The Gen 2 Exhaust Thread - Page 34 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

Sara/AWE · 05-24-2022, 04:47 PM

Quote:

Originally Posted by OkieSnuffBox

Nice!

But you haven't updated your exhaust thread yet.

May have crossed paths, should be good to go now!

OkieSnuffBox · 05-24-2022, 04:49 PM

Quote:

Originally Posted by Sara/AWE

May have crossed paths, should be good to go now!

Love it!

The only decision is going to be Chrome or Diamond Black tips.

joemysterio · 05-24-2022, 08:13 PM

Well, just ordered the Touring + black tips. Time to cancel my other order.

azndavepgh · 05-24-2022, 09:17 PM

Quote:

Originally Posted by mike2100

Any annoying resonance/drone at cruise rpms?

No, you can hear the exhaust a little more at highway speeds, but the road noise is still more prominent.

mycrors7 · 06-03-2022, 02:33 AM

i got the fujitsubo AR catback pretty much the day it was released.

serial number shows 001 haha

as a tl;dr review: its what you expect. virtually drone free, great tame tone.

i have a paired with the JDL ultra quiet front pipe and its maybe a tad bit louder than before, but still very tame. cops dont even bat an eye.

cold start and some shit revs

on 2/26 i went out with a buddy to record some footage. my DSLR decided it doesnt wanna record audio for some reason. I have to figure that out and try again, but here's some iphone footage for yall.

Cold start with the JDL ultra quiet front pipe:

slimfit · 06-03-2022, 06:40 PM

Did JDL stop selling their ultra quiet front pipe? I don’t see it on their site anymore.

slimfit · 06-03-2022, 06:40 PM

Sorry double post.

mycrors7 · 06-03-2022, 07:28 PM

Quote:

Originally Posted by slimfit

Did JDL stop selling their ultra quiet front pipe? I don’t see it on their site anymore.

No clue. I found a used one for dirt cheap and jumped on it

KillerBMotorsport · 06-04-2022, 03:42 PM

Quote:

Originally Posted by mycrors7

i got the fujitsubo AR catback pretty much the day it was released.

That's a whole lot of metal being added. Did you happen to weigh the setup vs OEM?

mycrors7 · 06-04-2022, 05:43 PM

Quote:

Originally Posted by KillerBMotorsport

That's a whole lot of metal being added. Did you happen to weigh the setup vs OEM?

oem is about 41lbs
fujitsubo is about 36lbs

~5lbs of savings

definitely not an exhaust you want if youre trying to remove as much weight as possible from the vehicle.

Espi · 06-05-2022, 09:50 AM

Quote:

Originally Posted by slimfit

Did JDL stop selling their ultra quiet front pipe? I don’t see it on their site anymore.

i emailed them about it they took them down temporarily, but they will be back. I was told due to the GESI cats being out of stock. I also have my fingers crossed!

slimfit · 06-05-2022, 10:26 PM

Quote:

Originally Posted by Espi

i emailed them about it they took them down temporarily, but they will be back. I was told due to the GESI cats being out of stock. I also have my fingers crossed!

Ok, good! Hopefully they’re back in stock by the time I’m ready.

DocWalt · 06-07-2022, 04:24 PM

I swapped from the Perrin 2.5" catback to the CSG Touring 86 catback... It's effectively OEM+ inside the car and not very loud outside the car either.

I have a JDL UEL and ISR Overpipe, stock frontpipe. The drone with the Perrin catback between 2-3k RPM was getting old quickly, not sure why it's so bad on a 2nd gen with UEL. Local friend has it with an EL header and it's drone free, so YMMV.

The CSG Touring 86 is damn near silent inside the car, may as well be OEM+ with zero drone and not much noise. It's getting a little louder after ~100 miles but I doubt it will ever get loud. Outside the car, on video anyway, it's not as deep of a sound as the Perrin but it's also less raspy and more "wooshy"

The CSG installs a little easier than the Perrin because you can set the tip depth easily, but the exhaust clamps were installed "backwards" meaning the bolt was on the wrong side of the exhaust for maximum clearance on installation. Kinda dumb but whatever, easy to fix. I also wish the CSG was 304 stainless, big bummer that it's not.

Prior setup with the Perrin catback:

New setup with the CSG catback (will update when I get some miles on it like the Perrin):

Anybody want to buy a Perrin catback? haha

eyeballs · 06-08-2022, 12:03 AM

Is that UEL header catted or not? Right now with the stock header & op, jdl catted/resonated fp, and csg touring my car is no louder then stock (except cold starts). I'm hoping it'll wake up a bit once I get the EL header on, ideally loud enough to hear it with a helmet on and not have to use the fake speaker noise. I don't want to stare at a CEL though and am waiting for a tune option before putting on a header. I also want it to be civil which is why I went with the CSG knowing I'd later do the rest of the exhaust.

06-07-2022, 04:24 PM	#475
DocWalt Senior Member Join Date: Oct 2013 Drives: '22 BRZ Location: PA Posts: 1,590 Thanks: 1,868 Thanked 1,091 Times in 602 Posts Mentioned: 20 Post(s) Tagged: 2 Thread(s)	I swapped from the Perrin 2.5" catback to the CSG Touring 86 catback... It's effectively OEM+ inside the car and not very loud outside the car either. I have a JDL UEL and ISR Overpipe, stock frontpipe. The drone with the Perrin catback between 2-3k RPM was getting old quickly, not sure why it's so bad on a 2nd gen with UEL. Local friend has it with an EL header and it's drone free, so YMMV. The CSG Touring 86 is damn near silent inside the car, may as well be OEM+ with zero drone and not much noise. It's getting a little louder after ~100 miles but I doubt it will ever get loud. Outside the car, on video anyway, it's not as deep of a sound as the Perrin but it's also less raspy and more "wooshy" The CSG installs a little easier than the Perrin because you can set the tip depth easily, but the exhaust clamps were installed "backwards" meaning the bolt was on the wrong side of the exhaust for maximum clearance on installation. Kinda dumb but whatever, easy to fix. I also wish the CSG was 304 stainless, big bummer that it's not. Prior setup with the Perrin catback: New setup with the CSG catback (will update when I get some miles on it like the Perrin): Anybody want to buy a Perrin catback? haha __________________ - Ken. H DocWalt's WRB 2013 BRZ Build Thread

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FR-S and BRZ Exhaust Compilation Thread	Spd229	Engine, Exhaust, Transmission	657	12-08-2022 12:08 PM
2022+ Exhaust compilation thread	Yoshoobaroo	Engine, Exhaust, Transmission	22	04-22-2022 06:17 AM
The Boosted Exhaust Thread	The Racers Line	Forced Induction	49	06-05-2014 01:13 AM
The Exhaust Weights thread	qoncept	Engine, Exhaust, Transmission	5	06-12-2013 02:34 PM
Agency Power Exhaust Thread PT II	vividracing	Engine, Exhaust, Transmission	222	07-28-2012 12:52 AM

05-24-2022, 08:13 PM	#465
joemysterio Senior Member Join Date: Dec 2021 Drives: Mini Location: Hayward Posts: 136 Thanks: 98 Thanked 51 Times in 34 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Well, just ordered the Touring + black tips. Time to cancel my other order.

06-03-2022, 02:33 AM	#467
mycrors7 Senior Member Join Date: Jul 2014 Drives: zd8 brz Location: United States Posts: 177 Thanks: 71 Thanked 182 Times in 86 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	i got the fujitsubo AR catback pretty much the day it was released. serial number shows 001 haha as a tl;dr review: its what you expect. virtually drone free, great tame tone. i have a paired with the JDL ultra quiet front pipe and its maybe a tad bit louder than before, but still very tame. cops dont even bat an eye. cold start and some shit revs on 2/26 i went out with a buddy to record some footage. my DSLR decided it doesnt wanna record audio for some reason. I have to figure that out and try again, but here's some iphone footage for yall. Cold start with the JDL ultra quiet front pipe:

06-03-2022, 06:40 PM	#468
slimfit Member Join Date: Oct 2009 Drives: ‘22 BRZ Location: Delco, PA Posts: 73 Thanks: 126 Thanked 47 Times in 25 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Did JDL stop selling their ultra quiet front pipe? I don’t see it on their site anymore.

06-03-2022, 06:40 PM	#469
slimfit Member Join Date: Oct 2009 Drives: ‘22 BRZ Location: Delco, PA Posts: 73 Thanks: 126 Thanked 47 Times in 25 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Sorry double post.

06-08-2022, 12:03 AM	#476
eyeballs Senior Member Join Date: Dec 2021 Drives: '22 BRZ Location: West CO Posts: 127 Thanks: 16 Thanked 53 Times in 40 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Is that UEL header catted or not? Right now with the stock header & op, jdl catted/resonated fp, and csg touring my car is no louder then stock (except cold starts). I'm hoping it'll wake up a bit once I get the EL header on, ideally loud enough to hear it with a helmet on and not have to use the fake speaker noise. I don't want to stare at a CEL though and am waiting for a tune option before putting on a header. I also want it to be civil which is why I went with the CSG knowing I'd later do the rest of the exhaust.

User Name		Remember Me?
Password