Innovate (Sprintex) Supercharger Owners Topic - Page 42 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

NickFRS · 07-28-2013, 03:38 PM

The PDX cars.

mad_sb · 07-29-2013, 09:32 AM

Quote:

Originally Posted by sw20kosh

I have been told the dyno dynamics has two modes:

1. Comparison mode - #s like a dynojet
2. Heartbreaker mode - low #s

Depends on the calibration. DD is the easiest of all to correct / fudge. Only takes one keystroke ("x" then enter your desired correction factor).

The older models, like the one shown in this thread, if uncorrected will read about 15% lower than an AWD dynojet on AWD cars. They seem to read at least that much lower in 2wd mode. If stock twins are making 160 - 165 then this one has either been corrected or recalibrated by dynodynamics.

Draco-REX · 07-29-2013, 10:17 AM

Quote:

Originally Posted by ft_sjo

Thanks. If we assume that dyno over-reads by about 10% (going by the N/A figures), then 220hp for the supercharged run sounds about right.

Don't forget, his baseline has a header-back exhaust and tune.

xjohnx · 07-29-2013, 10:28 AM

T minus 4 days to install! Tune from @moto-mike is in my inbox. Fuel pump and injectors should be delivered by UPS today. Innovate Supercharger should be arriving at @Pure Automotive 's shop tomorrow (I believe).

Looks like it's all coming together!

Draco-REX · 07-29-2013, 10:45 AM

I am so far behind schedule. Still haven't been able to get the car in for the flywheel yet..

Subzero · 07-29-2013, 11:29 AM

Quote:

Originally Posted by Draco-REX

I am so far behind schedule. Still haven't been able to get the car in for the flywheel yet..

This I am anxious to see. It should brap straight to the rev limiter.

mines13 · 07-29-2013, 01:10 PM

Quote:

Originally Posted by Draco-REX

I am so far behind schedule. Still haven't been able to get the car in for the flywheel yet..

This is a massive upgrade, I feel that swapping to a light weight flywheel transforms the character of this engine for the better.

xjohnx · 07-29-2013, 02:24 PM

Quote:

Originally Posted by mines13

This is a massive upgrade, I feel that swapping to a light weight flywheel transforms the character of this engine for the better.

dammit, i really need to block your account. Every time i read your posts i'm tempted to spend more money.

mines13 · 07-29-2013, 02:27 PM

Quote:

Originally Posted by xjohnx

dammit, i really need to block your account. Every time i read your posts i'm tempted to spend more money.

You are not kidding, I spend WAY too much money as it is on my own stuff.

Subzero · 07-29-2013, 03:01 PM

Quote:

Originally Posted by mines13

You are not kidding, I spend WAY too much money as it is on my own stuff.

Why am I not married? Because I can't have a spare on the shelf. :happy0180:

DarrenDriven · 07-29-2013, 03:13 PM

My attitude about the dyno numbers is that it doesn't really matter if you compare apples to apples. Do a baseline and a post-install run on the same dyno and you will get a realistic percentage increase in your power. I don't bother comparing my numbers to other dyno sheets... but gives you an idea.

swift996 · 07-29-2013, 04:12 PM

Was there a verdict on the Perrin CAI?

DarrenDriven · 07-29-2013, 04:14 PM

My car and the Hot Lava car owned by @tech4pdx

wrxgoose · 07-29-2013, 07:20 PM

now we need to get the two of them on a track to have some fun.

07-28-2013, 03:38 PM	#575
NickFRS Senior Member Join Date: Jun 2012 Drives: 2013 Asphalt FRS Location: Gladstone Posts: 1,450 Thanks: 899 Thanked 440 Times in 286 Posts Mentioned: 75 Post(s) Tagged: 0 Thread(s)	The PDX cars. __________________ 2013 Sion FRS 2014 Subaru WRX 2014 Subaru XV

07-29-2013, 04:12 PM	#586
swift996 Senior Member Join Date: Nov 2011 Drives: Subaru BRZ Limited 6MT Location: Winston-Salem, NC Posts: 2,432 Thanks: 712 Thanked 955 Times in 545 Posts Mentioned: 47 Post(s) Tagged: 0 Thread(s)	Was there a verdict on the Perrin CAI? __________________ Innovate Supercharged Black Limited BRZ 6-Speed MT(Build Thread) 2010 Cadillac CTS-V Sedan M6 w/550whp (Build Thread)

07-29-2013, 07:20 PM	#588
wrxgoose WUB WUB Join Date: Aug 2012 Drives: 2013 Firestorm Location: Charlotte Posts: 2,788 Thanks: 313 Thanked 1,573 Times in 858 Posts Mentioned: 52 Post(s) Tagged: 1 Thread(s)	now we need to get the two of them on a track to have some fun. __________________ Build thread: http://www.ft86club.com/forums/showthread.php?t=40850 no more blower power

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Innovative ideas to increase interior storage capacity?	swift996	Cosmetic Modification (Interior/Exterior/Lighting)	0	01-30-2013 11:45 PM
AVO vs Innovative	diss7	Forced Induction	32	01-21-2013 07:15 PM
Not another need to drive topic	Sargy	Mid-Atlantic	5	11-27-2012 01:18 PM
Technical topic sub-forums	OrbitalEllipses	Site Announcements / Questions / Issues	1	07-18-2012 12:38 AM
Can you close the topic please?	Standardsuspension	Brakes, Suspension, Chassis	14	06-26-2012 06:14 PM

07-29-2013, 10:28 AM	#578
xjohnx Grip>Slip Join Date: Jun 2012 Drives: 13 SWP BRZ Ltd - Innovate Powered! Location: RVA Posts: 3,563 Thanks: 656 Thanked 1,717 Times in 1,031 Posts Mentioned: 45 Post(s) Tagged: 3 Thread(s)	T minus 4 days to install! Tune from @moto-mike is in my inbox. Fuel pump and injectors should be delivered by UPS today. Innovate Supercharger should be arriving at @Pure Automotive 's shop tomorrow (I believe). Looks like it's all coming together!

07-29-2013, 10:45 AM	#579
Draco-REX Corner Junkie Join Date: Feb 2012 Drives: 13 BRZ, 11 STI, 99 RS Location: Ohio Posts: 2,908 Thanks: 129 Thanked 1,521 Times in 702 Posts Mentioned: 11 Post(s) Tagged: 0 Thread(s)	I am so far behind schedule. Still haven't been able to get the car in for the flywheel yet..

User Name		Remember Me?
Password