FBM Intake Manifold Release

[Reaper]

Bump

Sent from my SAMSUNG-SGH-I747 using Tapatalk

[FullBlown]

No update yet. We had fitment problems that were addressed but havent gotten a chance to test it again.

Hopefully we can get back on it soon.

[mike the snake]

Will this manifold be made of aluminum? Any chance it could be made of plastic?

[FullBlown]

Sorry Mike, only aluminum

[kiichiro]

Where can i preorder one with meth ports?

[FAER]

Originally Posted by kiichiro

Where can i preorder one with meth ports?

^this

[mike the snake]

The meth system I have has only one injector and it's in front of the throttle body on the intake tube.

[AZFA20]

Originally Posted by mike the snake

The meth system I have has only one injector and it's in front of the throttle body on the intake tube.

When you get into some of the advanced meth injection systems you can do direct port injection. Aquamist is an example. Good thing about the cast aluminum intakes is that they are usually plenty thick enough for tapping for such application as DP meth, nitrous, sensors, whatever really without the need to weld in bungs.

[SmsAlSuwaidi]

Originally Posted by AZFA20

When you get into some of the advanced meth injection systems you can do direct port injection. Aquamist is an example. Good thing about the cast aluminum intakes is that they are usually plenty thick enough for tapping for such application as DP meth, nitrous, sensors, whatever really without the need to weld in bungs.

Hmmm 4 meth ports and 4 nos ports ... Damn


Sent from my IBrick

[Mathewgzlz]

So next Friday for results lol


Sent from my iPhone using Tapatalk

[mike the snake]

My Meth system is Hydramist, which is Aquamist but controlled by the Hydra ECU, not the Aquamist controller, so basically the same as Aquamist.

I think if I wanted to I could go with direct port, but as it is right now it seems to be working well.

Originally Posted by AZFA20

When you get into some of the advanced meth injection systems you can do direct port injection. Aquamist is an example. Good thing about the cast aluminum intakes is that they are usually plenty thick enough for tapping for such application as DP meth, nitrous, sensors, whatever really without the need to weld in bungs.

[AZFA20]

Originally Posted by mike the snake

My Meth system is Hydramist, which is Aquamist but controlled by the Hydra ECU, not the Aquamist controller, so basically the same as Aquamist.

I think if I wanted to I could go with direct port, but as it is right now it seems to be working well.

Yeah you can for sure retrofit any of them really to be DP but truthfully its not necessary on these manifolds. Some of the super long inline 6 intake manifolds benefit from it because the rear cylinders can starve a little but really the DP meth systems are not something you see very often at all. This cast manifold would just make it a little easier to do those types of things if one were to decide to down the road.

[Carlitoz3]

Originally Posted by FullBlown

Not much, a lot of it was added to the bottom.

Hopefully their won't be any fitting issues with the BPB.
Id really love to get this when it comes out!

[SmsAlSuwaidi]

Originally Posted by Carlitoz3

Hopefully their won't be any fitting issues with the BPB.
Id really love to get this when it comes out!

I dont see the use of it with bpb, but hey thats just me. I feel like u'll hit a point where that extra runner length might not add anything ( diminishing returns )


Sent from my IBrick