Monogram series headlights on a FRS

[kthxbai]

Originally Posted by @Art_Mighty

...but most people do this wrong because the US Spec only have a wire running to the "Hi-Watt" side of the LED assembly. If you connect it as it is then the daytime LED's are actually to bright at night and are blinding to oncoming traffic I fixed this by adding back the "Low-Watt" lead. You can also look into intergrading the new Diode Dynamics always on module into your mod...

Sorry to bring up an old thread, I just got my hands on a used set of Release Series Headlights. Could you elaborate on how to added back the low-watt lead? Right now my LED bar is blinding at night as you mentioned. I'm no electrician, so any help put in the simplest form or a picture is greatly appreciated!

Sent from my Pixel 3 using Tapatalk

[@Art_Mighty]

Originally Posted by kthxbai

Sorry to bring up an old thread, I just got my hands on a used set of Release Series Headlights. Could you elaborate on how to added back the low-watt lead? Right now my LED bar is blinding at night as you mentioned. I'm no electrician, so any help put in the simplest form or a picture is greatly appreciated!

Sent from my Pixel 3 using Tapatalk

sorry for the very late reply, I'm not here often

it's been years since i've done anything with this but i will try and find my notes. i stared at the wiring diagram for hours figuring this out. The party trick is that you need to Retrofit the existing wires onto a new plug that came from a vehicle properly equipped for factory hids