07-10-2020, 04:17 PM
|
#71401 | |
|
Senior Member
Join Date: Feb 2012
Drives: '13 FR-S (#3 of 1st 86)
Location: Powder Springs, GA
Posts: 20,118
Thanks: 39,698
Thanked 25,475 Times in 11,612 Posts
Mentioned: 187 Post(s)
|
Quote:
Didn't realize you needed a key to start a sailboat... 
__________________
Olivia 05/03/2012 - 01/06/2024. 231,146 glorious miles.
Visit my Owner's Journal where I wax philosophic on all things FR-S Post your 86 or see others in front of a(n) (in)famous landmark. What fits in your 86? Show us the "Junk In Your Trunk". |
|
|
| The Following User Says Thank You to Dadhawk For This Useful Post: | p1l0t (07-10-2020) |
|
07-10-2020, 04:26 PM
|
#71402 | |
|
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 30,430
Thanks: 29,826
Thanked 32,845 Times in 16,844 Posts
Mentioned: 715 Post(s)
|
Quote:
|
|
|
|
| The Following User Says Thank You to humfrz For This Useful Post: | p1l0t (07-10-2020) |
|
07-10-2020, 06:35 PM
|
#71403 | |
|
Famous Potatoes
Join Date: Mar 2016
Drives: '15 ultramarine
Location: Idaho
Posts: 14,051
Thanks: 5,816
Thanked 19,658 Times in 9,249 Posts
Mentioned: 163 Post(s)
|
Quote:
|
|
|
|
| The Following User Says Thank You to Sapphireho For This Useful Post: | Dadhawk (07-10-2020) |
|
07-10-2020, 07:31 PM
|
#71404 | |
|
Senior Member
Join Date: Jun 2013
Drives: RX-7 / BRZ
Location: USA
Posts: 2,349
Thanks: 1,031
Thanked 2,501 Times in 1,081 Posts
Mentioned: 27 Post(s)
|
Quote:
Buy a full face paint respirator and this stuff.  It is an acid, so gear up in throw-a-way clothes and don't do it on a nice garage floor. Spray on, let sit until your eyes water and then scrub it off. Afterwards rinse the fuck out of everything with soapy water. Work amazing on cleaning up older boats that lived in the water and not dry docked.
__________________
//2013 World Rally Blue BRZ Limited FBM Turbo--gone
//2018 Crystal White Pearl BRZ Ts 2.2l Harrop Supercharged |
|
|
|
| The Following 2 Users Say Thank You to Kiske For This Useful Post: | p1l0t (07-10-2020), soundman98 (07-11-2020) |
|
07-10-2020, 07:45 PM
|
#71405 | |
|
Senior Member
Join Date: Jun 2013
Drives: RX-7 / BRZ
Location: USA
Posts: 2,349
Thanks: 1,031
Thanked 2,501 Times in 1,081 Posts
Mentioned: 27 Post(s)
|
Quote:
Nah, go. being that is one of the newer engines being swapped into a '13 car I already have to swap over almost every sensor and plug. A few more parts shouldn't be the end of the world. I've had 2 engines that came with each car. I've had one built engine from MAPerformance in 2015. I put a low mileage junk yard engine in the 13 car after the MAP engine burned up. It lasted about 1300 miles. The following engine was bought and never received 'because covid19 45 days weren't enough time to ship it...' way back in February.  It took forever for paypal to get the refund process. I then just bought another used low mileage engine with 20k on the clock which I just received. I also have another engine being build by IAG Performance to put in my tS over winter. I consider it my final, final try. It is a full custom build using the HKS Stroker, overbored and closed deck. It will be a 2.3l Harrop Supercharged monster. It's currently held up by JE Pistons whom are backed up with no ETA... I tell myself I cannot break my tS until I get the blue car out the door for good!
__________________
//2013 World Rally Blue BRZ Limited FBM Turbo--gone
//2018 Crystal White Pearl BRZ Ts 2.2l Harrop Supercharged |
|
|
|
| The Following 2 Users Say Thank You to Kiske For This Useful Post: | soundman98 (07-11-2020), Spuds (07-11-2020) |
|
07-10-2020, 08:38 PM
|
#71406 |
|
Senior Member
Join Date: Feb 2012
Drives: '13 FR-S (#3 of 1st 86)
Location: Powder Springs, GA
Posts: 20,118
Thanks: 39,698
Thanked 25,475 Times in 11,612 Posts
Mentioned: 187 Post(s)
|
My home laser printer apparently won't print in black and white if one of the color cartridges is empty! How completely stupid is that? And, of course, all the stores are closed because COVID says you have to roll up the carpets at 8:00pm.
Out of frustration, I restarted the printer. Apparently if you queue up jobs to the printer, then restart it, it will print before it's logic bomb tells it that one of its cartridges are empty. Take that, Michael Dell! Oh, I should add, I have the replacement Magenta cartridge (I always keep a set at home), or at least I thought I did. turns out the wrong cartridge was shipped in the right box. It's for a completely different printer model.
__________________
Olivia 05/03/2012 - 01/06/2024. 231,146 glorious miles.
Visit my Owner's Journal where I wax philosophic on all things FR-S Post your 86 or see others in front of a(n) (in)famous landmark. What fits in your 86? Show us the "Junk In Your Trunk". |
|
|
| The Following 3 Users Say Thank You to Dadhawk For This Useful Post: |
|
07-10-2020, 09:09 PM
|
#71407 |
|
Senior Member
Join Date: Jan 2018
Drives: Crapcan
Location: Oregon
Posts: 11,603
Thanks: 18,883
Thanked 16,883 Times in 7,684 Posts
Mentioned: 112 Post(s)
|
For as eff’d as these friction rings look, they are still in spec
 
__________________
"Experience is the hardest kind of teacher. It gives you the test first and the lesson afterward." -Oscar Wilde.
|
|
|
| The Following 3 Users Say Thank You to NoHaveMSG For This Useful Post: |
|
07-10-2020, 09:39 PM
|
#71408 | |
|
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 30,430
Thanks: 29,826
Thanked 32,845 Times in 16,844 Posts
Mentioned: 715 Post(s)
|
Quote:
|
|
|
|
| The Following 2 Users Say Thank You to humfrz For This Useful Post: | Dadhawk (07-12-2020), soundman98 (07-11-2020) |
|
07-10-2020, 09:42 PM
|
#71409 | |
|
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 30,430
Thanks: 29,826
Thanked 32,845 Times in 16,844 Posts
Mentioned: 715 Post(s)
|
Quote:
|
|
|
|
|
07-10-2020, 09:51 PM
|
#71410 |
|
Site Moderator
Join Date: Oct 2009
Drives: ichi 86 Project
Location: Middle of No where
Posts: 21,058
Thanks: 7,738
Thanked 19,285 Times in 8,392 Posts
Mentioned: 697 Post(s)
|
Top & middle are using 1084 steel vs bottom is 1080 steel.
There’s only 0.004 carbon difference between 1080 & 1084, but belt sander def saw the difference. Went through double of belts than 1080.
__________________
 |
|
|
| The Following 4 Users Say Thank You to ichitaka05 For This Useful Post: |
|
07-10-2020, 10:29 PM
|
#71411 |
|
Airborne at your service
Join Date: Sep 2014
Drives: '17 BRZ Series.Yellow
Location: El Paso, Texas
Posts: 6,419
Thanks: 4,579
Thanked 5,706 Times in 2,992 Posts
Mentioned: 33 Post(s)
|
Would you say it's wrong to get a VPN so you can watch things you're not supposed to?
__________________
|
|
|
| The Following 4 Users Say Thank You to weederr33 For This Useful Post: |
|
07-11-2020, 12:37 AM
|
#71412 | |
|
not playing cards
Join Date: Sep 2014
Drives: a 13 e8h frs
Location: vantucky, wa
Posts: 32,392
Thanks: 53,053
Thanked 37,228 Times in 19,308 Posts
Mentioned: 1118 Post(s)
|
Quote:
__________________
|
|
|
|
|
07-11-2020, 12:38 AM
|
#71413 | |
|
not playing cards
Join Date: Sep 2014
Drives: a 13 e8h frs
Location: vantucky, wa
Posts: 32,392
Thanks: 53,053
Thanked 37,228 Times in 19,308 Posts
Mentioned: 1118 Post(s)
|
Quote:
__________________
|
|
|
|
| The Following User Says Thank You to Ultramaroon For This Useful Post: | Spuds (07-11-2020) |
|
07-11-2020, 12:54 AM
|
#71414 | |
|
ProCrastinationConsultant
Join Date: Sep 2013
Drives: '14 Ranger, '18 Tacoma 4Dr LB
Location: chicago-ish
Posts: 11,327
Thanks: 35,240
Thanked 13,676 Times in 6,782 Posts
Mentioned: 98 Post(s)
|
Quote:
__________________
"The time you enjoy wasting is not wasted time"
 |
|
|
|
| The Following User Says Thank You to soundman98 For This Useful Post: | Spuds (07-11-2020) |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Language Rant Part Deux | MuseChaser | Off-Topic Lounge [WARNING: NO POLITICS] | 43 | 04-23-2017 07:55 PM |
| Random thoughts thread | MrVito | Off-Topic Lounge [WARNING: NO POLITICS] | 37188 | 02-25-2016 10:00 AM |
| Random Rubber Part | OoLong | BRZ First-Gen (2012+) — General Topics | 8 | 01-28-2014 10:31 AM |
| Crew Carshow : Part Deux 9/7/13 | saiyajinimports | Great Lakes | 0 | 08-17-2013 05:18 AM |
