WHAT DID YOU DO TO YOUR BRZ TODAY? - Page 1048 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Blue-Sensei · 08-28-2016, 01:42 PM

Installed TOMs tails, and valenti rear/reverse light.

Also I realize that the left exhaust is a little bit lower...need to go mess with that rubber grommet.

Bowen · 08-29-2016, 09:52 AM

Quote:

Originally Posted by Blue-Sensei

Installed TOMs tails, and valenti rear/reverse light.

Also I realize that the left exhaust is a little bit lower...need to go mess with that rubber grommet.

I knew that valenti 3rd brake light would look good with the red TOMs.

Gonna have to buy one soon

Blue-Sensei · 08-29-2016, 03:36 PM

Quote:

Originally Posted by Bowen

I knew that valenti 3rd brake light would look good with the red TOMs.

Gonna have to buy one soon

If you're wiring to toms, the red wire from the valenti matches to the red on the toms, and the blue matches to the black, with white stripe(on the toms).

kev60625 · 08-29-2016, 05:12 PM

Quote:

Originally Posted by Blue-Sensei

If you're wiring to toms, the red wire from the valenti matches to the red on the toms, and the blue matches to the black, with white stripe(on the toms).

Did you open the valenti light up and re-wire it?

I tried to open it up and re-wire/solder it, then once I connected it with the taps it didn't light up at all

. Think I ruined it

Drakiv · 08-29-2016, 07:52 PM

Installed my Carbon Fiber Driveshaft and swapped over to Neo Synthetic RHD gear oil in the transmission with the new PAR gear set. Also got around to making a small video of 1st thru 6th gear pull with the new gear set.

[ame="https://www.youtube.com/watch?v=eeggjO0Wf6g"]Par gearset 1st thru 6th pull in a BRZ - YouTube[/ame]

mrhemi · 08-29-2016, 10:05 PM

Changed all the slippery fluids and installed a Dezod cat back exhaust.

BRZtoni · 08-29-2016, 10:14 PM

getting ready to send to paint

BRZtoni · 08-29-2016, 10:21 PM

Quote:

Originally Posted by Drakiv

Installed my Carbon Fiber Driveshaft and swapped over to Neo Synthetic RHD gear oil in the transmission with the new PAR gear set. Also got around to making a small video of 1st thru 6th gear pull with the new gear set.

your rich

funwheeldrive · 08-29-2016, 10:30 PM

Quote:

Originally Posted by Drakiv

Installed my Carbon Fiber Driveshaft and swapped over to Neo Synthetic RHD gear oil in the transmission with the new PAR gear set. Also got around to making a small video of 1st thru 6th gear pull with the new gear set.

Impressions on the carbon fiber drive shaft?

Drakiv · 08-29-2016, 11:52 PM

Quote:

Originally Posted by BRZtoni

your rich

I wish, I just have different set of priorities and a situation that allows me to spend more money than usual on my car.

Quote:

Originally Posted by funwheeldrive

Impressions on the carbon fiber drive shaft?

I like it, it's hard to give a real review other than it works right now due to being at stock power levels and also doing it after I also changed my transmissions gearing along with a solid transmission mount and billet clutch fork. Everything I have done has completely changed the way the car feels when driving it, but with it all being done it's a completely different car, and in my opinion a much more enjoyable driving experience from an enthusiast standpoint.

kch · 08-30-2016, 02:26 PM

Quote:

Originally Posted by Drakiv

Also got around to making a small video of 1st thru 6th gear pull with the new gear set.

goddang that's a lot of gear whine. sounds like a real racecar now.

Figo · 08-30-2016, 04:12 PM

.

Removed the Cusco tower bar, and install this new 86 waterproof trunk liner.

Daily Drive Mode.

.

DocWalt · 08-30-2016, 04:20 PM

That liner is legit!

JPxM0Dz · 08-30-2016, 04:36 PM

08-29-2016, 10:14 PM	#14665
BRZtoni Turbo E85 Join Date: Sep 2013 Drives: 13 wrb brz Location: torrance, ca Posts: 1,093 Thanks: 172 Thanked 555 Times in 349 Posts Mentioned: 32 Post(s) Tagged: 0 Thread(s)	getting ready to send to paint __________________ Flex Fuel Turbo BRZ

08-30-2016, 04:12 PM	#14670
Figo Senior Member Join Date: Jun 2013 Drives: Vortech Supercharged FR-S Location: Central Jersey Posts: 1,515 Thanks: 597 Thanked 934 Times in 428 Posts Mentioned: 17 Post(s) Tagged: 1 Thread(s)	. Removed the Cusco tower bar, and install this new 86 waterproof trunk liner. Daily Drive Mode. . __________________ I'd rather lose by a mile because I built my own car, than win by an inch because someone else built it for me. Your car is your story, so don't let someone else write the book. ( White Tiger ) - FiGo's 車誌. Last edited by Figo; 08-30-2016 at 09:28 PM.

08-30-2016, 04:20 PM	#14671
DocWalt Senior Member Join Date: Oct 2013 Drives: '22 BRZ Location: PA Posts: 1,949 Thanks: 2,428 Thanked 1,673 Times in 845 Posts Mentioned: 25 Post(s) Tagged: 2 Thread(s)	That liner is legit! __________________ - Ken. H DocWalt's WRB 2013 BRZ Build Thread \| DocWalt's 2022 WRB BRZ Build Thread

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Saw My First FR-S Today	Marrk	Scion FR-S / Toyota 86 GT86 General Forum	26	05-15-2013 01:40 PM
Got my new FR-S today.	Boosted2.0	Scion FR-S / Toyota 86 GT86 General Forum	51	06-03-2012 11:35 PM
Sat in a FRS today!!	Ladnerd	Scion FR-S / Toyota 86 GT86 General Forum	12	04-30-2012 02:48 PM
Got my VIN today...	Enemies	BRZ First-Gen (2012+) — General Topics	63	04-12-2012 11:19 PM
sat in a BRZ today	NESW20	BRZ First-Gen (2012+) — General Topics	8	03-31-2012 09:53 AM

08-29-2016, 10:05 PM	#14664
mrhemi Member Join Date: Oct 2013 Drives: BRZ Location: Ontario Posts: 47 Thanks: 2 Thanked 23 Times in 15 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Changed all the slippery fluids and installed a Dezod cat back exhaust.

User Name		Remember Me?
Password