Coilover alignment specs on stock parts

[Rifle]

Hi all,

Just got a set of Tein Coils and dropped it a good amount, (1 finger gap all the way around).

Just wanted to post the final alignment specs on stock parts (lowers/bolts/etc), nothing changed except the coilovers.



Here's how it sits, for reference:

[8R6]

which ones did you get? no adjustable top hats? almost no camber in front, but an avg of -2.5 in rear is an odd setup. i'd recommend at the very minimum, get some camber bolts to dial in a little more negative camber up front (probably bring you to around -1 to -1.5ish). then you can save up for either adj tophats for the front later and/or adj rear LCA's and bring in the rear camber back to like -2 or so.

[keb86]

Originally Posted by Rifle

Hi all,

Just got a set of Tein Coils and dropped it a good amount, (1 finger gap all the way around).

Just wanted to post the final alignment specs on stock parts (lowers/bolts/etc), nothing changed except the coilovers.

looks like even no LCA in the rear with that drop, it will be ok.

Wheel specs?

[Rifle]

Originally Posted by 8R6

which ones did you get? no adjustable top hats? almost no camber in front, but an avg of -2.5 in rear is an odd setup. i'd recommend at the very minimum, get some camber bolts to dial in a little more negative camber up front (probably bring you to around -1 to -1.5ish). then you can save up for either adj tophats for the front later and/or adj rear LCA's and bring in the rear camber back to like -2 or so.

Down the road I'll probably get bolts and lowers but it's not a huge deal to me as I'm not tracking. It's a set of Tein street basis. Use OEM top hats.


As far as wheel setup,
17x9 + 35 w/ 255/40/17