My Shift Knob. Post yours too

[Cartman]

Originally Posted by ShaneLindley

Is that an option with Sickspeed? The knob will accommodate the lockout ring? Sounds great.

Mine's a Speeddawg shift knob... don't know about sickspeed.

I combined the shift knob with a blox lockout cover since the lockout opening on the speeddawg knob is huge.

Here's how it looks

[Tonypepatone]

Here is mine I like this one much better than stock.

Sent from my Nexus 6 using Tapatalk

[PNW-BRZ]

Raceng Ashiko knob. Still a little warm on the left from where my thumb was.

[Monkey_Boy]

It took a while to get here from the Group buy, but this is my Anarchy Motive Mammoth in WRB with my own design on the shift pattern. I have gunmetal grey rims and am a bit of a KC Royals fan.

[Cybmx]

Originally Posted by Cartman

Speed Dawg Rally Shift Knob

OMG this is sooooo awesome. Could you post a link to buy this? I think it will work great with my Hyperblue BRZ.


Thanks a ton

[Cybmx]

Btw, how do you keep the knob center while screwing it in?

[WhiteFRS69]

Originally Posted by Tonypepatone

Here is mine I like this one much better than stock.

Sent from my Nexus 6 using Tapatalk

which one is this???

[Cartman]

Originally Posted by Cybmx

OMG this is sooooo awesome. Could you post a link to buy this? I think it will work great with my Hyperblue BRZ.


Thanks a ton

http://www.speeddawg.com/

I bought it with the Mustang/focus reverse lockout recess, and used a blox lockout cover as a jam nut to fill in the recessed hole since it much larger than our lockout.

[Tonypepatone]

Originally Posted by WhiteFRS69

which one is this???

It's made by carbing. Ordered it from rallysportdirect they come in aluminum and delrin. I went with aluminum.

Sent from my Nexus 6 using Tapatalk

[Monkey_Boy]

Originally Posted by Cybmx

Btw, how do you keep the knob center while screwing it in?

1/2 of a cotton ball tucked in the hole before you start screwing it down will allow you to adjust until you get it tightened and centered to your liking.

[BigFatFlip]

Originally Posted by Cybmx

Btw, how do you keep the knob center while screwing it in?

I used a little bit of vibra-tite ("soft"/light thread locker) on the threads, screw it all the way down then back it up until centered, allow to set, done!

[MadtownFRS]

Sent from my iPhone using Tapatalk

[Kris86]

Originally Posted by Cappuccino

Running a TRD shift knob that I had in my IS200 lighter then the standard one so its easier to feel the gears and it feels great in my hand!

did you have to do any modification to install? also where can I get this shift knob?

[weederr33]

Originally Posted by Monkey_Boy

1/2 of a cotton ball tucked in the hole before you start screwing it down will allow you to adjust until you get it tightened and centered to your liking.

I'm going to try this for my Flossy knob. My TRD fits fine, but the Flossy is always off.