Do you warm up the car every morning b4 driving? - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

qqzj · 04-15-2014, 12:43 AM

I now wait till the rpm drops to about 1000 b4 driving. After I start driving, I try very hard to keep the rpm below 2500 until the water temperature is normal. Then I drive with WOT. Making this so complicated just to be gentle to my engine. I have a manual BTW.

Question is whether this is good or bad or simply does not matter? Some people start with 3000/4000 will warm up the cat quickly which is good to cat. I am quite confused. Any good theory out there?

phuthinhon · 04-15-2014, 01:06 AM

i always wait until the rpm drops to about 1k before I drive.

dbrandt01 · 04-15-2014, 01:11 AM

I start it and let it run til it drops in RPMs after 30 seconds or so, then just take it easy for a couple minutes going out of the subdivision because there is no reason to drive hard or fast through there. I've always done it this way even in my truck i used to have. Just habit I guess

SixthElement · 04-15-2014, 01:43 AM

I'm with dbrandt01. That's what i've always done. The biggest thing for the motor is to let the oil get to operating temp that way it is at the viscosity that the engine was designed to perform at before driving it hard.

hmong337 · 04-15-2014, 01:56 AM

I wait till the rpms drop then I go. I keep things under 4000 rpm when the engine is not fully warmed up. Try to shift under 3500 mostly.

mav1178 · 04-15-2014, 02:08 AM

http://www.ft86club.com/forums/showthread.php?t=62756

Ganthrithor · 04-15-2014, 06:31 AM

I usually wait for the idle to drop, then keep things under 3500 rpm until the water jacket gets up to its normal operating temp. It usually takes five or ten minutes for that to happen and for the transmission to start feeling warmed up.

I wish the car had an oil temp gauge.

housecat · 04-15-2014, 06:44 AM

I put on no gas until revs drop. That is very important so oil gets through the system. When temp needle is below cold, I give some constant 2k to 3k rpm until temp needle is actually pointing not 'negative' ie "off the charts" to the left. Without doing this, my brz will not shift into 2nd gear if it is cold outside.

BRZZZZZZZZZZ · 04-15-2014, 10:46 AM

No warm-up unless its below 0 Celsius, but I drive like a grandpa for the first 10+km no matter what to get all the fluids up to temp.

tahdizzle · 04-15-2014, 11:59 AM

I don't let it warm up, but I don't drive it hard in the morning.

Also the car hardly ever sees anything below 50 degrees anyway.

Turbowned · 04-15-2014, 12:03 PM

What everyone else said, basically.

BRZfan · 04-15-2014, 12:07 PM

When cold, I don't necessarily wait to get the car moving. I believe some load on the engine, even when cold, is better for the engine because it increase the (oil) pressure. However, I keep it under 25 MPH and moderate RPM in any gear until several clicks up on the H-2-O temp indicator.

I do not have a problem with entering second gear as some do.

Imrac · 04-15-2014, 12:18 PM

Quote:

Originally Posted by Ganthrithor

I usually wait for the idle to drop, then keep things under 3500 rpm until the water jacket gets up to its normal operating temp. It usually takes five or ten minutes for that to happen and for the transmission to start feeling warmed up.

I wish the car had an oil temp gauge.

[ame="http://www.amazon.com/ELM327-Bluetooth-Diagnostic-Scanner-Scantool/dp/B0051CAE1C"]Amazon.com: ELM327 Bluetooth OBDII OBD2 Diagnostic Scanner Can ELM 327 Scantool Check Engine Light Car Code Reader: Electronics[/ame] + Torque App = Oil temp gauge.

I usually don't warm up before moving as I am in a garage and exhaust is rather loud at 4:30AM in the morning for my neighbors, I try to scoot out quickly. (while keeping under 3k RPM)

wheelhaus · 04-15-2014, 12:28 PM

I begin moving almost immediately, but drive gently below 3k until the needle is above C. Then drive normal under 4k until temp has stabilized. No redline or WOT until I've been driving 10-20 minutes depending on ambient temps.

0w20 full synthetic flows easily below freezing, but I believe idling/running at cold temps should be kept as short as possible. I want to get it warmed up as quickly as possible.

04-15-2014, 12:43 AM	#1
qqzj Senior Member Join Date: Sep 2013 Drives: MDX, Camry Location: SF, CA Posts: 399 Thanks: 54 Thanked 69 Times in 44 Posts Mentioned: 3 Post(s) Tagged: 0 Thread(s)	Do you warm up the car every morning b4 driving? I now wait till the rpm drops to about 1000 b4 driving. After I start driving, I try very hard to keep the rpm below 2500 until the water temperature is normal. Then I drive with WOT. Making this so complicated just to be gentle to my engine. I have a manual BTW. Question is whether this is good or bad or simply does not matter? Some people start with 3000/4000 will warm up the cat quickly which is good to cat. I am quite confused. Any good theory out there?

04-15-2014, 01:56 AM	#5
hmong337 Emperor JDM Join Date: Jun 2013 Drives: '91 MR2 Gen3 3SGTE, '13 FRS Location: Onterrible, Canada Posts: 1,750 Thanks: 3,498 Thanked 909 Times in 495 Posts Mentioned: 20 Post(s) Tagged: 3 Thread(s)	I wait till the rpms drop then I go. I keep things under 4000 rpm when the engine is not fully warmed up. Try to shift under 3500 mostly. __________________

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Warm air from vents	blunova	Issues \| Warranty \| Recalls / TSB	131	10-06-2020 02:27 PM
Warm Up?	gt865	Scion FR-S / Toyota 86 GT86 General Forum	71	09-17-2014 12:28 PM
Ignition for Cat warm up	Toyota John	Software Tuning	8	04-16-2014 01:14 PM
How long do you warm up car before driving?	djmm	Scion FR-S / Toyota 86 GT86 General Forum	62	04-13-2014 03:34 AM
Warm up time	white_knight	Scion FR-S / Toyota 86 GT86 General Forum	47	03-14-2013 04:55 PM

04-15-2014, 01:06 AM	#2
phuthinhon Member Join Date: Mar 2014 Drives: 13 BRZ Location: Canada Posts: 76 Thanks: 26 Thanked 12 Times in 12 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	i always wait until the rpm drops to about 1k before I drive.

04-15-2014, 01:11 AM	#3
dbrandt01 Senior Member Join Date: Aug 2013 Drives: none Location: N/A Posts: 411 Thanks: 185 Thanked 229 Times in 140 Posts Mentioned: 16 Post(s) Tagged: 0 Thread(s)	I start it and let it run til it drops in RPMs after 30 seconds or so, then just take it easy for a couple minutes going out of the subdivision because there is no reason to drive hard or fast through there. I've always done it this way even in my truck i used to have. Just habit I guess

04-15-2014, 01:43 AM	#4
SixthElement Member Join Date: Jan 2014 Drives: 2013 black limited Location: Savannah, GA Posts: 32 Thanks: 4 Thanked 7 Times in 4 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	I'm with dbrandt01. That's what i've always done. The biggest thing for the motor is to let the oil get to operating temp that way it is at the viscosity that the engine was designed to perform at before driving it hard.

04-15-2014, 02:08 AM	#6
mav1178 Senior Member Join Date: Apr 2013 Drives: 2005 Toyota Camry Location: 91745 Posts: 6,562 Thanks: 493 Thanked 6,099 Times in 3,030 Posts Mentioned: 95 Post(s) Tagged: 3 Thread(s)	http://www.ft86club.com/forums/showthread.php?t=62756

04-15-2014, 06:31 AM	#7
Ganthrithor Senior Member Join Date: Feb 2013 Drives: '13 BRZ, '06 997, Other Things(TM) Location: Santa Barbara, CA Posts: 1,078 Thanks: 1,715 Thanked 670 Times in 351 Posts Mentioned: 9 Post(s) Tagged: 0 Thread(s)	I usually wait for the idle to drop, then keep things under 3500 rpm until the water jacket gets up to its normal operating temp. It usually takes five or ten minutes for that to happen and for the transmission to start feeling warmed up. I wish the car had an oil temp gauge.

04-15-2014, 10:46 AM	#9
BRZZZZZZZZZZ Car Nut Join Date: Dec 2013 Drives: BMW 335d, Toyota Echo RS, FRS Location: Calgary Posts: 1,557 Thanks: 368 Thanked 603 Times in 346 Posts Mentioned: 12 Post(s) Tagged: 2 Thread(s)	No warm-up unless its below 0 Celsius, but I drive like a grandpa for the first 10+km no matter what to get all the fluids up to temp.

04-15-2014, 12:07 PM	#12
BRZfan Senior Member Join Date: Oct 2012 Drives: 2013BRZ Premium St Silver Metallic Location: USA Posts: 824 Thanks: 79 Thanked 212 Times in 156 Posts Mentioned: 1 Post(s) Tagged: 1 Thread(s)	When cold, I don't necessarily wait to get the car moving. I believe some load on the engine, even when cold, is better for the engine because it increase the (oil) pressure. However, I keep it under 25 MPH and moderate RPM in any gear until several clicks up on the H-2-O temp indicator. I do not have a problem with entering second gear as some do.

04-15-2014, 12:28 PM	#14
wheelhaus Join Date: Jul 2012 Drives: 2013 BRZ, 2020 KTM Super Duke 1290R Location: Denver Posts: 1,788 Thanks: 714 Thanked 1,141 Times in 624 Posts Mentioned: 49 Post(s) Tagged: 1 Thread(s)	I begin moving almost immediately, but drive gently below 3k until the needle is above C. Then drive normal under 4k until temp has stabilized. No redline or WOT until I've been driving 10-20 minutes depending on ambient temps. 0w20 full synthetic flows easily below freezing, but I believe idling/running at cold temps should be kept as short as possible. I want to get it warmed up as quickly as possible.

User Name		Remember Me?
Password