Bride Seats

[diegoei]

Originally Posted by 8R6

super easy and no tools needed. just plug each end into the socket and done. we taped ours up to keep it covered and then ziptied it under the seat so it doesnt move around.

So i just went to Radio Shack and bought some, are these it? They had 1/2 watt and 1/4 watt which are the ones i bought.

[8R6]

Originally Posted by diegoei

So i just went to Radio Shack and bought some, are these it? They had 1/2 watt and 1/4 watt which are the ones i bought.

looks like it. i just checked and mine are 1 watt. not sure if that makes a difference for this use though. i just bent the wires (not sharply) and stuck each end into the socket. you should know immediately after you turn on the car and the airbag light turns off or not.

[Anal0g]

Originally Posted by diegoei

So i just went to Radio Shack and bought some, are these it? They had 1/2 watt and 1/4 watt which are the ones i bought.

You need 3.3 ohm and not 3.3k.

[diegoei]

Originally Posted by Anal0g

You need 3.3 ohm and not 3.3k.

This are 3.3 ohm look next to the numbers

[Chronology]

Originally Posted by diegoei

This are 3.3 ohm look next to the numbers

Per another site - http://www.clubwrx.net/forums/interi...resistors.html

3.3 ohm is WAY different then 3.3k(3300) ohm.

[dito]

Originally Posted by Chronology

Per another site - http://www.clubwrx.net/forums/interi...resistors.html

3.3 ohm is WAY different then 3.3k(3300) ohm.

yeah hes right. i believe the 3.3k ohm are different than the 3.3 ohm. i also double checked this too when i did my seat. the resistor i got was from Orvac Electronics in Fullerton