|
||||||
| Engine, Exhaust, Transmission Discuss the FR-S | 86 | BRZ engine, exhaust and drivetrain. |
![]() |
|
|
Thread Tools | Search this Thread |
|
|
#29 |
|
Member
Join Date: Jul 2014
Drives: 2014 FR-S Silver
Location: Lynden, WA
Posts: 56
Thanks: 1
Thanked 12 Times in 10 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
So I had a mechanic from the shop that installed the clutch take a ride with me today. Of course at first I could not get the car to buck at all. No matter what rpm or throttle position clutch let off. finally after about 7 stop signs it did it about half as bad as this past weekend. His eyes got wide open and he had a confused look. I was then able to recreate it about 5 times, but of course less severe than it has been. He then said there were 2 things I could do....
1) Contact Competition clutch and try to get them to warranty it out and he would talk to the shop manager about discounted services to have it R&R'd 2) Its an aggressive clutch, drive it aggressively and see how that affects it. |
|
|
|
|
|
#30 |
|
Off Topic
Join Date: Feb 2014
Drives: 2014 Subaru BRZ Limited
Location: Vegas, baby!
Posts: 4,610
Thanks: 2,369
Thanked 4,243 Times in 2,170 Posts
Mentioned: 43 Post(s)
Tagged: 3 Thread(s)
|
Both of which are fine options, but what if they installed it wrong? I doubt Competition Clutch is going to warranty it without it being taken off and sent to them for inspection first.
|
|
|
|
| The Following User Says Thank You to gramicci101 For This Useful Post: | FRS Justin (07-12-2016) |
|
|
#31 |
|
Senior Member
Join Date: May 2014
Drives: 2013 Asphalt FRS
Location: San Antonio
Posts: 994
Thanks: 693
Thanked 695 Times in 417 Posts
Mentioned: 22 Post(s)
Tagged: 1 Thread(s)
|
ok I just looked up your stg3 disc. and that is your problem the hotter it gets the stickier it is. Its a ceramic disc if I were you I would by a stg 2 disc and slap it in there and it should fix your problem. Or just beat on the ceramic one.
__________________
Instagram FT86PROJECT9S
Facebook FT86PROJECT9S 710whp |
|
|
|
|
|
#32 |
|
Member
Join Date: Jul 2014
Drives: 2014 FR-S Silver
Location: Lynden, WA
Posts: 56
Thanks: 1
Thanked 12 Times in 10 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
I agree that they wont do a thing without it being removed. I am going to drive it harder and see what happens, then go from there
|
|
|
|
|
|
#33 |
|
Member
Join Date: Jul 2014
Drives: 2014 FR-S Silver
Location: Lynden, WA
Posts: 56
Thanks: 1
Thanked 12 Times in 10 Posts
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
|
Thanks! I will look into that. I am going to try and drive it harder this week and see how that goes
|
|
|
|
| The Following User Says Thank You to Scikotic For This Useful Post: | FRS Justin (07-12-2016) |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ISSUE: 1900-2000 RPM Shutter/Shaking (Free load) | Neurytic | Issues | Warranty | Recalls / TSB | 29 | 11-22-2020 10:19 PM |
| 2-3K RPM hesitation/bucking - logged | 86fun | Software Tuning | 5 | 01-29-2016 08:58 AM |
| loss of power/ bucking in rain | fasteddy | Issues | Warranty | Recalls / TSB | 30 | 10-20-2015 02:08 AM |
| DIY CLUTCH INSTALL .. | charged86 | DIY (Do-It-Yourself) Guides | 3 | 09-13-2013 12:10 PM |
| HELP...Drive Shaft/Rear Tire Shutter | UM FRS | Issues | Warranty | Recalls / TSB | 11 | 09-05-2012 11:14 AM |