Rocket Bunny V2 Wiring

[JaySung86]

Hey ladies and gents, I'm new to this forum so this is pretty much a gift from me to you guys. I saw a lot of you guys that are either confused about how to wire up the module to your brz, frs, or gt86 or just don't know what the fack you're looking at.. and its making you batshit crazy...

So light up a smoke, or pop a pinch of that jaw rotter or fill your glass up.. I don't know.. but here we go!!!

So pretty much the basic is this, from Greddy, when you order your rbv2 bumper ($680 when you buy directly from them), you have the option to purchase the LED DRL separately.



On this module, it comes with
Red Wire

[Positive To Battery]

Black Wire

[Negative to Battery, or chassis]

Yellow

[ACC (Use this wire to cycle on and off for a on/off switch)]

White

[Headlight (Postive)]

Gray

[Flash Blinker]

Brown

[Disregard]

Green

[Disregard]

Below here is your headlight harness, see how it splits, low beam and high beam?



Behind the gray plastic piece is where you splice, solder, crimp, shrink... just dont black tape... please... i will slap you.



You have 2 options pretty much. You can splice and solder the white wire from the module to the Positive for low/high beam. Or you can wire it to the DRL. And tadaaaaaaaaaaaaaaa... just put away the rest of the wire so its not all lose and shat... zipties... <-- and put the module somewhere safe.

heres a potato for you guys.

[LXXXV1]

OP's first post and already contributing to the community!