follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Delicious Tuning
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.58 seconds. Search: Posts Made By: CxG
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 07-10-2019, 01:55 AM
Replies: 632
Views: 1,584,953
Posted By ayoshioka1
ADVAN RACING TC3 18x9.5 +45 square setup...

ADVAN RACING TC3 18x9.5 +45 square setup 255/35/18 firehawks

https://i.imgur.com/Z2stv4m.jpg

https://i.imgur.com/Ou6Q4FF.jpg

https://i.imgur.com/AY0dkVb.jpg

https://i.imgur.com/rCg0myL.jpg
Forum: Forced Induction 05-08-2019, 11:03 AM
Replies: 1,372
Views: 393,311
Posted By johan
I think as far as "where it hits its stride" is...

I think as far as "where it hits its stride" is defined by the compressor maps, I don't have that info. But yes, the point is, if the blower isn't working as hard, it will generate less heat via...
Forum: Forced Induction 05-07-2019, 12:15 PM
Replies: 1,372
Views: 393,311
Posted By johan
Justin, I'm just going to wade into this gently,...

Justin, I'm just going to wade into this gently, but I believe what he was getting at is that the 1320 requires more horsepower to spin. So, within the relative boost range that the 900 and 1320 can...
Forum: Electronics | Audio | NAV | Infotainment 05-02-2019, 11:29 AM
Replies: 57
Views: 36,000
Posted By demariners
Well re-pinning the clock spring is completely up...

Well re-pinning the clock spring is completely up to the installation. You can re pin it however you wish. The 2015 clock spring is only using 2 pins for the cruise control but the plug supports 12...
Forum: Forced Induction 04-27-2019, 05:25 AM
Replies: 27
Views: 10,200
Posted By Xero-Limit
Sorry to hear about your motor, sad how this...

Sorry to hear about your motor, sad how this recall has played out. You might want to check out our build here: http://www.ft86club.com/forums/showthread.php?t=133475 on the latest car. Basically...
Forum: Forced Induction 03-06-2019, 09:18 AM
Replies: 71
Views: 21,605
Posted By xjohnx
If your dealer is refusing to perform the recall...

If your dealer is refusing to perform the recall without you paying to have mods removed, I implore you to open an NHTSA investigation at the following link:
...
Forum: Forced Induction 03-05-2019, 11:58 AM
Replies: 71
Views: 21,605
Posted By xjohnx
I have obtained a copy of an email from a Subaru...

I have obtained a copy of an email from a Subaru district manager confirming they they are working against the spirit of the agreement Subaru entered into with the NHTSA. How could these items be a...
Forum: Forced Induction 03-05-2019, 08:07 AM
Replies: 71
Views: 21,605
Posted By Dadhawk
Sounds like you need to find a new dealer, not...

Sounds like you need to find a new dealer, not only for service, but for future purchases.
Forum: Forced Induction 03-04-2019, 02:27 PM
Replies: 71
Views: 21,605
Posted By Dadhawk
I think you may be right about the aftermarket...

I think you may be right about the aftermarket parts though. If you read through the Subaru instructions (https://static.nhtsa.gov/odi/rcl/2018/RCRIT-18V772-6522.pdf) (did not review Toyota) on page...
Forum: Forced Induction 03-02-2019, 11:08 PM
Replies: 71
Views: 21,605
Posted By mswbrz
My car falls under the recall 13 Brz and I was...

My car falls under the recall 13 Brz and I was able to register with no issues and HAVE NOT DONE RECALL .


Sent from my iPhone using Tapatalk
Forum: Engine, Exhaust, Transmission 02-13-2019, 07:11 PM
Replies: 439
Views: 185,710
Posted By staycrushing
the stock radiator and dedicated jackson cooler...

the stock radiator and dedicated jackson cooler would be a better option for you if you prefer separate units.

i personally run the dual oil cooler/radiator combo and have had zero issues with...
Forum: Engine, Exhaust, Transmission 02-13-2019, 08:56 AM
Replies: 439
Views: 185,710
Posted By Fred E
I don't think it's entirely reasonable to compare...

I don't think it's entirely reasonable to compare this unit to two dedicated separate units. Separate dedicated (high end) units could be more "effective" than this combo unit, but that also depends...
Forum: Forced Induction 01-26-2019, 04:56 PM
Replies: 71
Views: 21,605
Posted By Norotor
I'm going to have this problem; I've had my...

I'm going to have this problem; I've had my forged engine with upgraded heads/valvetrain sitting around for a while and finally decided to drop it back into my frs, and of course the recall was...
Forum: Forced Induction 01-24-2019, 03:53 PM
Replies: 71
Views: 21,605
Posted By kmbkk
Update... Priority Toyota agreed to do my...

Update...

Priority Toyota agreed to do my recall and I don’t have to remove the turbo kit. They’re also replacing the spark plugs and not charging any labor. I asked about using aftermarket valve...
Forum: Engine, Exhaust, Transmission 01-23-2019, 03:53 PM
Replies: 439
Views: 185,710
Posted By Butterballz
For me kinking was not a problem, you just have...

For me kinking was not a problem, you just have to twist where the fitting meets the hose. However, I did get rubbing. I twisted the lines to avoid touching anything but when pressurize, it tries to...
Forum: Forced Induction 01-15-2019, 10:07 AM
Replies: 71
Views: 21,605
Posted By Tcoat
Yep that is why I said check with your dealer....

Yep that is why I said check with your dealer. There has to be some that would like the extra income to do the work.
I hear ya on the Ca thing. That does sort of put your back up against the wall....
Forum: Forced Induction 12-24-2018, 05:24 PM
Replies: 1,372
Views: 393,311
Posted By sw20kosh
I run a 16psi pulley and control boost via...

I run a 16psi pulley and control boost via throttle mapping. I target a nice flat 12 psi across the rev range.
Forum: Forced Induction 12-20-2018, 03:56 PM
Replies: 1,372
Views: 393,311
Posted By johan
I don't want to go too far down the rabbit hole...

I don't want to go too far down the rabbit hole on this, as you guys should do your own testing and find the limits on this platform / blower. All of my testing was done on a Honda K20.

But I'll...
Forum: Forced Induction 12-17-2018, 11:05 PM
Replies: 1,372
Views: 393,311
Posted By firekat
I'm running the JR Radiator with the Harrop. ...

I'm running the JR Radiator with the Harrop. Both coolant and oil run a little over 190F most of the time. This is notably lower than stock readings. The only time I have seen these values creep...
Forum: Forced Induction 12-17-2018, 02:06 PM
Replies: 1,372
Views: 393,311
Posted By Trefoil
Just took a look at the Harrop oil cooler for our...

Just took a look at the Harrop oil cooler for our car: https://www.harrop.com.au/shop/engine-oil-cooler-toyota-86subaru-brz?search=oil%20cooler

Ouch! About the same price and no mention of...
Forum: Forced Induction 12-14-2018, 08:34 PM
Replies: 1,372
Views: 393,311
Posted By Trefoil
I went to a Jackson Racing dual radiator cooler...

I went to a Jackson Racing dual radiator cooler and experience extremely solid values from IAT sensor, OTS, and CTS. It has been a functional upgrade for driving in both cold and heat in a high...
Forum: Forced Induction 11-14-2018, 01:53 AM
Replies: 1,372
Views: 393,311
Posted By byun
Have to say this kit with the 85mm pulley and E85...

Have to say this kit with the 85mm pulley and E85 is amazing. Hitting 13psi and car feels a lot faster than the 90mm pulley I was running before


Sent from my iPhone using Tapatalk
Forum: Engine Swaps 09-20-2018, 10:01 AM
Replies: 139
Views: 110,695
Posted By VR4EVER
The guy who owns Puristmod is the same guy who...

The guy who owns Puristmod is the same guy who posted earlier in this thread... Dustin@Dynosty.

I actually bought Dustin's car (which had the BEAMS swap done on it) for my LS swap. Super nice guy....
Forum: Engine Swaps 09-18-2018, 09:13 PM
Replies: 139
Views: 110,695
Posted By Kenny_LongWrench
This may be of help. ...

This may be of help.

https://www.puristmod.com/collections/86swap-com/electronics
Forum: Engine Swaps 09-14-2018, 01:59 AM
Replies: 62
Views: 47,661
Posted By Manji
Car has been almost fully rebuilt over past 12...

Car has been almost fully rebuilt over past 12 months.
Decided to dry sump motor. Meant it could be mounted better, lower and further back.
Twin plate clutch, new cooling system, ducting and vents,...
Forum: Forced Induction 09-05-2018, 06:22 PM
Replies: 1,372
Views: 393,311
Posted By sw20kosh
My car dry (no gas, passengers, cargo, trunk...

My car dry (no gas, passengers, cargo, trunk stuff) is 2750 lbs.

Mods:
Half roll cage
Harrop SC kit
2 oil coolers
Brembo Club Racer 350mm big brake kit
Brembo GT rear big brake kit
17x9.5...
Forum: Forced Induction 09-04-2018, 08:37 PM
Replies: 1,372
Views: 393,311
Posted By Yoshoobaroo
Harrop TVS86 Owners Thread

That's why I'm asking, people with coilovers don't really have this issue, but with lowering springs you may need a 1/4" spacer on the top hat to level it back out. Spacers like this:...
Forum: Engine, Exhaust, Transmission 09-02-2018, 04:54 PM
Replies: 439
Views: 185,710
Posted By falcon_wizard
So I promised I would provide some feedback once...

So I promised I would provide some feedback once the Jackson Dual Cooler was installed.

Initial comparison logs seems very promising. While Oil temp could easily reach 280 degF when driving at...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 08-21-2018, 02:52 PM
Replies: 146
Views: 109,779
Posted By JRitt
Please also note...brake disc thermal mass plays...

Please also note...brake disc thermal mass plays into longevity. That's why we have multiple kits to cater to differing needs. My hunch is that the Brembo disc weighs about 20-21 lbs. Our 299x32mm...
Forum: Engine, Exhaust, Transmission 08-14-2018, 02:16 PM
Replies: 439
Views: 185,710
Posted By FymTom
I purchased the dual setup through CSG recently....

I purchased the dual setup through CSG recently. I did a data log of my daily commute before and after the install. I figured the data may interest some, since I was looking for more.

Car has JDL...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -4. The time now is 07:42 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.