|
||||||
| Scion FR-S / Toyota 86 GT86 General Forum The place to start for the Scion FR-S / Toyota 86 | GT86 |
![]() |
|
|
Thread Tools | Search this Thread |
|
|
#1 |
|
I don't lie.
Join Date: Aug 2012
Drives: AE86 Successor
Location: Canada
Posts: 380
Thanks: 290
Thanked 44 Times in 34 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Install rear armrest
Hey guys here's a tutorial I made on my phone on how to install rear seat armrest
and it wouldn't be possible without the super responsive help (by the minute) from user @OICU812! THANK YOU! Step 1-4: remove latch on rear seat (both sides), push seat down from bottom center and lift up Step 5: lift up plastic sleeve/sheet on center panel/console to reveal screws to unscrew Step 6: this will allow you to lift up and have enough room to remove two plugs that keeps the old armrest felt Step 7-8: use step 7 finger technique to put plug back after installing new pvc armrest Step 8: this technique can complement step 7 as your finger will fit in the hole to help feed and put the plug in the hole Step 9: voila you are almost done just pop the seats back in there is a hook where the seat will hook into, slide downwards and slide up to hook into place
__________________
I'll get a Mustang for way less if I wanted more power.
Last edited by SPEEDGOD; 07-15-2014 at 12:32 PM. Reason: Thanking OICU812 |
|
|
|
|
|
#2 |
|
Join Date: Mar 2013
Drives: 2013 Firestorm FRS
Location: Lake Elsinore, CA
Posts: 2,707
Thanks: 1,231
Thanked 2,144 Times in 1,003 Posts
Mentioned: 73 Post(s)
Tagged: 2 Thread(s)
|
lots of "finger" techniques described in there.
Looks good though, didn't even realize there was a rear arm rest available |
|
|
|
|
|
#3 |
|
Just a dude
Join Date: Mar 2013
Drives: Scion FR-S 2013
Location: Edson, Alberta, Canada
Posts: 3,289
Thanks: 1,185
Thanked 1,188 Times in 852 Posts
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
|
Glad you got it sorted man, it's subtle but a nice piece. I'd suggest getting a mod to move thread to the DIY section to help future peeps.
__________________
|
|
|
|
| The Following User Says Thank You to OICU812 For This Useful Post: | SPEEDGOD (07-15-2014) |
|
|
#4 |
|
Senior Member
Join Date: Feb 2014
Drives: 2014 BRZ Limited, 2013 Focus ST
Location: C-Bus, OH
Posts: 120
Thanks: 118
Thanked 74 Times in 35 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
I'm sure those sitting in that back will be very thankful that they have a place to put their elbows, even if there's no place for their lower extremities, lol.
|
|
|
|
|
|
#6 |
|
I don't lie.
Join Date: Aug 2012
Drives: AE86 Successor
Location: Canada
Posts: 380
Thanks: 290
Thanked 44 Times in 34 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Thanks man! You definitely helped so much and made this post possible.
__________________
I'll get a Mustang for way less if I wanted more power.
|
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is there a guide to install oem armrest? | Frs32907 | Cosmetic Modification (Interior/Exterior/Lighting) | 3 | 04-12-2014 12:06 AM |
| Rear Armrest install | Vides990 | Cosmetic Modification (Interior/Exterior/Lighting) | 8 | 03-09-2014 01:40 AM |
| Requesting Part Numbers for: '14 FR-S Knee Pads, Front Speaker Covers, Rear Armrest | jbsali | Cosmetic Modification (Interior/Exterior/Lighting) | 1 | 02-26-2014 07:22 AM |
| jdm armrest install, help | jdubious | Cosmetic Modification (Interior/Exterior/Lighting) | 4 | 12-11-2013 02:34 AM |
| Rear toe out after LCA install | midnight23 | Suspension | Chassis | Brakes -- Sponsored by 949 Racing | 3 | 09-01-2013 06:46 PM |