follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums

Register and become an FT86Club.com member. You will see fewer ads

Showing results 1 to 30 of 34
Search took 0.01 seconds.
Search: Posts Made By: Colin86
Forum: DIY (Do-It-Yourself) Guides 08-11-2024, 01:02 PM
Replies: 13
Views: 21,243
Posted By Colin86
For those of you in the same challenge. Solution...

For those of you in the same challenge. Solution I found was to power the two pins shown below with 12v power from the cig lighter. To get to the plug for the fuel relay you have to pull the interior...
Forum: Forced Induction 05-23-2023, 02:18 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
In theory the new bypass should (hopefully) be...

In theory the new bypass should (hopefully) be more reliable -if you bought the kit relatively recently you probably already have the revised unit. I installed the new style bypass last year, it's...
Forum: Forced Induction 10-03-2022, 01:09 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
PSA: The upgraded edelbrock bypass is relatively...

PSA: The upgraded edelbrock bypass is relatively straight forward to install WITHOUT removing the supercharger if you remove the AC compressor. Remove the AC compressor, throttle body, engine side of...
Forum: Engine, Exhaust, Transmission 09-09-2022, 04:25 PM
Replies: 6
Views: 1,312
Posted By Colin86
I had to clamp the springs with a vice before...

I had to clamp the springs with a vice before getting the first few threads on the nut on my JDL mid pipe... Not fun, but it all went together ok after getting the first few threads twisted on the...
Forum: Forced Induction 09-07-2022, 05:53 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
The edelbrock heat exchanger is low temp,...

The edelbrock heat exchanger is low temp, doubtful it'll negatively impact overall engine cooling in a meaningful way. Especially if you have the radiator/heat exchangers sealed against the bumper...
Forum: Issues | Warranty | Recalls / TSB 07-07-2022, 10:41 AM
Replies: 14
Views: 4,279
Posted By Colin86
New fuse block installed, sanded things, put it...

New fuse block installed, sanded things, put it back together and everything runs great. The old fuse block had plastic melted across nearly the entire bottom of the contact point -definitely what...
Forum: Forced Induction 11-17-2019, 04:42 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
I don't have an El header, but I'm on stock...

I don't have an El header, but I'm on stock clutch and spun a dynojet to the tune of 330whp and 240wtq with e85. Roughly 25k miles on the car, 5k of that supercharged.

Clutch slips a slight bit...
Forum: Forced Induction 09-27-2019, 08:09 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Same exact symptoms I just resolved by replacing...

Same exact symptoms I just resolved by replacing my bypass, thats where I'd start.
Forum: Forced Induction 09-12-2019, 02:11 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Chalk me up as another bypass valve victim. Car...

Chalk me up as another bypass valve victim. Car was frequently stalling at clutch in and idle would occasionally flutter. Otherwise car drove without major issues.

There was an audible hiss at...
Forum: Forced Induction 04-27-2019, 12:44 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Did the install myself and it's been smooth...

Did the install myself and it's been smooth sailing, even after pushing the envelope and going flex fuel. I'd definitely do it over again.

Keep in mind this thread serves as a place those with...
Forum: Forced Induction 03-29-2019, 03:47 AM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
This. Beyond that my car has been absolutely...

This.

Beyond that my car has been absolutely reliable with the delicious tune including excellent driveability, no regrets. If you're looking for more power I highly recommend.
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 12-08-2018, 12:49 PM
Replies: 28
Views: 5,630
Posted By Colin86
For what it's worth my 215 MPSS's have handled...

For what it's worth my 215 MPSS's have handled many 20 minute HPDE sessions without complaining or getting greasy (65-80 degree ambient). Had to air out as they gained something like 15+psi, but...
Forum: Wheels | Tires | Spacers | Hub -- Sponsored by The Tire Rack 12-07-2018, 12:32 AM
Replies: 28
Views: 5,630
Posted By Colin86
Edelbrock supercharged on e85 here. Dynoed at...

Edelbrock supercharged on e85 here. Dynoed at roughly 330whp. Currently on 215/45/17 mpss on stock wheels.

If conditions are right on the street I've gently rolled into first and maintained a...
Forum: Forced Induction 10-07-2018, 12:08 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
More of a road course guy but the drag strip is...

More of a road course guy but the drag strip is fun every now and again. First time I took my FRS out last year the track was rained out and I was only able to make one pass where I spun all the way...
Forum: Engine, Exhaust, Transmission 07-31-2018, 09:14 PM
Replies: 42
Views: 15,141
Posted By Colin86
Apparently the Sickspeed differential covers have...

Apparently the Sickspeed differential covers have been discontinued, just found out my order was canceled and refunded. Lame.
Forum: Forced Induction 07-21-2018, 11:35 AM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Logs are showing manifold absolute pressure...

Logs are showing manifold absolute pressure around 1.75 bar right at my redline of 7500, so a peak of 10-11 psi. Note Delicious and most tuners recommend safely extending redline slightly and I would...
Forum: Forced Induction 07-16-2018, 08:16 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Edelbrock on 93 felt quick, e85 makes it feel...

Edelbrock on 93 felt quick, e85 makes it feel fast -you're going to love it. :cheers:

Definitely agree on the Delicious V25, the drive ability is way better than any of my previous tunes.
Forum: Forced Induction 07-05-2018, 09:28 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Posted this in the dyno thread but figured I'd...

Posted this in the dyno thread but figured I'd share here as well.

Edelbrock w/ stock pulley
DW300c fuel pump and DW 700cc injectors
Delicious D box, flex fuel kit, and Edelbrock tune
Gruppe-S...
Forum: Forced Induction 07-05-2018, 09:25 PM
Replies: 284
Sticky: FI Dyno thread
Views: 270,170
Posted By Colin86
Edelbrock w/ stock pulley DW300c fuel pump and...

Edelbrock w/ stock pulley
DW300c fuel pump and DW 700cc injectors
Delicious D box, flex fuel kit, and Edelbrock tune
Gruppe-S UEL header and over pipe (both coated)
E85
Stock front pipe, cat...
Forum: Engine Swaps 05-10-2018, 09:31 PM
Replies: 172
Views: 88,844
Posted By Colin86
Build is beautiful, thanks for sharing with the...

Build is beautiful, thanks for sharing with the forums!
Forum: Forced Induction 10-14-2017, 07:49 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Dbox and Delicious tuned here -car runs nice and...

Dbox and Delicious tuned here -car runs nice and smooth.

Unfortunately I think my bypass went bad... Going to check it tomorrow, huge thanks to BirdTRD for the guide.

I feel like we should...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 07-20-2017, 02:03 PM
Replies: 71
Views: 42,692
Posted By Colin86
I've used the Hawk HP+ pads on another platform...

I've used the Hawk HP+ pads on another platform for split duty and just put Hawk Street/Race pads on my FRS.

Haven't been to the track yet in the FRS with the new Street/Race pads but compared to...
Forum: Engine, Exhaust, Transmission 07-19-2017, 10:25 AM
Replies: 21
Views: 9,899
Posted By Colin86
Confirmed, settings work. Thank you Yoshoobaroo!!

Confirmed, settings work. Thank you Yoshoobaroo!!
Forum: Engine, Exhaust, Transmission 07-17-2017, 12:02 PM
Replies: 21
Views: 9,899
Posted By Colin86
Thank you!!! :cheers: I'm going to give this a...

Thank you!!! :cheers: I'm going to give this a shot and will report back.
Forum: Forced Induction 05-30-2017, 07:36 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
Any others in the forums running e85 + edelbrock...

Any others in the forums running e85 + edelbrock on a stock bottom end? How many miles on the setup? Track days?

Worth the risk?
Forum: Engine, Exhaust, Transmission 05-28-2017, 10:01 PM
Replies: 439
Views: 211,083
Posted By Colin86
Other than the lines the kit has been great!! :D

Other than the lines the kit has been great!! :D
Forum: Engine, Exhaust, Transmission 05-28-2017, 09:35 PM
Replies: 439
Views: 211,083
Posted By Colin86
I went to install this kit a year ago and found...

I went to install this kit a year ago and found the lines to be unacceptable. The shorter line had a kink regardless of how it was installed. Line failures like the one shown above aren't surprising....
Forum: Engine, Exhaust, Bolt-Ons 01-11-2017, 10:53 AM
Replies: 680
Views: 234,718
Posted By Colin86
NVM, saw it on the first post. 42.7 mm to...

NVM, saw it on the first post.

42.7 mm to 60mm (for anyone who was curious)

Free bump!
Forum: Forced Induction 11-25-2016, 12:02 PM
Replies: 5,015
Views: 1,811,619
Posted By Colin86
I had this exact same issue on the CARB tune, it...

I had this exact same issue on the CARB tune, it seemed to happen more frequently when the AC was on... For me I noticed it on the highway during partial throttle passing situations mid way through...
Forum: Forced Induction 11-15-2016, 09:12 PM
Replies: 26
Views: 22,494
Posted By Colin86
Congrats on the numbers!! I too am curious...

Congrats on the numbers!!

I too am curious about the specs of the engine build...
Showing results 1 to 30 of 34

 
Forum Jump

All times are GMT -4. The time now is 01:00 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2026 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.