Strange Smells After Header Install - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

megamarines · 07-04-2015, 08:18 AM

Hey guys, last week I purchased a slightly worn RevWorks UEL header and installed it the next day. It had no dings or cracks, and just had the classic coloring of being used for a few thousand miles. Got an O2 spacer on it as well.

Installed it the next morning, did a double gasket attachment to the over pipe, and torqued everything correctly. It's currently attached to an Invidia OP, resonated Front Pipe, and N1 exhaust. Now, this is my first header, but I don't think it's supposed to leave a smell every time I turn off the car and get out. It simply smells like gasoline fumes/fuel or at least have an aura of that smell around the car. Next is when I sometimes step on the gas it's fine, but when I come down from it the inside smells a little bit like a burnt fuel or metallic-ish smell; almost carbon heavy.

I'm not sure what's going on, but it's beginning to concern me. It doesn't seem to be getting worse but it does smell bad.

Any ideas? I honestly don't think it's a gasket leak, but I'll be replacing all of them with the Grimmspeed set within the month.

swarb · 07-04-2015, 08:46 AM

Do you have any cat's left? Zero cats would make that smell, but it would usually be towards the back of the car.
Sounds like an exhaust leak to me. Did you use new gaskets?
Oils in your hand from the install could cause a smell too, but for me it went away after two heat cycles.
OEM gaskets are good too.

Chad11491 · 07-04-2015, 08:49 AM

Quote:

Originally Posted by swarb

Do you have any cat's left? Zero cats would make that smell, but it would usually be towards the back of the car.
Sounds like an exhaust leak to me. Did you use new gaskets?
Oils in your hand from the install could cause a smell too, but for me it went away after two heat cycles.
OEM gaskets are good too.

Yup, if it's catless it will smell like that, which is what I bet the problem is.

megamarines · 07-04-2015, 09:05 AM

With zero cats is it really that prevalent? Seems like it would be less extreme. Either way, I can deal with forever, but I wonder how much it'll go away with the gasket change.

Qadthane · 07-04-2015, 11:41 AM

Quote:

Originally Posted by megamarines

With zero cats is it really that prevalent?

Yep, It will be stinky.

Quote:

Originally Posted by megamarines

...but I wonder how much it'll go away with the gasket change.

None. Unless there really is an exhaust leak, but I bet it's from being catless.

megamarines · 07-04-2015, 04:28 PM

Quote:

Originally Posted by Qadthane

Yep, It will be stinky.

None. Unless there really is an exhaust leak, but I bet it's from being catless.

Well shit, okay then. Thanks for the help.

Qadthane · 07-04-2015, 04:36 PM

I was behind an older Camaro the other day and reminded of how it can smell.

07-04-2015, 08:18 AM	#1
megamarines Senior Member Join Date: Aug 2014 Drives: 2015 FR-S RS 1.0 Location: Walnut Creek, CA Posts: 368 Thanks: 144 Thanked 177 Times in 91 Posts Mentioned: 29 Post(s) Tagged: 2 Thread(s)	Strange Smells After Header Install Hey guys, last week I purchased a slightly worn RevWorks UEL header and installed it the next day. It had no dings or cracks, and just had the classic coloring of being used for a few thousand miles. Got an O2 spacer on it as well. Installed it the next morning, did a double gasket attachment to the over pipe, and torqued everything correctly. It's currently attached to an Invidia OP, resonated Front Pipe, and N1 exhaust. Now, this is my first header, but I don't think it's supposed to leave a smell every time I turn off the car and get out. It simply smells like gasoline fumes/fuel or at least have an aura of that smell around the car. Next is when I sometimes step on the gas it's fine, but when I come down from it the inside smells a little bit like a burnt fuel or metallic-ish smell; almost carbon heavy. I'm not sure what's going on, but it's beginning to concern me. It doesn't seem to be getting worse but it does smell bad. Any ideas? I honestly don't think it's a gasket leak, but I'll be replacing all of them with the Grimmspeed set within the month.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
no cel after catless header install	vestal52	Engine, Exhaust, Transmission	14	05-22-2014 03:21 AM
Header Install in NEPA?	Optimus Prime	NY / NJ / CT / PA	2	03-26-2014 07:00 PM
Header install in Toronto	CreinCrein	CANADA	14	01-26-2014 11:03 PM
How much to install header/OP/down pipe?	Boofneenee	DIY (Do-It-Yourself) Guides	7	09-24-2013 05:10 PM
strange coilover install noises/ tried everything	NemeGuero	Suspension \| Chassis \| Brakes -- Sponsored by 949 Racing	16	02-27-2013 12:02 AM

07-04-2015, 08:46 AM	#2
swarb Senior Member Join Date: Sep 2014 Drives: BRZ Location: Los Angeles Posts: 3,052 Thanks: 1,773 Thanked 2,451 Times in 1,271 Posts Mentioned: 79 Post(s) Tagged: 0 Thread(s)	Do you have any cat's left? Zero cats would make that smell, but it would usually be towards the back of the car. Sounds like an exhaust leak to me. Did you use new gaskets? Oils in your hand from the install could cause a smell too, but for me it went away after two heat cycles. OEM gaskets are good too.

07-04-2015, 09:05 AM	#4
megamarines Senior Member Join Date: Aug 2014 Drives: 2015 FR-S RS 1.0 Location: Walnut Creek, CA Posts: 368 Thanks: 144 Thanked 177 Times in 91 Posts Mentioned: 29 Post(s) Tagged: 2 Thread(s)	With zero cats is it really that prevalent? Seems like it would be less extreme. Either way, I can deal with forever, but I wonder how much it'll go away with the gasket change.

07-04-2015, 04:36 PM	#7
Qadthane Member Join Date: Jan 2014 Drives: 2013 FR-S in Asphalt Location: Southern Maryland Posts: 69 Thanks: 166 Thanked 50 Times in 28 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	I was behind an older Camaro the other day and reminded of how it can smell.

User Name		Remember Me?
Password