follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 2 1 2
Showing results 1 to 27 of 42
Search took 0.31 seconds. Search: Posts Made By: vfrqqq
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 12-26-2023, 04:15 PM
Replies: 9
Views: 4,172
Posted By whataboutbob
I think a catch can would help with this. Even NA...

I think a catch can would help with this. Even NA I got a decent amount of blow-by and I suspect what you are seeing is a result of blow-by.
Forum: Engine, Exhaust, Transmission 10-28-2023, 05:34 PM
Replies: 20
Views: 3,316
Posted By e1_griego
Last motor swap I did (which was a few years ago)...

Last motor swap I did (which was a few years ago) took about 5 hours from driving one into the garage with rod knock to firing the new (used, ebay) motor up.

These things are stupid simple.
Forum: Engine, Exhaust, Transmission 10-11-2023, 09:51 PM
Replies: 20
Views: 3,316
Posted By NoHaveMSG
It's not just the cam sensors. The reluctor wheel...

It's not just the cam sensors. The reluctor wheel for cam positioning is different as is the crank position sensor and reluctor wheel. Inny vs. Outy. Pre-facelift ECU can't read the signal on the...
Forum: Engine, Exhaust, Transmission 10-10-2023, 08:39 AM
Replies: 20
Views: 3,316
Posted By blsfrs
I did something similar to get my FRS. Before...

I did something similar to get my FRS. Before car prices went crazy, I made friends with the manager of a small car lot near my house. I would stop in weekly and we would look at various auction...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 07-31-2023, 01:12 PM
Replies: 1
Views: 1,036
Posted By Figo
Iv figured it out. They are the same. Subaru...

Iv figured it out. They are the same. Subaru updated the part number from soa868v9270 to soa868v9272 and changed containers. so the Black container is the new version of the coolant!

If you are...
Forum: Scion FR-S / Toyota 86 GT86 General Forum 09-23-2022, 09:30 AM
Replies: 24,612
Views: 7,307,377
Posted By blsfrs
Purchased Billetworz 500g shift knob from vfrqqq....

Purchased Billetworz 500g shift knob from vfrqqq. My butt dyno says it added 2.57 hp. Feels really nice too.
Forum: Engine, Exhaust, Bolt-Ons 08-23-2022, 10:23 PM
Replies: 31
Views: 7,476
Posted By dreamwonder
Carb tune works for 2015. The tune itself is non...

Carb tune works for 2015. The tune itself is non transferable.
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 08-15-2022, 11:47 AM
Replies: 17
Views: 2,832
Posted By DarkPira7e
That's why I don't comment on things I intend to...

That's why I don't comment on things I intend to buy typically. Easier to PM them
Forum: User/Vendor/Sponsor Reviews, Feedback, Comments 08-13-2022, 11:17 AM
Replies: 17
Views: 2,832
Posted By Windycity
Watch for Scammers Everyone

Hey fellow car guys, this forum is one of the best and most thorough resources for the 86 platform. I have purchased many things from this forum over the years and have had no issues. I recently...
Forum: Engine, Exhaust, Transmission 07-11-2022, 05:52 PM
Replies: 31
Views: 4,663
Posted By jrhudson
i went this route and its really not as simple as...

i went this route and its really not as simple as you making it out to be. I was on the same boat as you. novice "mechanic"(meaning not real mechanic, does it for a hobby on my car), mechanically...
Forum: Engine, Exhaust, Transmission 07-11-2022, 05:36 PM
Replies: 31
Views: 4,663
Posted By NoHaveMSG
If you haven't done any kind of engine assembly...

If you haven't done any kind of engine assembly before I don't recommend it. A boxer is just like any other engine but almost double the parts. If you don't have experience with FIPG it can be easily...
Forum: Engine, Exhaust, Transmission 07-11-2022, 05:36 PM
Replies: 31
Views: 4,663
Posted By Ultramaroon
For sure! Long block is doable. There are some...

For sure! Long block is doable. There are some differences in the layout of electrical parts, so make sure the replacement is compatible. I don't remember the cutoff years offhand, just that it's...
Forum: Engine, Exhaust, Transmission 07-11-2022, 04:04 PM
Replies: 31
Views: 4,663
Posted By DarkPira7e
I second the notion that you doing a rebuild...

I second the notion that you doing a rebuild isn't a great idea. There are things so impossibly small that will make or break your build, this engine isn't forgiving in the slightest.

Just get...
Forum: Engine, Exhaust, Transmission 07-11-2022, 03:20 PM
Replies: 31
Views: 4,663
Posted By Ultramaroon
Peace of mind went out the window as soon as the...

Peace of mind went out the window as soon as the supercharger was added. An overly aggressive, or poor tune was most likely the culprit.

If you are already hedging with "don't have the time to...
Forum: Electronics | Audio | NAV | Infotainment 11-25-2021, 01:17 PM
Replies: 4
Views: 1,209
Posted By LimitedSlip
This should help: ...

This should help:

https://www.ft86club.com/forums/showthread.php?t=142734

:thumbsup:
Forum: Engine, Exhaust, Transmission 08-20-2021, 05:23 PM
Replies: 8
Views: 1,860
Posted By wolffbite
OP hasn't replied yet but if the reverse lockout...

OP hasn't replied yet but if the reverse lockout gate is indeed your issue, here is the official procedure for setting the clearance.
Forum: DIY (Do-It-Yourself) Guides 07-23-2021, 07:14 AM
Replies: 217
Views: 221,984
Posted By ermax
Like I said it’s Russian roulette. It isn’t that...

Like I said it’s Russian roulette. It isn’t that you had to turn it far, it’s just that you didn’t get lucky until you turned it far. I typically just turn it a few degrees and cross my fingers. If...
Forum: DIY (Do-It-Yourself) Guides 07-14-2021, 06:22 AM
Replies: 217
Views: 221,984
Posted By Feezz
Its very useful, You put best efforts!

Its very useful, You put best efforts!
Forum: DIY (Do-It-Yourself) Guides 07-08-2021, 12:58 PM
Replies: 217
Views: 221,984
Posted By blsfrs
I'm not an expert but I have worked on cars for a...

I'm not an expert but I have worked on cars for a long time. When a flywheel is resurfaced, an equal amount of material is removed from its entire face. Its "balance" won't change. That leaves the...
Forum: DIY (Do-It-Yourself) Guides 07-08-2021, 08:49 AM
Replies: 217
Views: 221,984
Posted By blsfrs
Did you reach out to SBC? If the dealer won't...

Did you reach out to SBC? If the dealer won't help try the manufacturer.
Forum: DIY (Do-It-Yourself) Guides 07-03-2021, 11:38 AM
Replies: 217
Views: 221,984
Posted By ermax
I’ve never heard of someone surfacing a FW...

I’ve never heard of someone surfacing a FW without also making sure it’s balanced but if I had to guess, this is where your problem is if it’s not the driveshaft. Did you mark the drive shaft before...
Forum: DIY (Do-It-Yourself) Guides 07-02-2021, 03:04 PM
Replies: 217
Views: 221,984
Posted By pope
Ideally, removing an even layer of material would...

Ideally, removing an even layer of material would not change the balance. But was the layer removed an even layer? .030” from the highest point might have only been .025” from another point. The...
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-14-2021, 07:28 PM
Replies: 55
Views: 7,305
Posted By itschris
I noticed this a couple years ago in my reservoir...

I noticed this a couple years ago in my reservoir too. I tried wiping it out with a paper towel when bleeding my clutch, it was kinda greenish blackish. Didn't get it all, but hasn't seemed to cause...
Forum: Engine, Exhaust, Transmission 06-11-2021, 09:33 PM
Replies: 6
Views: 1,727
Posted By Olson1288
Found this quote on a Subaru forum. It's from...

Found this quote on a Subaru forum. It's from like 10 years ago but I imagine the same process still applies:


"Hi guys, I work for South Bend Clutch. I just wanted to clarify your concerns.
...
Forum: Engine, Exhaust, Transmission 06-11-2021, 06:59 PM
Replies: 6
Views: 1,727
Posted By CSG Mike
They're made by Exedy, as are many clutches on...

They're made by Exedy, as are many clutches on the market, including the stock clutch.
Forum: Mechanical Maintenance (Oil, Fluids, Break-In, Servicing) 06-04-2021, 11:22 PM
Replies: 55
Views: 7,305
Posted By Capt Spaulding
If the friction point is that low it could very...

If the friction point is that low it could very possibly be a source of your problem. Since swapping the fluid and bleeding the system didn't resolve your issue, you might try adjusting the pedal...
Forum: Forced Induction 03-27-2021, 05:18 PM
Replies: 23
Views: 55,853
Posted By ShadowReaper
I got some pictures to add to this thread 1st...

I got some pictures to add to this thread
1st picture: Overlook
2nd picture: The hose (in red) connects to the solenoid, helpful for tracing it.
3rd picture: (From the back of the Intake Manifold)...
Showing results 1 to 27 of 42
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -4. The time now is 10:53 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.