Welding an Exhaust Cutout

[8RZ]

Originally Posted by humfrz

So, I'll be 75 next month

You're younger than I thought.

[humfrz]

Originally Posted by 8RZ

You're younger than I thought.

OMG ........

Do I sound THAT old .......


humfrz

[BirdTRD]

Originally Posted by Asian

I've been wanting to install an exhaust cutout to control how loud my car can be. I've run into a problem where my HKS front pipe is 60mm or 2.36in in diameter and the exhaust cutout diameter of the pipe comes in at either 2.25in or 2.5in. Could an exhaust shop be able to weld the cutout to my front pipe? Or would it be a better idea just to sell and get a 2.5in front pipe? Thanks

I had a QTP cutout installed when I did 2.5 inch from the overpipe back. The shop had a hard time finding a good spot to put it, they ended up right where the gap between the floor pan and gas tank are so they had a place for the motor to sit up out of the way.

[2slo4u]

My kit came with a 2.5 Y pipe. I have it installed on my front pipe before the resonator. It does hang a little low though so speed bumps may not be your friends now if your car is lowered.