|
||||||
| Engine, Exhaust, Transmission Discuss the FR-S | 86 | BRZ engine, exhaust and drivetrain. |
 |
|
|
Thread Tools | Search this Thread |
09-28-2016, 10:38 AM
|
#15 |
|
Senior Member
Join Date: Jun 2016
Drives: 2016 FR-S MT, 2015 Scion FR-S AT,
Location: SW Fl
Posts: 487
Thanks: 271
Thanked 307 Times in 180 Posts
Mentioned: 3 Post(s)
|
When I installed my Borla exhaust, the center resonator was just a couple mm from making contact with the tunnel. I ended up having to loosen and shift the last stock part before theBorla parts (over-pipe I think) to gain enough clearance. I am almost sure it would have vibrated otherwise.
*and there was nothing in the instructions or online video's I watched that mentioned needing to touch that part at all.* I was almost ready to go Bubba on the spot until I found all that slack available to adjust upstream. |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OFT stg 2 UEL 91 vs 93 - noticeable difference? | alanhung85 | Software Tuning | 2 | 10-22-2014 09:48 AM |
| DIY: Installing Pioneer AVIC Z150BH Aftermarket Head Unit | tiz22 | DIY (Do-It-Yourself) Guides | 35 | 07-24-2014 07:03 PM |
| How do you keep cruise control after installing a aftermarket hub and steering wheel? | Timtamtt | Cosmetic Modification (Interior/Exterior/Lighting) | 1 | 11-30-2013 07:17 AM |
| BEWARE when installing aftermarket tail lights, you must seal the area ! | Kayzer Soze | Cosmetic Modification (Interior/Exterior/Lighting) | 5 | 08-27-2013 01:52 PM |
| Installing TRD Parts / Locating a good shop | Re~Mix | Engine, Exhaust, Transmission | 9 | 06-12-2012 12:05 PM |
