Wheel Directory: XXR 527 18x9.75 +20

[Charky]

Originally Posted by DarrenDriven

Already asked and answered.

Its true my bad

[kombatlion]

NIce setupppp Like a lot!

[kombatlion]

Mi set up!

[bhbnuckle]

Hello Guy and Gals

as title says will it fit on FR-S?

my car is lowered by Eibach Pro with stock shock and strut.

will it rub my fender?

Please advice..

Thank you!

[GaN-MaN]

There is an entire 82 page thread on the XXR 527/530 and i can bet Bob's your uncle that you will find if it fits in there...

Before you ask again, yes people are running 18x9.75 +20...

http://www.ft86club.com/forums/showthread.php?t=18661

[Celigts]

Just attemted 235/40/18 on xxr 18x9.75+20 with skunk2 coilovers with 10k springs replaced all around...Max camber front...and hits fender on max drop. Rear hits fender...I'm thinking i shoulda went 225/40/18...

[DarrenDriven]

Yeah, my setup with the 225/40/18s only rubs slightly when I enter a steep driveway at an angle and loads a wheel, or at 50MPH+ freeway on-ramps. You could always raise it up 1/2" and see if that helps... but that defeats the purpose, haha.

[Albaro08]

Originally Posted by DarrenDriven

Yeah, my setup with the 225/40/18s only rubs slightly when I enter a steep driveway at an angle and loads a wheel, or at 50MPH+ freeway on-ramps. You could always raise it up 1/2" and see if that helps... but that defeats the purpose, haha.

I like your set up but would going 18x9.75 40 make the wheel go into the fender more or out and I would like to go with meaty tires??? But still have the concave look

Sent from my D6616 using Tapatalk

[Timmy_Jones]

Originally Posted by Albaro08

I like your set up but would going 18x9.75 40 make the wheel go into the fender more or out and I would like to go with meaty tires??? But still have the concave look

Sent from my D6616 using Tapatalk

You are correct, but I think these wheels are limited in offset. XXR only makes the 9.75 in a +20. The more narrow wheel can be had on like a +35, better suited to fitting the car.

[Albaro08]

So you don't recommend going this size or find something else I want to go 235/55/18 on wheels

Sent from my D6616 using Tapatalk

[Leonardo]

Originally Posted by Albaro08

So you don't recommend going this size or find something else I want to go 235/55/18 on wheels

Sent from my D6616 using Tapatalk

That's way too big. It will never fit. 235/40/18. Or 225/40/18. I've seen 225/35/18 too.

[alvinrenz]

I am planning to go with these set up with BC Coilover extreme drop. wrapped with 225/40


My question is, Will it rub on the lowest settings? if yes can i lift it a notch?

do I get a better fitment if i go 18x8.75 in the front or i should be fine in squared 9.75?

thanks for the help. This will be my first coilover and wheel fitment.

I am aiming similar to this

[jkrlox]

Did you find your answer? Would it fit better to combine 8.75 +35 and 9.75 +20 than square 9.75?

Originally Posted by alvinrenz

I am planning to go with these set up with BC Coilover extreme drop. wrapped with 225/40


My question is, Will it rub on the lowest settings? if yes can i lift it a notch?

do I get a better fitment if i go 18x8.75 in the front or i should be fine in squared 9.75?

thanks for the help. This will be my first coilover and wheel fitment.

I am aiming similar to this

[swarb]

Originally Posted by jkrlox

Did you find your answer? Would it fit better to combine 8.75 +35 and 9.75 +20 than square 9.75?

You just bumped an old thread.
8.75 +35 for wider tires and minimal camber.
9.75 +20 for 225/40 or smaller and 4-5+++ camber.