|
Engine, Exhaust, Transmission Discuss the FR-S | 86 | BRZ engine, exhaust and drivetrain. |
|
Thread Tools | Search this Thread |
12-05-2016, 01:48 PM | #1 |
Junior Member
Join Date: Dec 2016
Drives: Stock White Scion FRS
Location: North Carolina
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Is a tune needed for a new exhaust?!
Hey, I'm looking at installing a Invidia n1 catback exhaust and Invidia catless frontpipe and wasn't sure if I have to tune my FR-S for it? Also if I don't need a tune, would it be recommended that I get a tune anyways? Thanks!
|
12-05-2016, 01:52 PM | #2 |
IG: @nickwiththefrs
Join Date: Sep 2015
Drives: 2016 Scion FR-S Halo
Location: Alameda, CA
Posts: 668
Thanks: 432
Thanked 305 Times in 205 Posts
Mentioned: 19 Post(s)
Tagged: 3 Thread(s)
|
You dont have to. I didnt at first but I did try doing the OFT stage 1 tune (n1 catback, catless fp and drop in filter). Felt a small difference, only did it cause I got a header and wanted to try stage 1 before I installed it.
|
12-05-2016, 02:19 PM | #3 |
Sarcastic SOB
Join Date: May 2012
Drives: '13 FR-S M6, '23 Volvo V60 CC
Location: Thornhill Ontario
Posts: 4,614
Thanks: 1,344
Thanked 2,844 Times in 1,635 Posts
Mentioned: 32 Post(s)
Tagged: 3 Thread(s)
|
No. If you install headers a tune might extract another 15 peak hp. OFT with headers cheapest way to tune without a lot of risk.
__________________
5:AD kit, HKS V1+ S/C, ECUtek dyno'd, Ohlins MP20, Magnaflow cb, Revworks UEL, Topspeed overpipe, Pinnacle Ceramic tint, VG shark fin, HID's, yellow DRL's, full LEDs, red floor lights, Homelink mirror, trunk lid liner, Perrin LWCP, Valenti smoked, Flossy Grip Tape Shorty, GT86 plaque, lighted vanity mirror, Michelin PSS, Project mU +800, DOT4 fluid, 720 Form GTF1 17x8&9, stitched leather bits, EZ valve.
|
12-05-2016, 02:41 PM | #4 | |
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 29,873
Thanks: 28,793
Thanked 31,828 Times in 16,430 Posts
Mentioned: 708 Post(s)
Tagged: 2 Thread(s)
|
Quote:
I don't think you would need a tune after those mods. And ....... I wouldn't recommend that you get a tune,...... anyways...... humfrz |
|
12-05-2016, 03:05 PM | #5 |
Senior Member
Join Date: Jun 2016
Drives: 13 frs red
Location: Lantana fl
Posts: 448
Thanks: 51
Thanked 198 Times in 115 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
|
12-05-2016, 03:34 PM | #6 |
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 29,873
Thanks: 28,793
Thanked 31,828 Times in 16,430 Posts
Mentioned: 708 Post(s)
Tagged: 2 Thread(s)
|
Well, no ...... I just believe that when messing with the exhaust, shy of replacing the header with an aftermarket header, that a tune isn't necessary for averaging driving. In addition, it's a great way to mess with warranty work.
Oh, my use of the word "anyways" was in reference to the OP's use of the word "anyways" ...... as I took to mean ...... just for the heck of it. humfrz - jest ain't no fun ...... |
12-05-2016, 04:46 PM | #7 | |
Senior Member
Join Date: Jun 2016
Drives: 13 frs red
Location: Lantana fl
Posts: 448
Thanks: 51
Thanked 198 Times in 115 Posts
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
|
Quote:
|
|
12-05-2016, 05:21 PM | #8 |
Senior Member
Join Date: Mar 2015
Drives: 2015 Subaru BRZ Limited CWP
Location: SoCal
Posts: 1,561
Thanks: 34
Thanked 669 Times in 469 Posts
Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
|
there's no need to get a tune for just replacing the front pipe and cat back, however, I would recommend buying an OFT (you can find a used one for around $400) and doing a "stage 1" tune for better drive-ability. you probably won't have much of a horsepower increase from the tune, but the car will run better. once you decide you want an aftermarket header (which you probably will later on) then you can get the "stage 2" tune from OFT without spending extra cash and that tune will actually add some extra HP. in regards to warranty work, you can always flash the car back to stock with the OFT as well.
__________________
|
12-05-2016, 06:09 PM | #9 | |
Senior Member
Join Date: May 2013
Drives: 2013 FR-S, white, MT
Location: Puyallup, WA
Posts: 29,873
Thanks: 28,793
Thanked 31,828 Times in 16,430 Posts
Mentioned: 708 Post(s)
Tagged: 2 Thread(s)
|
Quote:
I was replacing the spark plug wires on my old Chevrolet and didn't pay attention to which wire went to which hole in the distributor cap. Then I had a misconception about the firing order. Talk about ..... backfire! ....... humfrz |
|
12-05-2016, 07:31 PM | #10 | |
Mr.Fujitsubo
Join Date: Sep 2014
Drives: 2018 STI
Location: Woodbridge
Posts: 1,719
Thanks: 4,055
Thanked 1,552 Times in 784 Posts
Mentioned: 31 Post(s)
Tagged: 1 Thread(s)
|
Quote:
Read my review for more information on the OFT. http://www.ft86club.com/forums/showt...23#post2771023
__________________
2018 Subaru WRX STI ~ The Weekend Car ~
2015 Toyota 86 ~ The Sold Car ~ Build Journal OFT Stage 1 Tune Review |
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Unichip tune software needed | almeshtaq | Software Tuning | 0 | 06-24-2016 01:58 AM |
OFT300 (Vortech/OFT) help needed (tune issue) | sirsol66 | Software Tuning | 7 | 12-09-2015 12:17 PM |
high octane fuel + FI, tune not needed? | BRZPDX | Forced Induction | 6 | 09-30-2014 12:41 AM |
If just want to add front pipe and overpipe, tune needed to avoid cel? | OICU812 | Engine, Exhaust, Transmission | 3 | 07-26-2013 09:43 AM |
Exhaust help needed | Jordan6908 | Engine, Exhaust, Transmission | 1 | 06-26-2012 11:41 AM |