Frs with apr splitter

[FRSfan111]

Originally Posted by stockysnail

Not all but hopefully at least a couple at PIR. I want to try ORP at least once too as I've never been.

Nice, ill go to as many as work allows.

[stockysnail]

@FRSfan111 here are the pics so you can judge if the APR splitter is a possibility with my driveway.

[OjiGeorge]

What mounting points did you use for under the vehicle? I just received mine, but no instructions. I was curious how you lined up drill points, and what you secured it to. From my recollection underneath there is a liner attached with push-click fasteners which are probably too weak for this.

Also, did you remove the underliner all together, or trim it?

Cheers

[FRSfan111]

Originally Posted by OjiGeorge

What mounting points did you use for under the vehicle? I just received mine, but no instructions. I was curious how you lined up drill points, and what you secured it to. From my recollection underneath there is a liner attached with push-click fasteners which are probably too weak for this.

Also, did you remove the underliner all together, or trim it?

Cheers

I have to take pics. But I picked up these alen headed screws that have a clip that I put on/drilled through on the plastic underline that is part of the bumper. The factory rubber underliner is currently off my car. I could trim it and use it, but the splitter covers that entire area so I chose not too.

For install the quick and dirty way is set up against the bumper on the car. Find out how far u want it to stick out while clearing the space where the factory skid plate goes. (The splitter should just about butt up against the skid plate) then mark it with tap. This will take a few sets of hands. The remove bumper, clamp it together drill ur holes, install and profit.

[FRSfan111]

Originally Posted by stockysnail

@FRSfan111 here are the pics so you can judge if the APR splitter is a possibility with my driveway.
Attachment 65593
Attachment 65594
Attachment 65595
Attachment 65596

Would be really tight. But at max angle an slow you should clear it. But it would def be really close. The lip isn't thick but it sticks out about 2 inches or so on the side.