$50 Kensun HID KITS

[ryoma]

Originally Posted by golfyankee2121

The quality of mine seem to be pretty good. I've had them for over a year now and no problems to date...

-J.B.

if 6000k is more blue than 8000k, then you have quality control issues. 6000k should NEVER be more blue than 8000k. 6000k should be brighter (in regards to pure lumens output) for sure, but not more blue. btw, 8000k is straight up dangerous to drive on the road. the point of HID's (properly set up with projector and bulbs) is to increase light output to drive safely. no idea why people would want to take a step back with bulbs that are near purple in color and have less visibility than halogen reflectors.

to the OP: if you are dead set on a PnP option (it's not as bad for the FRS since it comes with halogen projectors compared to halogen reflectors), I suggest buying the Morimoto bulbs from The Retrofit Source. top notch customer service and better than most, if not all, of the China bulbs on the market.

[FRSBRZGT86FAN]

Originally Posted by toast

I read in a thread on here that tuners have found instances of non-OEM HID's putting out sufficiently high RF emissions that it would screw up the ECU and make the care act strange. OEM products are rigorously tested for their emissions, aftermarket ones do not have to meet this requirement.

Either there ecu isn't shielded or that hid kit is not made in the U.S. or imported illegally because its got some serious FCC issues lol I've never heard of that issue

[Poodles]

Originally Posted by FRSBRZGT86FAN

Either there ecu isn't shielded or that hid kit is not made in the U.S. or imported illegally because its got some serious FCC issues lol I've never heard of that issue

All HID kits are illegal technically. There's a reason a single OEM ballast or bulb is more expensive than an entire "kit."

[BobbyDee]

Here's another picture to compare
Kensun 6k 35watt H7 vs OEM HIDs

[FRSBRZGT86FAN]

Well I'm just going to keep the stock winjet halogens for now I don't want to put HIDs on till I save up for a high quality retrofit

[ryoma]

Originally Posted by BobbyDee

Here's another picture to compare
Kensun 6k 35watt H7 vs OEM HIDs

the two HID bulbs look like they're not matching. were they warmed up when you took the picture, or just turned on?

[cdrazic93]

Lol when i was like 15 i had like 30k deep blue HID's. Man i was stupid back then.

[BobbyDee]

Originally Posted by ryoma

the two HID bulbs look like they're not matching

Hmm you know what, I can see where you made your statement. But they really match, for some reason my phone couldn't focus it, maybe I could get another picture to compare.

[Poodles]

Originally Posted by BobbyDee

Here's another picture to compare
Kensun 6k 35watt H7 vs OEM HIDs

Too close to tell much about output...

Originally Posted by BobbyDee

Hmm you know what, I can see where you made your statement. But they really match, for some reason my phone couldn't focus it, maybe I could get another picture to compare.

Phone's auto white balance will show things we can't normally see. It can also make blue look white and white look yellow...

[HATED1]

@BobbyDee how was the install? Would you mind posting pics on where you put all the hardware? Any electrical issues so far? Do they start up all the time? Any straight on shots from a bit of a distance?