[autosenses]

Originally Posted by strat61caster

Max front camber whatever it is, -1.5 ish at best depending on which bolts you got. Zero toe front, 1/16” in at the rear. Can’t do anything else have fun.

I have SPC camber bolts. These ok? Other bolts better or offer more angle?

Thanks for the help!

[strat61caster]

Originally Posted by autosenses

I have SPC camber bolts. These ok? Other bolts better or offer more angle?

Thanks for the help!

Sure, check this thread out. FYI aftermarket camber bolts bump you out of d street if your club follows scca classing.

https://www.ft86club.com/forums/showthread.php?t=103609

[autosenses]

Originally Posted by strat61caster

Sure, check this thread out. FYI aftermarket camber bolts bump you out of d street if your club follows scca classing.

https://www.ft86club.com/forums/showthread.php?t=103609

Thanks.

So my SPC bolts will give me a max of 1.75? I thought its capable of 2.5? Either way, think 1.75 is a good start.

What should I expect for tire wear?

[strat61caster]

Originally Posted by autosenses

Thanks.

So my SPC bolts will give me a max of 1.75? I thought its capable of 2.5? Either way, think 1.75 is a good start.

What should I expect for tire wear?

Depends on which bolt you got 14 or 16mm, it’s in the thread.

Rear should wear decently even, you’ll chew up the outside edge of the front tire a noticeable amount, rotating front to back will help but you may consider flipping the tires on the wheels to squeeze a few more events out of them.

[autosenses]

Originally Posted by strat61caster

Depends on which bolt you got 14 or 16mm, it’s in the thread.

Rear should wear decently even, you’ll chew up the outside edge of the front tire a noticeable amount, rotating front to back will help but you may consider flipping the tires on the wheels to squeeze a few more events out of them.

Your right it is in the thread- just read it again. SO much information! I love it.

I think I got 14? this is the SPC model number SPC81305

https://www.ftspeed.com/part/81305-s...1#.ZCvxZHbMLEY