Clutch Flywheel & Fuel rail change Engine cranks but won't start after

[svnintl]

So, make sure you have your cranks dowel aligned with your crank plate. My awesome tuner (guess that's why you pay the professionals) suggested that after reading everything else was correct on the ecutek loggin, did I check the crank dowel. Evidently I installed it 180 degree opposite of its hole. Had to order new crank plate.

I'm still reinstalling everything but will give final update if that's the culprite

https://www.ft86club.com/forums/atta...1&d=1596372915

https://www.ft86club.com/forums/atta...1&d=1596372915

[Gloonge]

Ayyy I got it right with the trigger wheel. Been there done that bud, good luck on the reassembly!

[svnintl]

Originally Posted by Gloonge

Ayyy I got it right with the trigger wheel. Been there done that bud, good luck on the reassembly!

Yup you got it. And it was exactly the reluctor wheel. Car fired up today. So recap: if you don't have any trouble codes, all fuses checked, and battery is charged; check your reluctor wheel, crank sensor, and fuel pressure.

[Gloonge]

Originally Posted by svnintl

Yup you got it. And it was exactly the reluctor wheel. Car fired up today. So recap: if you don't have any trouble codes, all fuses checked, and battery is charged; check your reluctor wheel, crank sensor, and fuel pressure.

I wish mine was so simple. Just installed the edelbrock supercharger today and no start. I think the tune I got from Open Flash has the map sensor set out of range, I still show -1.6 psi with the car off.

Just waiting on a response from them in the next day or so. Glad you're back on the road!