Suspension setup for Limerock
 

Hey everyone,

I need a little help to get an idea what alignment setup I should start for this season.

I'm going to do a season at Limerock's AutoX which is the official FCP Euro Proven grounds.

I know I have limited adjustment with stock suspension, but what alignment numbers should I be looking for? I have 17x8 45's RPF1's with 225 RT660's & camber bolts (not installed yet).

Any help is appreciated.

:cheers:

Max front camber whatever it is, -1.5 ish at best depending on which bolts you got. Zero toe front, 1/16” in at the rear. Can’t do anything else have fun.

More camber could help. Peddler top hats would add another degree of camber

Sent from my Pixel 6 using Tapatalk

I have SPC camber bolts. These ok? Other bolts better or offer more angle?

Thanks for the help!

Sure, check this thread out. FYI aftermarket camber bolts bump you out of d street if your club follows scca classing.

https://www.ft86club.com/forums/showthread.php?t=103609

Thanks.

So my SPC bolts will give me a max of 1.75? I thought its capable of 2.5? Either way, think 1.75 is a good start.

What should I expect for tire wear?

Depends on which bolt you got 14 or 16mm, it’s in the thread. :iono:

Rear should wear decently even, you’ll chew up the outside edge of the front tire a noticeable amount, rotating front to back will help but you may consider flipping the tires on the wheels to squeeze a few more events out of them.

Your right it is in the thread- just read it again. SO much information! I love it.

I think I got 14? this is the SPC model number SPC81305

https://www.ftspeed.com/part/81305-s...1#.ZCvxZHbMLEY