Dyno Day and Tuning April 22nd! Lansdale PA

[Xero-Limit]

If you haven't seen the group buy, we will be at R/T Tuning on the dyno. Start time 0900-0930, room for 6-10 folks (more if we can move quickly and depending on what will be done).

Figure 60 for 2 runs (either stock or flashed)

100 for flash and 3-4 runs, this will have your baseline stock run, tuned file, and we'll flash it for you right there on the dyno. Does not include tune/license or hardware. This can be purchased for a couple of more days until the group buy ends, but we will flash on site also.

120/hr for hourly fine tuning for those that want it, no more than 1-2 hours each though (if you need more we'll schedule a different day)

Should be an awesome time. If you haven't been to R/T the guys there are top notch and so is the facility. Well worth the day off!

Either PM to reserve your spot, reply down below, but make sure we have you listed as we get closer so you don't lose the spot. First come first serve!

[AllDayJonRay]

Attending and will have my tune optimized! Call dibs on the earliest time slots!

[kykiee]

I'm in for this.

[AllDayJonRay]

I'm surprised there isn't more interest in this.. Even just to tag along and watch some 86 dyno's???

[Xero-Limit]

Originally Posted by AllDayJonRay

I'm surprised there isn't more interest in this.. Even just to tag along and watch some 86 dyno's???

Weekdays are such....but it allows folks who want to fine tune their stuff a bit more time. A couple of years back we did a benefit there along with the tristate crowd and managed to get ~30 cars in one day (and probably 100 people), but during the week it is a bit tougher (call in sick, we won't tell ). I'll be dragging my MX-5 now that it is back together and seeing how it does with E85. Should max out that GT2860RS with on the stock motor...or fireworks! Last time it was 325 uncorrected on pump gas and the draw through setup. Any bets?

I'd bring the BRZ but I'm keeping it stock for now to fine tune that as much as possible, and we'll be dynoing that one the 16th in Nazareth just to check up on things now that it is warm.

[Laika]

How late do you guys plan on sticking around?


I'm down to skip work as much as the next guy but I need to be in on mondays

[AllDayJonRay]

I'll be leaving early afternoon that day. Also can't miss work on Mondays (but work evenings).

[kykiee]

Originally Posted by moto-mike

Either PM to reserve your spot, reply down below, but make sure we have you listed as we get closer so you don't lose the spot. First come first serve!

Looks like I'm getting the ECUTEK today. Wondering if I should flash my ecu or just wait till Dyno Day to run one stock dyno and then flash it.

[Xero-Limit]

Originally Posted by kykiee

Looks like I'm getting the ECUTEK today. Wondering if I should flash my ecu or just wait till Dyno Day to run one stock dyno and then flash it.

Up to you...if you come in stock and flash you'll see some gains but the learning won't be accounted for. If you flash prior, then come in to the dyno, we'll see the learned values and can do a little fine tuning for you in less time. So it depends on what your goal is...to see back to back testing or use the time to get some more hp.

[Xero-Limit]

Ok guys final call, please PM or e-mail or call to confirm that you are coming, otherwise we will have some time in the AM and an afternoon car or two.

[kykiee]

Results after tuning today. Thanks Mike!

[Simmons]

Nice Gains.


How does it feel?


Simmons

[kykiee]

Originally Posted by Simmons

Nice Gains.


How does it feel?


Simmons

Torque dip is less noticeable. Top-end feels really good. Also, I got your whiteline tops installed with rce yellow lowering springs this past weekend. lol

[Simmons]

Originally Posted by kykiee

Torque dip is less noticeable. Top-end feels really good. Also, I got your whiteline tops installed with rce yellow lowering springs this past weekend. lol

Awesome, glad to hear.


Simmons