I can't even see if my pads are low. Worst brake design ever. - Page 14 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Dake · 11-16-2019, 11:39 AM

Back before cell phones with cameras, I drew a diagram of the rear drums on my Chevy Nova (the Toyota re-badged one) so I could get it back together.

JD001 · 11-16-2019, 12:10 PM

Quote:

Originally Posted by Dake

Back before cell phones with cameras, I drew a diagram of the rear drums on my Chevy Nova (the Toyota re-badged one) so I could get it back together.

Why would you draw a diagram of the rear drums on your Chevy Nova (even if it's a rebadged Toyota)?

ben721364 · 11-16-2019, 12:18 PM

Quote:

Originally Posted by GrantedTaken

This comment shows you don't understand the point of this conversation.

Since I may not be the only deplorable moron here, how bout explaining. TIA

Sapphireho · 11-16-2019, 12:22 PM

I really need to wash my rims.

JD001 · 11-16-2019, 12:30 PM

Quote:

Originally Posted by Sapphireho

I really need to wash my rims.

Must say that your disks are really shiny.. can almost see your brake pads...

Tcoat · 11-16-2019, 12:42 PM

DAMNIT.
Guys, yesterday I could see all my brake parts just fine but today I can't see anything at all. I can't even tell if I have rotors or calipers much less pads.
What can I do? PLEASE HELP!

JD001 · 11-16-2019, 12:50 PM

Quote:

Originally Posted by Tcoat

DAMNIT.
Guys, yesterday I could see all my brake parts just fine but today I can't see anything at all. I can't even tell if I have rotors or calipers much less pads.
What can I do? PLEASE HELP!

Just get some decent chrome wheel caps and all will look okay.

Tcoat · 11-16-2019, 01:07 PM

Quote:

Originally Posted by JD001

Just get some decent chrome wheel caps and all will look okay.

Will they let me see my brake parts? Do i mount them behind the wheels like mirrors?

You clearly do not have the intelligence to contribute to this conversation if you can't even answer my question. Just go back to your 50s moondisk fanboi stuff and leave this to the grown ups.

soundman98 · 11-16-2019, 01:10 PM

Quote:

Originally Posted by JD001

Why would you draw a diagram of the rear drums on your Chevy Nova (even if it's a rebadged Toyota)?

derail in 3, 2, 1....

so my rangers brake pedal started feeling 'off' about a month ago. tore down the rear drums, and figured out that the parking brake was seized half-applied, one piston was seized on one side, the other side was leaking. replaced the pistons, took pictures before tearing it down to make sure i could get it back together.

i get everything back together 100% of how the pictures i had were, but then the brake adjuster cables had 1/2" of slack, where it had all been tight.

it took 4 hours and calling my mechanic brother out to look at it to finally figure out that the half-moon cable guide piece the adjuster cable ran over had a notch that was 1/32" out of place, causing the slack.

drum brakes are evil.

JD001 · 11-16-2019, 01:13 PM

Quote:

Originally Posted by Tcoat

Will they let me see my brake parts? Do i mount them behind the wheels like mirrors?

You clearly do not have the intelligence to contribute ti this conversation if you can't even answer my question. Just go back to your 50s moondisk fanboi stuff and leave this to the grown ups.

I think you may have a point regards"intelligent" contribution. My simple thinking was based on shiny things always look good and impress.. as for checking the darn brake pads, how about the following?

JD001 · 11-16-2019, 01:15 PM

Quote:

Originally Posted by soundman98

derail in 3, 2, 1....

so my rangers brake pedal started feeling 'off' about a month ago. tore down the rear drums, and figured out that the parking brake was seized half-applied, one piston was seized on one side, the other side was leaking. replaced the pistons, took pictures before tearing it down to make sure i could get it back together.

i get everything back together 100% of how the pictures i had were, but then the brake adjuster cables had 1/2" of slack, where it had all been tight.

it took 4 hours and calling my mechanic brother out to look at it to finally figure out that the half-moon cable guide piece the adjuster cable ran over had a notch that was 1/32" out of place, causing the slack.

drum brakes are evil.

That's great but you still haven't explained why you drew your brake drums on your car?

Tcoat · 11-16-2019, 01:18 PM

Quote:

Originally Posted by JD001

I think you may have a point regards"intelligent" contribution. My simple thinking was based on shiny things always look good and impress.. as for checking the darn brake pads, how about the following?

Oh come on I did the best to channel Granted and that is all I get.

soundman98 · 11-16-2019, 01:18 PM

Quote:

Originally Posted by JD001

That's great but you still haven't explained why you drew your brake drums on your car?

i didn't draw them. that was the other guy. and he drew them out because he said it was before digital pictures. back then, they had to take pictures on film, and get them developed, which would take weeks.

i know, because my families first digital camera, my mom would always yell at me for "wasting film".

JD001 · 11-16-2019, 01:25 PM

Quote:

Originally Posted by Tcoat

Oh come on I did the best to channel Granted and that is all I get.

What are you expecting? A 'spanking'? This I would leave to our Royal family... I'm just too polite to fucking dish out abuse..

11-16-2019, 12:22 PM	#186
Sapphireho Famous Potatoes Join Date: Mar 2016 Drives: '15 ultramarine Location: Idaho Posts: 14,045 Thanks: 5,814 Thanked 19,647 Times in 9,243 Posts Mentioned: 162 Post(s) Tagged: 0 Thread(s)	I really need to wash my rims. Attached Images

11-16-2019, 12:42 PM	#188
Tcoat Senior Member Join Date: Jul 2014 Drives: 2020 Hakone Location: London, Ont Posts: 69,841 Thanks: 61,656 Thanked 108,295 Times in 46,456 Posts Mentioned: 2499 Post(s) Tagged: 50 Thread(s)	DAMNIT. Guys, yesterday I could see all my brake parts just fine but today I can't see anything at all. I can't even tell if I have rotors or calipers much less pads. What can I do? PLEASE HELP! Attached Images __________________ Racecar spelled backwards is Racecar, because Racecar.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY - Changing Your Brake Pads (Race Pads upgrade)	PMok	DIY (Do-It-Yourself) Guides	53	09-03-2021 06:17 PM
Brake Pads, Rotors and All Your Brake/Suspension Needs! Great Prices!! Check it out!!	Mike@CZP	Brakes, Suspension, Chassis	348	06-01-2018 01:29 PM
Wtb coilovers, brake pads, SS brake lines, engine dress up stuff	IBill4You	Want-To-Buy Requests	2	06-13-2015 04:02 PM
Project Mu - Brake Pads, Rotors and Brake Cooling Duct - FREE SHIPPING!	eauto	Brakes, Suspension, Chassis	255	10-15-2014 02:45 PM
Redline360: Brake Lines, Brake Rotors, Brake Pads for BRZ/FRS	Redline360	Brakes, Suspension, Chassis	12	01-05-2013 11:20 PM

11-16-2019, 11:39 AM	#183
Dake Senior Member Join Date: Aug 2012 Drives: FR-S Location: Houston Posts: 1,082 Thanks: 469 Thanked 841 Times in 424 Posts Mentioned: 5 Post(s) Tagged: 0 Thread(s)	Back before cell phones with cameras, I drew a diagram of the rear drums on my Chevy Nova (the Toyota re-badged one) so I could get it back together.

User Name		Remember Me?
Password